MPD MPA400MDX-0524Z 400w ac-dc active pfc medical power supply Datasheet

MicroPower Direct
Go Direct - MicroPower Direct - For Product, Performance and Price
400W AC-DC ACTIVE PFC MEDICAL POWER SUPPLY
MPA400MD DUAL OUTPUT SERIES
FEATURES:
•
•
•
•
•
•
Medical Safety Approvals
Power Factor Corrected to EN61000-3-2 class D
1U height size
U-Chassis & Enclosed with built-in fan Mechanical Options
High power density: 6.25 watts/cu inches
Current Monitoring and Remote Voltage adjustment (Margin)
U - Chassis Type: 8 x 5 x 1.6”
Enclosed with built-in fan Type: 9 x 5 x 1.6”
CB
PRODUCT SPECIFICATIONS:
Input Voltage: 90-264 Vac full range, 47~63 Hz.
Input Current: 6.35A at 90 Vac full load.
Inrush Current: 35A Max @ 230 Vac with full load and cold start.
PFC: Active power factor correction meet EN61000-3-2 class D.
Fan Drive: 12 VDC/400 mA is available to drive an external fan.
Transient Response: Returns to within 1% in less than 2.5 mS for
a 50% load change and the peak transient does not excess 5%.
Overshoot: Turn-on/off not exceed 5% over nominal voltage.
Efficiency: 75% minimum (Measuring at 230V and full load).
Turn On Delay: 1 second maximum at 120 Vac.
Hold Up Time: 20 mS min. at 80% of full load.
Adjustability: Output user adjustable ±5% minimum.
Remote Sense: Designated “RS+” and “RS-” on the CN3.
Remote On-Off: Designated as “RSW” on the CN3, requires a low
signal to inhibit output.
Power Supply On: Green LED designated as “LED 1” on the PCB.
LED display: Bi-color “LED1” emit green light on operating. Any
protection occurred or RSW applied low signal will emit orange.
Power Good: Designated as “PG” on the CN3 will go high 100500mS after regulation and goes low 1mS before loss of regulation.
Input Circuit (primary): Two protected fuse inserted, shall be
blown only by an internal power fault.
Input Voltage Protection: Power shut down under 80 ±5 Vac,
and recovered over 86 Vac.
Over-Power Protection: C.C. mode 110-140% and auto-recovery.
Over-Voltage Protection: Latching down will occur when output
voltage exceed 130% and recycle AC input to reset.
Over Temp. Protection: Protected at ambient 85°C; Auto-recovery.
Short Circuit Protection: Trip without damage and auto-recovery.
Switching Frequency: 30 kHz fixed frequency.
Operating Temperature: O°C to 70°C ambient, de-rating at 2.5%
per degree from +50°C to +70°C
Storage Temperature: -20 to 85°C.
Operating Humidity: 5% to 90% RH, Non-condensing.
Storage Humidity: 5% to 95% RH, Non-condensing.
Vibration: Frequency 5 to 50 Hz, acceleration ±7.35 M/(SxS) on
X,Y and Z Axis.
Emissions: FCC Part 15, CISPR 22 class B, Conducted.
Safety Regulation: Approved to UL60950-1/ 60601-1, CSA
C22.2 No. 60950-1-03/ 601.1-M90, TUV EN60950-1/ 60601-1, CE
Mark (LVD) EN61204-3/ 60601-1-2/ 61000-3-2,3 & IEC61000-4
Series Regulations and CB.
Leakage Current: 300 uA
HI-POT Test: 1500 Vac between input line and chassis (2 mA DC
cut off current); 4000 Vac between primary and secondary
windings; Primary to core 1500 Vac. All for 3 sec.
Grounding Test: Apply 40 A from ground pin to the earthed
connection point. Maximum allowable resistance is 0.1ohm.
Warranty: 2 years.
MTBF: 100000 Hrs (according to MIL-HBK-217F) at 30? .
Cooling: Enclosed Type: Self cooled by internal ball bearing fan.
U-Chassis Type: Full rating under 22.95 CFM forced air flow.
Burn in: 45 +/- 5 degree C for 1 hour @230Vac with full load.
Enclosure: U-Chassis type - 8(L) x 5(W) x 1.6(H) inches.
Enclosed type - 9(L) x 5(W) x 1.6(H) inches.
