3.5x2.8 mm SMD CHIP LED LAMP AA3528SURCK HYPER RED Description Features SINGLE COLOR. The Hyper Red source color devices are made with DH SUITABLE FOR ALL SMT ASSEMBLY AND SOLDER InGaAlP on GaAs substrate Light Emitting Diode. PROCESS. AVAILABLE ON TAPE AND REEL. IDEAL FOR BACKLIGHTING. PACKAGE : 1500PCS / REEL. RoHS COMPLIANT. Package Dimensions N ot es : 1. A l l di m ens i ons are i n m i l l i m et ers (i nc hes ). 2. T ol eranc e i s ±0. 25 (0. 0 1" ) unl es s ot her wi s e not e d. 3. S pec i f i c at i ons a re s ubj e c t t o c hange wi t hout n ot i c e. SPEC NO: DSAA6808 REV NO: V.6 DATE: MAR/21/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1201000394 Selection Guide Part No. Dice AA3528SURCK Iv (mcd) @ 20mA Lens Type HYPER RED (InGaAlP) Viewing Angle Min. Typ. 2θ θ1/2 70 200 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 650 nm IF=20mA Hyper Red 635 nm IF=20mA Spectral Line Half-width Hyper Red 28 nm IF=20mA C Capacitance Hyper Red 35 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.95 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage Operating / storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA6808 REV NO: V.6 DATE: MAR/21/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1201000394 Hyper Red AA3528SURCK SPEC NO: DSAA6808 REV NO: V.6 DATE: MAR/21/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1201000394 AA3528SURCK Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage,luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAA6808 REV NO: V.6 DATE: MAR/21/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1201000394