Part No: G5Z-003 – G5 Series Tilt Switch - Mercury Features: * Insulated * Form: NO/NC/SPST/Mount dependent * Angles Referenced from Horizontal * Hermetically Sealed * Small Package Size * Narrow Included Angle * High Current Capability * Low Contact Resistance * Long Life Drawing dimensions in inches. Tilt switches “make” when the electrode is tilted below horizontal and “break” when tilted above the horizontal. Total travel from “make” to “break” is the “Maximum included angle” shown below. The component to which the switch is attached must have a total tilt angle greater than the “Maximum included angle” for proper operation. Maximum included Angle* : 11º * Switching occurs when body axis is near horizontal Switch Ratings: Max Switching Voltage Max Switching Current 240V Initial Contact Resistance (Max). Stand Off Voltage (contact to contact) (contact to ground) Operating Temperature Storage Temperature Typical number of operations at specified load G-Force Activation G-Level/Range Dimensions: Weight per 100pcs. Lbs / Kgs: Body Length (less leads). Inches / Millimeters: Maximum Diameter. Inches / Millimeters: Materials: Lead Wire Type Lead wire length/skive/termination 3 milli Ohms 1500V 5000V -38º to 220ºF / -38º to 105ºC -40º to 356ºF / -40º to 180º C 10,000,000 N/A Finish: Cotton Insulated © American Electronic Components Inc 2006 Specifications are subject to change without notice. E&OE. 120VAC / 7A, 240VAC / 5A : 120VDC / 5A, 240VDC / 4A : Tungsten 240V / 700W: 0.33HP / 480VAC, 0.25HP / 240 VDC 4.45 / 2.02 1.81 / 46.0 0.52 / 13.7 #20AWG Silicone Insulated 6 in / Ring Terminal with 0.17 dia. hole American Electronic Components Inc., 1101 Lafayette Street, Elkhart, Indiana. USA Tel: +1-574-295-6330 Fax: +1-574-293-8013 Email: [email protected] http://www.aecsensors.com G5Z-001 200606