SL Power MINT1400A 400w single output sery Datasheet

MINT1400A
400W Single Output Series
Medical – Universal Input Power Supply
2 Year Warranty
•Compact 3.94” x 7” x 1.58”, 1U compatible
•9.5 W/in³
•300W Convection Rating
•Efficiency up to 91%
•12Vdc to 48Vdc outputs, up to 400W
•Remote ON/OFF by PS-ON Signal
•Safety approved to Medical and ITE Standards
• EN/IEC/UL60601-1 and CSA 601.1
•CSA/EN/IEC/UL60950-1, 2nd Edition
•Compliant to EN55011/22 Conducted Noise,
Class B
•RoHS Compliant – Category 6
Specifications
AC Input
All Specifications are typical at nominal input, full load at 25°C unless otherwise stated.
80-270VAC, 47-63 Hz single phase. (See Note 1)
Turn On Time
500mSec maximum
120VAC: 4.2A, 230VAC: 2.1A
Hold-up Time
20 ms at 400W
Input Current Input
Inrush Current Input
Active circuit, 37A max
Input Fuses
F1, F2: 6.3A
Power Factor
Efficiency
0.99 typical, 0.96 minimum
Typical 88% @ 120VAC, 91% @ 240VAC
Remote Sense
Overvoltage Protection
Switching Frequency
Output Voltages
See chart. Voltages adjustable +/- 5%
Earth Leakage Current
Total Regulation
See chart
Not required
Transient Response
500µs to 1%, 0.2A/µs, 3.5% Deviation
Shock and Vibration
Shock:
MIL-STD-810E, 516.4 part IV
Vibration: 5Hz – 500Hz, 2.5 Grms
Cycling type, 470W typical
Overtemperature Protection
Provided on all models, autorecovery. See page 2 for cooling information
Compensates for up to 500mV
drop on output leads
Output Power
400W with fan cooling. See derating chart for other
conditions. Peak: 450W for 1 min., 10% duty cycle
Ripple and Noise
1% pk-pk max., 20MHz BW, differential mode
Minimum Load
See chart
Overload Protection
Safety Standards
Isolation
Operating Temperature
Storage Temperature
Relative Humidity
Output: 170kHz ± 8kHz;
PFC: 90kHz, ± 8kHz; Bias: 100kHz, ± 6 kHz
Medical: EN/IEC/UL 60601-1, CSA 601.1
ITE: CSA/EN/IEC/UL 60950-1, 2nd Edition
Input-Output: 4000VAC,
Input-Ground: 1500VAC, Output-Ground
100µA at 120VAC, 60Hz Normal.
400µA at 264Vac, 60Hz SFC.
0° to 70°C, refer to derating
curve for ratings >40°C
-40 to +85°C
5% to 95%, non-condensing
Altitude
Operating: -500 to 10,000 ft.
Non-Operating: -500 to 40,000 ft.
Model Number Key
MINT 1 400 A 12 10 L 01
01 = Standard Model, 02 and higher indicates a m odified m odel.
"L" = Input Connector - EBY P/N 5002-03-N-12
"10" = Output Connections - Bus Bars w ith #10 screw s
Output Voltage: "12" = 12V output, "24" = 24V output, etc.
Model Configuration: "A" = Original Configuration
Output Pow er (Watts) - "400" = 400W
# of Outputs
Product Fam ily: "M" = Medical, "I" = Internal, "NT" = New Technology
______________________________________________________________________________________________________________________________ 1 of 3
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
MINT1400A
400W Single Output Series
Medical – Universal Input Power Supply
2 Year Warranty
Output Parameters
Model
Number
Output
Volts (V)
MINT1400A1210L01
Output Current
Fan Cooled
Convection
12V
33.0A
Ripple
& Noise
25.0A
Total
Regulation
1%
2%
MINT1400A2410L01
24V
16.7A
12.5A
1%
2%
MINT1400A2810L01
28V
14.3A
10.7A
1%
2%
MINT1400A4810L01
48V
8.30A
6.30A
1%
2%
Note 1: When the input voltage is <90Vac, derate output power to 300W fan cooled, or 250W convection.
Signals
Inhibit:
TTL LOW to inhibit
PS Off:
TTL HIGH to inhibit
Pwr OK
TTL HIGH when AC is OK, 100-200 mS delay.
Pwr OK
PF LOW 4 mS warning before loss of output regulation.
DC OK:
HIGH when output is >90% of nominal
Fan Output:
12Vdc @ 250 mA.
5V Standby Voltage:
Always on, up to 100mA.
EMI/EMC Compliance
Conducted Emissions
EN55011/22 Class B
Radiated Emissions
EN55011/22 Class A
Voltage Fluctuations
EN61000-3-3, complies
Static Discharge Immunity
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
Radiated RF Immunity
EN61000-4-3, 3V/m.
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz..
Line Surge Immunity
EN61000-4-5, 1kV differential, 2kV common-mode
Conducted RF Immunity
EN61000-4-6, 3Vrms
Power Frequency Magnetic Field Immunity
EN61000-4-8, 3A/m
Voltage Dip Immunity
EN61000-4-11 criteria A @ 250 Watts or less.
Line Frequency Harmonics
EN61000-3-2, Class A
Output Power Derating Curve
MINT1400 Output Power Derating Chart
Output Power (Watts)
450
400
350
300
Note: For convection cooling, the
power supply is required to be
mounted on a heatsink or system
chassis with a minimum of 150 in² of
surface area.
250
200
External 200 lfm Fan
Convection
150
100
50
0
0
10
20
30
40
50
60
70
Ambient Temperature (deg C)
______________________________________________________________________________________________________________________________ 2 of 3
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
MINT1400A
400W Single Output Series
Medical – Universal Input Power Supply
2 Year Warranty
Outline Drawing & Connector Information
Connector Information
SIGNAL CONNECTOR (J3) (optional):
INPUT CONNECTOR (TB1):
Pin 1
AC Line
Pin 2
Pin 3
Neutral Ground
Manufacturer's P/N:
EBY P/N 5002-03-N-12
Pin 1
PS OFF
Pin 5
RTN
Pin 2
INHIBIT
Pin 6
+5V Standby
Pin 3
PWR OK
Pin 7
­ SENSE
Pin 4
DC OK
Pin 8
+ SENSE
Manufacturer's P/N:
AMP P/N 640456-8
DC OUTPUT CONNECTORS (TB2):
Pin 1
+Vout
Pin 2
-Vout
Manufacturer's P/N:
Bus bars with
#10 screws
FAN OUTPUT CONNECTOR (J4) (optional):
Pin 1
+12V @ .25A
Pin 2
RTN
Manufacturer's P/N:
AMP P/N 640456-2
MATING CONNECTORS:
Mate For:
J1
TB2
Manufacturer's P/N:
#6-32 Lug, 0.325 Center
Wire - sized for output current rating.
Options:
Signals
Fan Output
Mate For:
J3
J4
Manufacturer's P/N:
AMP P/N 1375820-8, Pins: 1375813-3
AMP P/N 1375820-2, Pins: 1375813-3
Data Sheet © 2011 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication.
Rev. 3-12-2013
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
______________________________________________________________________________________________________________________________ 3 of 3
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
Similar pages