UNISONIC TECHNOLOGIES CO., LTD DTC114E NPN SILICON TRANSISTOR NPN DIGITAL TRANSISTOR (BUILT- IN BIAS RESISTORS) FEATURES * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow negative input. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Lead Free Halogen Free DTC114EG-AE3-R DTC114EG-AL3-R DTC114EG-AN3-R DTC114EL-T92-B DTC114EG-T92-B DTC114EL-T92-K DTC114EG-T92-K DTC114EL-T9S-B DTC114EG-T9S-B DTC114EL-T9S-K DTC114EG-T9S-K Note: Pin Assignment: G: GND I: IN O: OUT Package SOT-23 SOT-323 SOT-523 TO-92 TO-92 TO-92SP TO-92SP Pin Assignment 1 2 3 G I O G I O G I O G O I G O I G O I G O I Packing Tape Reel Tape Reel Tape Reel Tape Box Bulk Tape Box Bulk MARKING SOT-23 / SOT-323 / SOT-523 TO-92 www.unisonic.com.tw Copyright © 2014 Unisonic Technologies Co., Ltd TO-92SP 1 of 3 QW-R206-047.J DTC114E NPN SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C, unless others specified) PARAMETER RATINGS UNIT 50 V -10 ~ +40 V 100 mA SOT-23/SOT-323 200 SOT-523 150 Power Dissipation PD mW TO-92 625 TO-92SP 550 Junction Temperature TJ +150 °C Storage Temperature TSTG -55 ~ +150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Supply Voltage Input Voltage Output Current SYMBOL VCC VIN IOUT ELECTRICAL CHARACTERISTICS (TA=25°C, unless others specified) PARAMETER SYMBOL VIN(OFF) Input Voltage VIN(ON) Output Voltage VOUT(ON) Input Current IIN Output Current IOUT(OFF) DC Current Gain hFE Input Resistance R1 Resistor Ratio R2/R1 Transition Frequency fT Note: Transition frequency of the device TEST CONDITIONS VCC =5V, IOUT =100μA VOUT =0.3V, IOUT =10mA IOUT/IIN =10mA/0.5mA VIN=5V VCC =50V, VIN =0V VOUT =5V, IOUT =5mA VCE =10V, IE =−5mA, f=100MHz (Note) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN TYP MAX 0.5 0.1 0.3 0.88 0.5 10 1 250 13 1.2 3 30 7 0.8 UNIT V V V mA μA KΩ MHz 2 of 3 QW-R206-047.J DTC114E NPN SILICON TRANSISTOR TYPICAL CHARACTERISTICS Input Voltage vs. Output Current (ON Characteristics) 100 Output Current vs. Input Voltage (OFF characteristics) 10m VOUT=0.3V VCC=5V 5m 50 TA= 100°C 25°C -40°C 20 Output Current, IOUT(A) Input Voltage :VI(ON) V 2m 10 TA= - 40°C 25°C 100°C 5 2 1 0.5 1m 500μ 200μ 100μ 50μ 20μ 10μ 5μ 0.2 2μ 0.1 0.1 1μ 0.2 0.5 1 2 5 10 20 50 100 0 0.5 Output Current, IOUT(mA) Output Voltage, VOUT(ON) (mV) DC Current Gain, hFE 100 50 20 10 5 50 20 10 5 2 1 2 5 10 20 50 100 Output Current, IOUT(mA) TA= 100°C 25°C -40°C 100 1 0.1 1 lOUT/lIN=20 200 2 0.5 3.0 500 200 0.2 2.5 2.0 1000 VOUT=5V TA= 100°C 25°C -40°C 500 1.5 Output Voltage vs. Output Current DC Current Gain vs. Output Current 1k 1.0 Input Voltage, VI(OFF) (V) 0.1 0.2 0.5 1 2 5 10 20 50 100 Output Current, IOUT(mA) UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R206-047.J