GBJ601 THRU GBJ607 SINGLE PHASE 6.0 AMP BRIDGE RECTIFIERS VOLTAGE RANGE 50 to 1000 Volts CURRENT 6.0 Amperes GBJ FEATURES * Ideal for printed circuit board .134(3.4) .122(3.1) 1.193(30.3) 1.169(29.7) .189(4.8) .173(4.4) .150(3.8) .134(3.4) ~ ~ .165(4.2) .142(3.6) .094(2.4) .078(2.0) .043(1.1) .035(0.9) .441(11.2) .425(10.8) + * Mounting position: Any .800(20.3) .776(19.7) * Low leakage current .708(18.0) .669(17.0) .189 (4.8) * Low forward voltage .114(2.9) .098(2.5) .031(0.8) .023(0.6) .402(10.2) .303(7.7) .303(7.7) SPACING .386(9.8) .287(7.3) .287(7.3) Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating 25 C ambient temperature uniess otherwies specified. Single phase half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. TYPE NUMBER GBJ601 GBJ602 GBJ603 GBJ604 GBJ605 GBJ606 GBJ607 UNITS 50 35 50 Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward (with heatsink Note 2) 100 70 100 200 140 200 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V 6.0 A Rectified Current at Tc=100 C (Without heatsink) Peak Forward Surge Current, 8.3 ms single half sine-wave 2.8 A superimposed on rated load (JEDEC method) Maximum Forward Voltage Drop per Bridge Element at 3.0A D.C. Maximum DC Reverse Current Ta=25 C 170 1.1 5.0 A V A at Rated DC Blocking Voltage Typical Junction Capacitance (Note 1) Typical Thermal Resistance R JC (Note 2) Operating Temperature Range, TJ Storage Temperature Range, TSTG 500 A 55 3.4 -55 +150 -55 +150 PF C/W C C Ta=100 C NOTES: 1. Measured at 1.0MHz and applied reverse voltage of 4.0V DC. 2. Thermal Resistance from Junction to Case with device mounted on 75mm x 75mm x 1.6mm Cu Plate Heatsink. 284 RATING AND CHARACTERISTIC CURVES (GBJ601 THRU GBJ607) FIG.2-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT AVERAGE FORWARD CURRENT,(A) 9 8 7 6 WITH HEATSINK 5 4 WITHOUT HEATSINK 3 Single Phase 2 1 0 Half Wave 60Hz Resistive Or Inductive Load 0 20 40 60 80 100 120 140 160 PEAK FORWARD SURGE CURRENT,(A) FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE 250 200 150 Sine Wave JEDEC method 50 0 1 CASE TEMPERATURE,( C) 8.3ms Single Half Tj=25 C 100 50 10 5 100 FIG.3-TYPICAL FORWARD FIG.4-TYPICAL REVERSE CHARACTERISTICS CHARACTERISTICS 50 50 10 10 REVERSE LEAKAGE CURRENT, ( A) INSTANTANEOUS FORWARD CURRENT,(A) NUMBER OF CYCLES AT 60Hz 3.0 1.0 Tj=25 C Pulse Width 300us 1% Duty Cycle 0.1 3.0 Tj=100 C 1.0 0.1 Tj=25 C .01 0 .2 .4 .6 .8 1.0 1.2 .01 1.4 FORWARD VOLTAGE,(V) 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) 285