Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter FEATURES: Models Single output • AC-DC Constant Current or Constant Voltage LED Driver • Input range 90-305VAC/47-440Hz • High efficiency up to 86% • Operating temperature -40 to 85°C • Dimmable via analog / 0-10V dimming ② Model Output Voltage Range ③ (V) Output Current ③ (A) Input Voltage (VAC/Hz) Input Voltage (VDC) AMEPR30-5070AZ 36-50 0-0.77 90-305/47-440 120-430 AMEPR30-4864AZ 36-48 0-0.66 90-305/47-440 120-430 AMEPR30-36100AZ 24-36 0-1.04 90-305/47-440 120-430 AMEPR30-24140AZ 12-24 0-1.45 90-305/47-440 120-430 AMEPR30-12250AZ 5-12 0-2.55 90-305/47-440 120-430 • • • • • Over temperature protection Over current protection Waterproof case rated IP68 Power Factor Correction Short circuit protection Mode of Operation Constant Current Constant Voltage ② Constant Current Constant Voltage ② Constant Current Constant Voltage ② Constant Current Constant Voltage ② Constant Current Constant Voltage ② Exceeding the maximum output power will permanently damage the converter ② The dimming feature is not supported when units are used in Constant Voltage mode only. Max Output Power (W) ① Efficiency (%) 35 38.5 30.7 31.7 36 37.4 33.6 34.8 30 30.6 86 85 86 84 85 84 84 84 83 83 ① ③ In constant current mode output current is maximum shown, in constant voltage mode output voltage is the maximum shown. NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. Input Specifications Parameters Inrush current <2ms Leakage current AC current Power Factor External fuse Start up time Output Specifications Parameters Conditions 115VAC 230VAC 115VAC 230VAC 115VAC 230VAC 115VAC 230VAC Typical 25 40 0.3 0.5 0.43 0.25 450 Conditions Typical Current accuracy ±2 Line regulation LL-HL ±1 Load regulation 0-100% load ±2 20MHz Bandwidth 75 Ripple & Noise ④ Hold-up time 50 Current adjustment range 100-0 Minimum Load Voltage See the models table ④ Tested with 0.1µF (C/C) or (M/C) and 47µF (E/C) parallel capacitors at the end. www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 1 of 14 Maximum Units A mA A 0.96 0.90 250V/1A Maximum ms Units % % % mV p-p ms % Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ Isolation Specifications Parameters Tested I/O voltage Isolation Resistance Isolation Capacitance up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Conditions Typical 3sec 500VDC General Specifications Parameters Switching frequency Over current protection Over voltage protection Short circuit protection Short circuit restart Over temperature protection Operating temperature Maximum case temperature Storage temperature Temperature coefficient Cooling Humidity Case material Potting Wires Weight Dimensions MTBF >1000 1000 Conditions Rated Units 3000 VAC MΩ pF Typical Maximum 130 95-110% of Iout 110% of Vout Continuous Auto recovery >105°C -40 to +85 With derating over 55°C Units KHz o 100 -40 to +95 ±0.02 Free air convection Plastic Epoxy (IP67 rated) UL1015 18AWG * 20CM 350 5.30 x 2.27 x 1.59 inches 134.80 x 57.68 x 40.50 mm >400,000 hrs (MIL-HDBK-217F at +25°C) 95 C C o C % / oC o % RH g Safety Specifications Parameters Agency approvals Standards www.aimtec.com F 052.1e R3.S cULus, CE UL8750, UL60950-1, EN55022, class B, EN60529(IP68), EN61347-1, EN61347-2-13 Information Technology Equipment EN55022 Class B Harmonic Current Emissions IEC/EN 61000-3-2, Class C Voltage fluctuations and flicker IEC/EN 61000-3-3, (EN60555-3) Electrostatic Discharge Immunity IEC 61000-4-2 RF, Electromagnetic Field Immunity IEC 61000-4-3 Electrical Fast Transient / Burst Immunity IEC 61000-4-4 Surge Immunity IEC 61000-4-5 RF, Conducted Disturbance Immunity IEC 61000-4-6 Power frequency Magnetic Field Immunity IEC 61000-4-8 Voltage dips, Short Interruptions Immunity IEC 61000-4-11 Tel: +1 514 620 2722 2 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Dimensions End View 40.50 (1.59) Top View 16.75 (0.66) 137.33 (5.41) 60.00 (2.36) 32.00 60.00 (1.26) (2.36) Side View 40.50 (1.59) 200.00 (8.00) 200.00 (8.00) Input/Output Wires are 18 AWG 20cm 2.30 (0.09) 161.30 (6.35) NOTE: to adjust the output current connect a 20K Ohm pot between blue and white wire www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 3 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Analog (Resistive) Dimming Application Circuit AC BROWN L GREEN +Vout 1 AMEPR30-AZ 1st LED -Vout N BLUE RED 1 BLUE BLACK Model Number AMEPR30-5070AZ AMEPR30-4864AZ AMEPR30-36100AZ AMEPR30-24140AZ AMEPR30-12250AZ Maximum Pot Value (kΩ) 9.00 9.00 9.00 26.00 26.10 Pot WHITE 0-10V Dimming Application Circuit U1 +Vs (Blue) 0-10Vdc Pin 1 -Vs (White) Pin 2 R28 1K5, 0805 LTV-817C GND Derating Free Air Convection 55 º C 100 80 Safe Operating Area 60 40 20 0 -40 -20 0 20 40 60 80 85 100 Ambient Temperature º C www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 4 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Efficiency Vs. Input Voltage & Output Current (Constant Current Mode) AMEPR30-5070AZ AMEPR30-4864AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 5 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Efficiency Vs. Input Voltage & Output Current (Constant Current Mode) Continued AMEPR30-36100AZ AMEPR30-24140AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 6 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Efficiency Vs. Input Voltage & Output Current (Constant Current Mode) Continued AMEPR30-12250AZ PFC Value vs. Output Load Current (Constant Current Mode) AMEPR30-5070AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 7 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter PFC Value vs. Output Load Current (Constant Current Mode) Continued AMEPR30-4864AZ AMEPR30-36100AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 8 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter PFC Value vs. Output Load Current (constant current mode) Continued AMEPR30-24140AZ AMEPR30-12250AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 9 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Constant Current vs. Constant Voltage Mode AMEPR30-5070AZ AMEPR30-4864AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 10 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Constant Current vs. Constant Voltage Mode (continued) AMEPR30-36100AZ AMEPR30-24140AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 11 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Constant Current vs. Constant Voltage Mode (continued) AMEPR30-12250AZ Dimming Control (Output Current vs. Radj) AMEPR30-5070AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 12 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Dimming Control (Output Current vs. Radj) continued AMEPR30-4864AZ AMEPR30-36100AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 13 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30-AZ up to 2.5A | AC-DC / DC-DC | LED Driver / Converter Dimming Control (Output Current vs. Radj) continued AMEPR30-24140AZ AMEPR30-12250AZ NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 14 of 14 Toll free: + 1 888 9 AIMTEC (924 6832) North America only