Film capacitors - AC capacitors Motor run capacitors Series/Type: B32328 The following products presented in this data sheet are being withdrawn. Ordering Code B32328A4256J037 Substitute Product Date of Withdrawal 2013-02-08 Deadline Last Orders 2013-05-08 Last Shipments 2013-08-08 For further information please contact your nearest EPCOS sales office, which will also support you in selecting a suitable substitute. The addresses of our worldwide sales network are presented at www.epcos.com/sales. Film capacitors – AC capacitors Motor Run Capacitors B32328 – MotorCap™ Construction Dielectric: polypropylene film Plastic can and top UL 94 V2 material Dry type Features Self-healing properties Low dissipation factor P0 as per IEC 60252-1 2001-02 High insulation resistance Case IP 53 protected IEC/EN 60335-1 compatible on request Typical applications For general sine wave applications, mainly as motor run capacitor Terminals Twin core cable type PP 2 × 0.50 mm2, 600 V, 95 °C Connectors on request Mounting parts (optional) Threaded stud at bottom of can (max. torque = 5 Nm) Fast fixation for mounting into a hole of Ø 8 mm Technical data and specifications Reference standards IEC 60252-1 2001-02 / EN 60252 2001 Safety class to IEC 60252-1 2001-02 P0 Life expectancy to IEC 60252 2001 250 V/85 °C: 400 V/85 °C: 480 V/85°C: Rated capacitance CR See dimensions table Tolerance ±5% Rated voltage VR 250 V, 400 V, 480 V Rated frequency fR 50/60 Hz 10,000 h (class B) 10,000 h (class B) 3,000 h (class C) Maximum ratings Maximum permissible voltage Vmax 1.1 × VR (VR= Rated voltage) Maximum permissible current Imax 1.3 x IR (IR= Rated current) FK PC PM AC Please read the important notes, cautions and warnings. July 2007 Page 2 of 8 Film capacitors – AC capacitors Motor Run Capacitors B32328 – MotorCap™ Test data AC test voltage terminal to terminal VTT 2 · VR, 2 s (routine test) 2 · VR, 60 s (type test) Insulation resistance Rins or time constant τ at 20 °C, rel. humidity ≤ 65% (minimum as-delivered values) 3,000 s Dissipation factor tan δ at 20 °C ≤ 1,0 · 10-3 (120 Hz) Maximum rate of voltage rise dV/dtmax 10 V/μs Climatic data Climatic category 25/085/21 to IEC 60068-1 Lower category Tmin –25 °C Upper category Tmax +85 °C Damp heat test ttest 21 days Mechanical and thermal properties Ball pressure test to IEC 60309-1 sec. 27.3 20 N at 125 °C Plastic can and top disk material Compliant to EN 60252 UL 94 V2 compatible Glow wire test to IEC 60695-2-1/0 and –2-1/1 Test temp 550 °C for IR ≤ 0.5 A Test temp 750 °C for IR > 0.5 A Self extinguish within 30 seconds of withdrawing the glow wire and without igniting wrapping tissue. Tracking test to IEC 60112 solution A > 250 V Protection class to IEC 60529 2001 IP 53 Compatibility to RoHS Compliance to directive 2002/95/EC Approvals VDE 400 V/85 °C: 10,000 h (class B) for 1,5 µF ... 50 µF Approved 480 V/85 °C: Approved 3,000 h (class C) for 3 µF ... 35 µF FK PC PM AC Please read the important notes, cautions and warnings. July 2007 Page 3 of 8 Film capacitors – AC capacitors Motor Run Capacitors Dimensional drawing B32328 – MotorCap™ Mounting options # = 1: Can without mounting # = 2: Can with M8 bolt 10 Stud M8x1.25 Star Washer 8mm Nut M8x1.25 # = 5: Fast fix mounting 10 M8-sized M-Clip fast fixation 10 10.2+0.1/-0 2.0±0.05 Ø8.2+0.2/-0 Ø2.2+0.1/-0 FK PC PM AC Please read the important notes, cautions and warnings. July 2007 Page 4 of 8 Film capacitors – AC capacitors Motor Run Capacitors B32328 – MotorCap™ Ordering codes and packing units VR CR V AC μF 250 1,5 25 × 58 B32328A1155J0#* 112 2 25 × 58 B32328A1205J0#* 112 3 25 × 58 B32328A1305J0#* 112 4 25 × 58 B32328A1405J0#* 112 5 25 × 58 B32328A1505J0#* 112 6 25 × 58 B32328A1605J0#* 112 7 25 × 58 B32328A1705J0#* 112 7,5 25 × 58 B32328A1755J0#* 112 8 25 × 58 B32328A1805J0#* 112 9 30 × 62 B32328A1905J0#* 112 10 30 × 62 B32328A1106J0#* 112 12 30 × 62 B32328A1126J0#* 112 14 30 × 62 B32328A1146J0#* 112 15 30 × 62 B32328A1156J0#* 112 16 30 × 62 B32328A1166J0#* 112 18 30 × 62 B32328A1186J0#* 112 20 35 × 62 B32328A1206J0#* 84 22 35 × 62 B32328A1226J0#* 84 25 35 × 71 B32328A1256J0#* 84 30 35 × 71 B32328A1306J0#* 84 35 40 × 71 B32328A1356J0#* 60 40 40 × 71 B32328A1406J0#* 60 45 40 × 71 B32328A1456J0#* 60 50 40 × 95 B32328A1506J0#* 60 55 40 × 95 B32328A1556J0#* 60 60 40 × 95 B32328A1606J0#* 60 Max. dimensions d×l mm FK PC PM AC Please read the important notes, cautions and warnings. Ordering code Packing units pcs. July 2007 Page 5 of 8 Film capacitors – AC capacitors Motor Run Capacitors B32328 – MotorCap™ VR CR V AC μF 400 1,5 25 × 58 B32328A4155J0#* 112 2 25 × 58 B32328A4205J0#* 112 3 25 × 58 B32328A4305J0#* 112 4 25 × 58 B32328A4405J0#* 112 5 30 × 62 B32328A4505J0#* 112 6 30 × 62 B32328A4605J0#* 112 7 35 × 62 B32328A4705J0#* 84 7,5 35 × 62 B32328A4755J0#* 84 8 35 × 62 B32328A4805J0#* 84 9 35 × 62 B32328A4905J0#* 84 10 35 × 62 B32328A4106J0#* 84 12 35 × 71 B32328A4126J0#* 84 14 35 × 71 B32328A4146J0#* 84 15 40 × 71 B32328A4156J0#* 60 16 40 × 71 B32328A4166J0#* 60 18 40 × 71 B32328A4186J0#* 60 20 40 × 71 B32328A4206J0#* 60 22 40 × 71 B32328A4226J0#* 60 25 40 × 95 B32328A4256J0#* 