Yea Shin GBL410 Glass passivated single-phase bridge rectifier Datasheet

DATA SHEET
GBL4005 THRU GBL410
SEMICONDUCTOR
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
Reverse Voltage - 50 to 1000 Volts Forward Current - 4.0 Amperes
FEATURES
GBL Unit:inch(mm)
•Plastic package has Underwriters Laboratory Flammability
Classification 94V-0
•This series is UL listed under the Recognized Component
0.825 (20.9)
0.815 (20.7)
0.125 (3.17)
x 45 degrees
Chamfer
Index, file number E54214
•Glass passivated chip junctions
•High case dielectric strength
0.421 (10.7)
•Typical IR less than 0.1mA
0.411 (10.4)
0.080 (2.03)
0.060 (1.50)
•High surge current capability
•Ideal for printed circuit boards
•High temperature soldering guaranteed:
260°C/10 seconds, 0.375" (9.5mm) lead length,
0.098 (2.5)
0.075 (1.9)
0.095 (2.41)
0.080 (2.03)
5 lbs. (2.3kg) tension
0.718 (18.2)
0.682 (17.3)
0.098 (2.5)
0.075 (1.9)
O
•High temperature soldering : 260 C / 10 seconds at terminals
Lead Depth
0.022 (0.56)
•Pb free product at available : 99% Sn above meet RoHS
0.050 (1.27)
0.018 (0.46)
0.040 (1.02)
environment substance directive request
0.210 (5.3)
0.190 (4.8)
MECHANICAL DATA
0.040 (1.02)
0.030 (0.76)
•Case: Molded plastic body over passivated junctions
0.140 (3.56)
0.128 (3.25)
0.022 (0.56)
•Terminals: Plated leads solderable per MIL-STD-750,
0.018 (0.46)
Method 2026
Polarity shown on front side of case: positive lead by beveled corner
•Mounting Position: Any
•Weight: 0.071 ounce, 2.0 grams
Dimensions in inches and (millimeters)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25°C ambient temperature unless otherwise specified.
SYMBOLS
GBL
GBL
GBL
GBL
GBL
GBL
GBL
4005
401
402
404
406
408
410
UNITS
Maximum repetitive peak reverse voltage
VRRM
50
100
200
400
600
800
1000
Volts
Maximum RMS voltage
VRMS
35
70
140
280
420
560
700
Volts
VDC
50
100
200
400
600
800
1000
Volts
Maximum DC blocking voltage
4.0
Maximum average forward TC=50°C (NOTE 1)
rectified output current at TA=40°C (NOTE 2)
Peak forward surge current, single half sine-wave
superimposed on rated load (JEDEC Method) TJ=150°C
3.0
I(AV)
IFSM
150.0
Amps
I2t
93.0
A2sec
VF
1.0
Volts
Rating for fusing (t<8.3ms)
Maximum instantaneous forward drop per leg
at 4.0 Amperes
Maximum DC reverse current at rated TA=25°C
5.0
IR
DC blocking voltage per leg TA=125°C
Typical junction capacitance per leg (NOTE 3)
uA
500.0
CJ
95.0
40.0
Typical thermal resistance per leg (NOTE 1)
RQJA
22.0
(NOTE 2)
RQJL
3.5
TJ, TSTG
-55 to +150
Operating junction storage and temperature range
Amps
pF
℃/W
℃
NOTES:
(1) Unit mounted on 3.0 x 3.0 x 0.11" thick (7.5 x 7.5 x 0.3cm) Al. plate
(2) Unit mounted on P.C.B. at 0.375" (9.5mm) lead length and 0.5 x 0.5" (12 x12mm) copper pads
(3) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts
http://www.yeashin.com
1
REV.02 20120305
DEVICE CHARACTERISTICS
GBL4005 THRU GBL410
Fig. 2 -- Maximum Non-Repetitive Peak
Forward Surge Current Per Leg
Fig. 1 -- Derating Curves Output
Rectified Current
150
60 Hz Resistive or Inductive Load
Peak Forward Surge Current (A)
Average Forward Output Current (A)
5.0
Heat-Sink Mounting
3.0 x 3.0 x 0.11" Thick
(7.5 x 7.5 x 0.3cm)
Aluminum Plate
4.0
3.0
2.0
P.C.B. Mounting
0.47 x 0.47" (12 x 12mm)
Copper pads with 0.375"
(9.5mm) lead length
1.0
0
TJ = TJ max.
Single Sine-Wave
(JEDEC Method)
100
50
1.0 Cycle
0
0
50
100
150
10
1
Fig. 4 -- Typical Reverse Leakage
Characteristics Per Leg
Fig. 3 -- Typical Forward Voltage
Characteristics Per Leg
500
Instantaneous Reverse Current (A)
10
1
TJ = 25°C
Pulse width = 300µs
1% Duty Cycle
0.01
0.4
0.6
0.8
1.0
1.2
1.4
100
10
TA = 125°C
1
0.1
TA = 25°C
0.01
40
20
0
1.6
80
60
100
Percent of Rated Peak Reverse Voltage (V)
Fig. 5 -- Typical Junction Capacitance
Per Leg
Fig. 6 -- Typical Transient Thermal
Impedance Per Leg
1,000
Junction Capacitance (pF)
50 — 400V
600 — 1000V
Instantaneous Forward Voltage (V)
Transient Thermal Impedance (°C/W)
Instantaneous Forward Current (A)
100
0.1
100
Number of Cycles at 60Hz
Ambient Temperature (°C)
TJ = 25°C
f = 1.0MHz
Vsig = 50mVp-p
100
10
0.1
50 — 400V
600 — 1000V
1
10
100
10
1
0.1
0.01
0.1
1
10
t, Heating Time (sec.)
Reverse Voltage (V)
http://www.yeashin.com
100
2
REV.02 20120305
100
Similar pages