THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 5.0V HCMOS OCVCXO ABSOLUTE M AXIMUM RATING S PARAMETER Storage Temperature TABLE 1.0 UNITS MINIMUM -40 NOMINAL - MAXIMUM 85 UNITS °C (Vcc) -0.5 - 7.0 Vdc NOMINAL (Fo) MAXIMUM 20.00 UNITS Center Frequency Frequency Calibration Frequency vs. Change in Temperature Frequency vs. Change in Supply Voltage Frequency vs. Change in Load Frequency Aging Daily Frequency Aging per year Total Frequency Tolerance Operating Temperature Range MINIMUM 9.00 Supply Voltage Supply Current Supply Current Steady State @25°C Supply Voltage OPERATING SPECIFIC ATIONS TABLE 2.0 PARAMETER -1.0 -0.25 -0.05 -0.02 -0.7 -4.6 -20 - 1.0 0.25 0.05 0.02 20 0.7 4.6 70 MHz ppm ppm ppm ppm ppb/day ppm ppm °C (Vcc) 4.75 (Icc) - 5.00 5.25 Vdc - 350 (Icc) mA - 180 - mA Allan Variance (1 second) - 5.00E-10 - Jitter (10Hz to 10 MHz) SSB Phase Noise at 1Hz offset SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - -60 -90 -120 -140 -150 - 1 5 1 2 ps RMS dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz Minutes nS nS MINIMUM NOMINAL MAXIMUM UNITS 0.5 5 2.5 100k 2.5 -7 7 - 4.5 -5 - Vdc ppm ppm ppm/V Ohm MINIMUM 12 4.75 - NOMINAL 15 - MAXIMUM 18 0.4 UNITS pf Vdc Vdc -4 45 - 50 - 4 55 6 mA mA % nS INTPUT CHARACTERISTICS PARAMETER Control Voltage Range Frequency at Vc=0.5 Vdc Frequency at Vc=4.5 Vdc Slope of Frequency Adjust Input Impedance (Vc) HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% (Ioh) (Ioh) 1 2 3 4 OVA5GA3AB DESCRIPTION The Connor Winfield OVA5GA3AB is a hermetically sealed 14 Pin DIP, 5.0V Oven Controlled Voltage Controlled Crystal Oscillator (OCVCXO) with a HCMOS / TTL compatible output. The OVA5GA3AB is designed for higher stability applications requiring low jitter and tight calibration. 5 FEATURES 6 5.0V OPERATION HCMOS OUTPUT TABLE 3.0 NOTE LOW JITTER <1PS RMS FREQUENCY STABILITY: +/-0.25PPM 7 7 TEMPERATURE RANGE: -20 TO 70°C NOTE OVERALL FREQUENCY TOLERANCE: +/-4.6 PPM OVER TWENTY YEARS. 14 PIN DIL PACKAGE 8 8 ORDERING INFORMATION OVA5GA3AB TABLE 5.0 PACKAG E CHARACTERISTICS Package NOTE TABLE 4.0 (Voh) (Vol) CW 0512 OVA5GA3AB 10.00M NOTE 14 pin DIP, hermetically sealed, grounded case, welded package OCXO SERIES - 10.00MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx082 PAGE 1 OF 2 REV: 01 DATE: 04/06/05 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS Notes: 1) 2) 3) 4) 5) Initial calibration @ 25°C, Vc = 2.50V at time of shipm ent. Frequency vs. temperature stability, -20 to 70°C, referenced to 25°C. Frequency stability per 5% change in supply voltage. Frequency stability per 5% change in load Inclusive of calibration, operating tem perature range, supply voltage chang e, load change, shock and vibration and ag ing over 20 years. 6) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.5ppm of nominal. 7) Referenced to Fo @ 25°C, Positive Transfer Characteristic. 8) Supply voltage at 5.00 Vdc. ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260°C ±5°C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. 0.330 MAX (8.38mm) CONTROL VOLTAGE 4.5 20K POT Specifications subject to change without notice. DATA SHEET #: Cx082 PAGE 2 OF 2 REV: 01 DATE: 04/06/05 aCopyright 2001 Connor-Winfield all rights reserved.