Weight: U-Chassis Type – 1.3KG; Enclosed Type – 1.6KG;
MicroPower Direct
www.micropowerdirect.com
292 Page Street, Ste D Stoughton, MA 02072 • TEL: (781) 344-8226 • FAX: (781) 344-8481 • EMAIL: [email protected]
OUTPUT VOLTAGE / CURRENT RATING CHART: Measured at output power connector.
Model Number
Max. Output current
Output Voltage
MPA400MDx-0312z
MPA400MDx-0324z
MPA400MDx-0512z
MPA400MDx-0524z
MPA400MDx-1224z
Total Regulation
Ripple & Noise
40A
± 5%
± 1%
Convection
22.95 CFM
V1: +3.3V
30A
V2: +12V
16.7A
25A
± 5%
± 1%
V1: +3.3V
30A
40A
± 5%
± 1%
V2: +24V
8.34A
12.5A
± 5%
± 1%
30A
40A
± 5%
± 1%
16.7A
25A
± 5%
± 1%
30A
40A
± 5%
± 1%
V1: +5V
V2: +12V
V1: +5V
V2: +24V
8.34A
12.5A
± 5%
± 1%
V1: +12V
16.7A
25A
± 5%
± 1%
V2: +24V
8.33A
12.5A
± 5%
± 1%
* MPA400MDx-00z: x = E (Enclosed type) or U(U-Chassis type); z = Blank (terminal strips), M (Molex Connectors) or I (IEC Input Connector, Enclosed unit only).
* 10% minimum load is required for all outputs to maintain the ripple and regulation. Output is fully isolated.
* Total combined power of V1 and V2:
400W Max. with 22.95 CFM forced air and 250W convection cooling for the MPA400MDU-1224 and 400W for the MPA400MDE-1224
. by self cooling.
300W Max. with 22.95 CFM forced air and 200W convection cooling for all other MPA400MDU models and 300W for all other MPA400MDE models by self cooling.
OUTLINE DRAWING:
Overall Size for U-Chassis Type: 8(L) x 5(W) x 1.6(H)inches; Weight: Maximum weight is 1.3kg; Option: Top Cover.
I/O Connector pin assignment:
B: MOUNTING HOLE 8 PLACE
6-32 UNC(Zn-plated)
SCALE 4:1
C
C
B
B
B
B
C
C
FAN
CN3
V2
B
CN1
V2
RTN
RTN
V1
V1
CN2
L
N
C
B
C
B
B
B
C
C
Input Connector(CN1):
U-Chassis Type – mating Molex Part No. 09-910700 equivalent(7 pin, 5 used), or Howder
Terminal block Part No. HD-121-3P.
Enclosed type – IEC320 or equivalent Snap-in
mounting type or DINKLE Terminal block Part No.
DT-35-A02W-03 (3 pin)
C:MOUNTING HOLE 8 PLACE
M4X0.7 UNC
SCALE 4:1
Output Connector (CN2): Mating Molex 16 pins
(09-91-1600), or Howder (HD-121-6P) M3.5, 8
pins terminal block, 9.5MM Center.
Output Pin Assignment: (See table below)
Overall Size for Enclosed Type: 9(L) x 5(W) x 1.6(H)inches; Weight: Maximum weight is 1.6kg
C
B
C
B
C
C
L N
B
C
Fan driver connector (FAN): 12 VDC / 400 mA
is available to drive an external fan. Mating connector
is a JST XHP-2 or Molex P/N 48-151-0210 ( 2 pins
0.98 pitch). Mating Pins: JST SXH-001T-P0.62T
or Molex 48150 .
B
B
C
C
B
B
Mounting Inserts: 6-32, M4 4 Places individually
with maximum penetration 0.15” on bottom side
and 0.25” on both side.
V2
V2
RTN
RTN
V1
V1
B
C
Logic signal connectors (CN3):
Mating JST XHP-8 or equivalent (CHYAO
SHIUNN JS-2001-08) Mating Pins: JST SXH002T-P0.6 for AWG 30 to 26.
V1
V2
RTN
MOLEX
PINS 1-6
PINS 14-16
PINS 7-13
HOWDER
PINS 1-2
PINS 6
PINS 3-5
MOUNTING HOLE:
B: 6-32 UNC(Zn-p late d) 8 PLACE
C: M4X0.7 UNC 8 PLACE
MicroPower Direct
www.micropowerdirect.com
292 Page Street, Ste D Stoughton, MA 02072 • TEL: (781) 344-8226 • FAX: (781) 344-8481 • EMAIL: [email protected]
Similar pages