Teledyne A2C2115 10 to 2000 mhz sma cascaded amplifier Datasheet

PRELIMINARY
A2C2115
10 TO 2000 MHz
SMA CASCADED AMPLIFIER
A2C2115
Typical Values
High Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low Noise Figure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Medium Output Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Reverse Isolation . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Performance Thin Film
Two-stage SMA Package
A2C2115
28.0 dB
3.0 dB
+15.0 dBm
49 dB
T0-8 Amplifier SMA Case
(two-stage)
˜
PRODUCT LABEL AREA
SPECIFICATIONS*
1.330
(33.78)
0.375
(9.52)
Parameter
Typical
Frequency (Min.)
5-2100 MHz
Small Signal Gain (Min.)
28.0 dB
DC BIAS
Guaranteed
0 to 50 °C
-55 to +85 °C
10-2000 MHz
10-2000 MHz
26.5 dB
25.0 dB
0.500
(12.70)
GND
MOUNTING SURFACE
0.460
(11.68)
0.100
(2.54)
Gain Flatness (Max.)
±0.5 dB
±0.8 dB
±1.0 dB
Noise Figure (Max.)
3.0 dB
3.5 dB
4.0 dB
1.7:1
1.9:1
2.0:1
SWR (Max.)
Input/Output
Power Output (Min.)
@ 1dB comp.
+15.0 dBm
+14.0 dBm
+14.0 dBm
Reverse Isolation
49 dB
—
—
DC Current (Max.)
120 mA
125 mA
130 mA
MOUNTING HOLE
2-56 UNC-2B x 0.15 DEEP
THREADED INSERT
(4) PLCS
1.000
(25.40)
0.290
(7.37)
RF CONNECTOR
SMA JACK (FEMALE)
(2) PLCS
0.750
(19.05)
* Measured in a 50-ohm system at +15 Vdc unless otherwise specified.
INTERMODULATION PERFORMANCE
A2C2115
Typical @ 25 °C
Second Order Harmonic Intercept Point. . . . . . . . . . . . . . .
Second Order Two Tone Intercept Point . . . . . . . . . . . . . . .
Third Order Two Tone Intercept Point . . . . . . . . . . . . . . . . .
+46 dBm
+40 dBm
+27 dBm
ABSOLUTE MAXIMUM RATINGS
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -62 to +125 °C
Maximum Case Temperature . . . . . . . . . . . . . . . . . . . . . . . .
+125 °C
Maximum DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+18 Volts
Maximum Continuous RF Input Power . . . . . . . . . . . . . . . .
+10 dBm
Maximum Short Term Input Power (1 Minute Max.) . . . . . . .
50 Milliwatts
Maximum Peak Power (3 µsec Max.) . . . . . . . . . . . . . . . . . .
0.5 Watt
Burn-in Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+125 °C
Thermal Resistance1 (θjc) . . . . . . . . . . . . . . . . . . . . . . . . . .
+26 °C/Watt
Junction Temperature Rise Above Case (Tjc) . . . . . . . . . . .
+26.8 °C
1
0.310
(7.87)
Thermal resistance is based on total power dissipation.
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected]
Similar pages