60 30 40 × 95 B32328A4306J0#* 60 35 45 × 95 B32328A4356J0#* 45 40 45 × 95 B32328A4406J0#* 45 45 50 × 95 B32328A4456J0#* 32 50 50 × 95 B32328A4506J0#* 32 55 50 × 95 B32328A4556J0#* 32 60 50 × 95 B32328A4606J0#* 32 Max. dimensions d×l mm FK PC PM AC Please read the important notes, cautions and warnings. Ordering code Packing units pcs. July 2007 Page 6 of 8 Film capacitors – AC capacitors Motor Run Capacitors VR CR V AC μF 480 B32328 – MotorCap™ Max. dimensions d×l Ordering code mm Packing units pcs. 3 30 × 62 B32328A8305J0#* 112 4 30 × 62 B32328A8405J0#* 112 6 35 × 62 B32328A8605J0#* 84 7,5 35 × 62 B32328A8755J0#* 84 8 35 × 71 B32328A8805J0#* 84 10 40 × 71 B32328A8106J0#* 60 12 40 × 71 B32328A8126J0#* 60 15 45 × 71 B32328A8156J0#* 45 16 45 × 71 B32328A8166J0#* 45 20 45 × 71 B32328A8206J0#* 45 22 45 × 71 B32328A8226J0#* 45 25 45 × 95 B32328A8256J0#* 45 30 45 × 95 B32328A8306J0#* 45 35 45 × 95 B32328A8356J0#* 32 40 45 × 120 B32328A8406J0#* 45 45 50 × 120 B32328A8456J0#* 32 50 50 × 120 B32328A8506J0#* 32 Composition of ordering code: #: Construction 1 plastic can 3 plastic can with M8 bolt 5 plastic can with fast fixation device, available for diameters 30 mm, 32 mm and 35 mm, others on request #: Wire length (dimension ‘b’ in drawing) 7 200 mm 9 300 mm others on request U Please read “Applications warning, installation and maintenance instructions” and the “General Safety Data Sheet for Power Capacitors” issued by ZVEI, which are available on the internet at www.epcos.com/ac_capacitors, to ensure optimum performance and to prevent products from failing, and in worst case, bursting and fire. Information given in the data sheet reflects typical specifications. You are kindly requested to approve our product specifications or request our approval for your specification before ordering. FK PC PM AC Please read the important notes, cautions and warnings. July 2007 Page 7 of 8 Important notes The following applies to all products named in this publication: 1. Some parts of this publication contain statements about the suitability of our products for certain areas of application. These statements are based on our knowledge of typical requirements that are often placed on our products in the areas of application concerned. We nevertheless expressly point out that such statements cannot be regarded as binding statements about the suitability of our products for a particular customer application. As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them than the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS product with the properties described in the product specification is suitable for use in a particular customer application. 2. We also point out that in individual cases, a malfunction of passive electronic components or failure before the end of their usual service life cannot be completely ruled out in the current state of the art, even if they are operated as specified. In customer applications requiring a very high level of operational safety and especially in customer applications in which the malfunction or failure of a passive electronic component could endanger human life or health (e.g. in accident prevention or lifesaving systems), it must therefore be ensured by means of suitable design of the customer application or other action taken by the customer (e.g. installation of protective circuitry or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or failure of a passive electronic component. 3. The warnings, cautions and product specific notes must be observed. 4. In order to satisfy certain technical requirements, some of the products described in this publication may contain substances subject to restrictions in certain jurisdictions (e.g. because they are classed as “hazardous”). Useful information on this will be found in our Material Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed questions, please contact our sales offices. 5. We constantly strive to improve our products. Consequently, the products described in this publication may change from time to time. The same is true of the corresponding product specifications. Please check therefore to what extent product descriptions and specifications contained in this publication are still applicable before or when you place an order. We also reserve the right to discontinue production and delivery of products. Consequently, we cannot guarantee that all products named in this publication will always be available. 6. Unless otherwise agreed in individual contracts, all orders are subject to the current version of the “General Terms of Delivery for Products and Services in the Electrical Industry” published by the German Electrical and Electronics Industry Association (ZVEI). 7. The trade names EPCOS, BAOKE, Alu-X, CeraDiode, CSSP, MiniBlue, MKK, MLSC, MotorCap, PCC, PhaseCap, PhaseMod, SIFI, SIKOREL, SilverCap, SIMDAD, SIMID, SineFormer, SIOV, SIP5D, SIP5K, ThermoFuse, WindCap are trademarks registered or pending in Europe and in other countries. Further information will be found on the Internet at www.epcos.com/trademarks. FK PC PM AC July 2007 Page 8 of 8