HCR8065M3PBL-001 HCR8065M3PWL-001 806-960MHz &1710-2200MHz HCR-M-3 ASSEMBLY AND INSTALLATION INSTRUCTIONS SPECIFICATIONS Model Number Frequency Gain (Typical) Gain (Max) VSWR Max Input Power Radiation Pattern HCR8065M3PBL-001 HCR8065M3PWL-001 806-960MHz 1710-2200MHz 2.1dBi 2.2dBi 2.6dBi 3.2dBi < 2:1 10W Omnidirectional Polarization Vertical Product Label With Laird Logo Yes Nominal Impedance 50 Ohm Antenna Dimension 83.8(H)X36.5(Dia.)mm (Excludes Gasket Height) Weight Antenna Color 192.5g Black/White Wind Survival 282 km/h Mounting Please read all instructions carefully before attempting to install and use this product. P-Mount Operating Temperature -30ºC +70ºC Storage Temperature -40ºC +85ºC Ingression Protection IP67 RoHS Compliance YES SAFETY The HCR8065M3PBL-001, HCR8065M3PBL-001, and all associated equipment should be installed in accordance with applicable local and national electrical code guidelines to ensure safe operation. MOUNTING 1. 2. 3. 4. Antenna perspective view mounting Warranty and Liability Laird warrants to the original purchaser that antenna products will remain free from defects in materials and workmanship for period of (5) years from the purchase date. If any such defect is discovered within the warranty period, Laird will at its sole option, repair or replace the Product free of charge upon its return to the factory. This warranty applies only if the Product is used in a normal fashion, and is void if the Product is abused, disassembled, tampered with, used unreasonably, or fails as a result of normal wear. Furthermore, this warranty applies only to defects, which occur where the proper Product is selected as recommended by Laird and is used in the fashion recommended by Laird for the defective Product. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, AND IS LIMITED TO A PERIOD OF (5) YEARS FROM THE DATE OF ORIGINAL PURCHASE. LAIRD IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND. ANY WARRANTY EXTENDED HEREIN SHALL BE LIMITED TO THE PRICE PAID TO LAIRD FOR THE DEFECTIVE PRODUCT. WHERE STATE OR LOCAL LAW GOVERNS THE PERIOD OF WARRANTY, SUCH PERIOD SHALL CONTROL. Americas: +1.847 839.6907 [email protected] 5. 6. 7. 8. Check your antenna to be certain the antenna resonant frequency range and your radio are compatible. Plan the mounting location on the ground plane. Be certain to choose a flat area on the vehicle with a metal thickness of 0.20” to 0.40” Drill a 5/8” diameter hole and remove a 0.020” diameter ring of paint from the around the hole to enable a firm ground connection. Insert the antenna threaded shaft through the hole in the metal surface. Insert the lock washer and thread the locking nut onto the antenna shaft and be certain that the o-ring is in the groove of antenna bush before tightening. Tighten to 5-6 Nm of torque. A light application of silicone grease to the o-ring will prevent the o-ring from binding. When finished, inspect for a proper bottom O-ring seal. This will prevent water leaking into the mount and perhaps into the machine/vehicle. PRECAUTION The antenna should be mounted on the desired location before FUNCTIONING. This is to ensure that not damage antenna during the mounting of the antenna. Europe: +44.1628.858941 [email protected] Asia; +1.65.6.243.8022 [email protected] www.lairdtech.com IAS_165-00146-004_AA_081914