AM-182 / AMC-182 Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz Rev. V4 Features TO-8-1 • 28.5 dB Typical Gain • 2.7 dB Typical Low Noise Description M/A-COM’s AM-182 is a high gain feedback amplifier with high intercept and compression points. This amplifier is packaged in a TO-8 package. Due to the internal power dissipation the thermal rise should be minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM-182 is ideally suited for use where a high intercept, high reliability amplifier is required. Ordering Information Part Number Package AM-182 PIN TO-8-1 AMC-182 SMA Connectorized Outline Drawing: SMA Connectorized * Absolute Maximum Ratings 1 Parameter Absolute Maximum Max. Input Power +13 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C 1. Operation of this device above any one of these parameters may cause permanent damage. ∗ Dimensions are inches (millimeters) ±0.015 (0.38) unless otherwise specified. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-182 / AMC-182 Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz Rev. V4 Electrical Specifications: 2,3 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @+25oC 300 MHz dB 27.2 28.2 29.2 Frequency Response — 5 - 1000 MHz dB — — ±1.2 Gain Variation with Temperature — 5 - 1000 MHz dB — — ±1.2 1 dB Compression Output Power 5 - 1000 MHz dBm +9 — — Noise Figure — 5 - 1000 MHz dB — — 4.5 Reverse Transmission — 5 - 1000 MHz dB — -36 -32 VSWR — 5 - 1000 MHz Ratio — — 2.0:1 Output IP2 Two-Tone inputs up to 0 dBm 5 - 1000 MHz dBm +28 — — Output IP3 Two-Tone inputs up to 0 dBm 5 - 1000 MHz dBm +18 — — Vbias — — VDC +14.5 +15.0 +15.5 Ibias Vbias = +15.0 VDC — mA — 44 50 Power Dissipation @ +15 V Bias — mW — 660 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 800 mW must be provided in use. 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-182 / AMC-182 Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz Rev. V4 Typical Performance Curves 3 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.