Mean Well LPC-150-500 150w single output led power supply Datasheet

LPC-150
150W Single Output LED Power Supply
series
■ Features :
Constant current design
180~305VAC input only
High efficiency up to 90%
Protections: Short circuit / Over voltage / Over temperature
Cooling by free air convection
Fully encapsulated with IP67 level (Note.6)
Fully isolated plastic case
ClassⅡ power unit, no FG
Suitable for LED lighting and moving sign application (Note.7)
100% full load burn-in test
Low cost, high reliability
2 years warranty (Note.4)
IP67
SPECIFICATION
LPC-150-350 LPC-150-500 LPC-150-700 LPC-150-1050 LPC-150-1400 LPC-150-1750 LPC-150-2100 LPC-150-2450 LPC-150-2800 LPC-150-3150
MODEL
RATED CURRENT
350mA
CURRENT ACCURACY
±5.0%
500mA
700mA
1050mA
CONSTANT CURRENT REGION Note.5 215 ~ 430V 150 ~ 300V 107V ~ 215V 72V ~ 144V
150W
151.2W
150.5W
150.5W
RATED POWER
OUTPUT
RIPPLE CURRENT
±5%
RIPPLE & NOISE
2Vp-p
VOLTAGE TOLERANCE
LINE REGULATION
±2.0%
±1%
SETUP, RISE TIME
1000ms, 80ms / 230VAC at full load
Note.2 180 ~ 305VAC
FREQUENCY RANGE
INPUT
90%
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
1.7 A / 230VAC
43V ~ 86V
150.5W
36V ~ 72V 31V ~ 62V
151.9W
151.2W
27V ~ 54V 24V ~ 48V
151.2W
151.2W
1Vp-p
1Vp-p
1Vp-p
1Vp-p
1Vp-p
1Vp-p
2450mA
69 ~ 80V
63 ~ 75V
55 ~ 65V
1.5A / 277VAC
3 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC
440 ~ 470V 330 ~ 365V 235 ~ 265V 158 ~ 188V 115 ~ 135V 96 ~ 115V 80 ~ 97V
Protection type : Shut down and latch off o/p voltage re-power on to recovery
OVER TEMPERATURE
Shut down o/p voltage, recovers automatically after temperature goes down
WORKING TEMP.
-25 ~ +50℃ (Refer to "Derating Curve")
10 ~ 95% RH non-condensing
-40 ~ +70℃, 10 ~ 95% RH
±0.03%/℃ (0 ~ 50℃)
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
IP67 approved; refer to EN60950-1
WITHSTAND VOLTAGE
I/P-O/P:3KVAC
ISOLATION RESISTANCE
I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
Compliance to EN55022(CISPR22) Class B; EN61000-3-2 Class A(≤80% load); EN61000-3-3
EMC IMMUNITY
MTBF
DIMENSION
PACKING
3150mA
COLD START 40A(twidth=750μs measured at 50% Ipeak) at 230VAC
<0.25mA / 277VAC
EMC EMISSION
2800mA
254VDC ~ 431VDC
Hiccup mode, recovers automatically after fault condition is removed
VIBRATION
NOTE
151.2W
LEAKAGE CURRENT
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
OTHERS
54V ~ 108V
SHORT CIRCUIT
PROTECTION OVER VOLTAGE
EMC
2100mA
47 ~ 63Hz
EFFICIENCY (Typ.)
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
SAFETY &
1Vp-p
1750mA
16ms/230VAC at full load
HOLD UP TIME (Typ.)
VOLTAGE RANGE
1Vp-p
1.5Vp-p
1400mA
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level , criteria A
479K hrs min. MIL-HDBK-217F (25℃)
191*63*37.5mm (L*W*H)
0.74Kg; 20pcs/15.8Kg/0.95CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
2. Derating may be needed under low input voltages. Please check the static characteristics for more details.
3. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
4. Refer to warranty statement.
5. Constant current operation region is within 50% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please
reconfirm special electrical requirements for some specific system design.
6. Suitable for indoor use or outdoor use without direct sunlight exposure, please avoid immerse in the water over 30minutes.
7. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
File Name:LPC-150-SPEC 2015-05-28
LPC-150
150W Single Output LED Power Supply
Mechanical Specification
Case No. LPC-150
300±20
series
Unit:mm
300±20
191
5
25
25
SJTW 18AWG
T case
26
ψ
5
+V(Red)
-V(Black)
86
4.
5
63
5
SJTW 18AWG
AC/N(Blue)
AC/L(Brown)
5
37.5
※ T case: Max. Case Temperature.
Recommend Mounting Direction
Block Diagram
PWM fosc : 67KHz
65KHz
EMI FILTER
&
RECTIFIERS
I/P
RECTIFIERS
&
FILTER
POWER
SWITCHING
O.L.P.
+V
-V
DETECTION
CIRCUIT
PWM
CONTROL
O.V.P.
Derating Curve
Static Characteristics
100
100
90
80
80
70
LOAD (%)
LOAD (%)
60
40
20
-25
-15
0
15
30
40
50
AMBIENT TEMPERATURE (℃)
60
70 (HORIZONTAL)
60
50
40
180
190
200
210
220
230 240
250
260
270
280
305
INPUT VOLTAGE (V) 60Hz
File Name:LPC-150-SPEC 2015-05-28
Similar pages