14 Pin DIL 5 Tap TTL Compatible MIL 883 Active Delay Lines TAP DELAYS ±5% or 2 nS TOTAL DELAYS ±5% or 2 nS 5, 10, 15, 20 6, 12, 18, 24 7, 14, 21, 28 8, 16, 24, 32 9, 18, 27, 36 10, 20, 30, 40 12, 24, 36, 48 15, 30, 45, 60 20, 40, 60, 80 25, 50, 75, 100 30, 60, 90, 120 35, 70, 105, 140 40, 80, 120, 160 45, 90, 135, 180 50, 100, 150, 200 60, 120, 180, 240 70, 140, 210, 280 25 30 35 40 45 50 60 75 100 125 150 175 200 225 250 300 350 PART NUMBER TAP DELAYS ±5% or ±2 nS TOTAL DELAYS ±5% or ±2 nS EP9810M-25 EP9810M-30 EP9810M-35 EP9810M-40 EP9810M-45 EP9810M-50 EP9810M-60 EP9810M-75 EP9810M-100 EP9810M-125 EP9810M-150 EP9810M-175 EP9810M-200 EP9810M-225 EP9810M-250 EP9810M-300 EP9810M-350 80, 160, 240, 320 84, 168, 252, 336 88, 176, 264, 352 90, 180, 270, 360 94, 188, 282, 376 100, 200, 300, 400 110, 220, 330, 440 120, 240, 360, 480 130, 260, 390, 520 140, 280, 420, 560 150, 300, 450, 600 160, 320, 480, 640 170, 340, 510, 680 180, 360, 540, 720 190, 380, 570, 760 200, 400, 600, 800 PART NUMBER 400 420 440 450 470 500 550 600 650 700 750 800 850 900 950 1000 EP9810M-400 EP9810M-420 EP9810M-440 EP9810M-450 EP9810M-470 EP9810M-500 EP9810M-550 EP9810M-600 EP9810M-650 EP9810M-700 EP9810M-750 EP9810M-800 EP9810M-850 EP9810M-900 EP9810M-950 EP9810M-1000 Delay Times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current IIL IOS Low-Level Input Current Short Circuit Output Current ICCH High-Level Supply Current ICCL Low-Level Supply Current TRO Output Rise Time NH NL Fanout High-Level Output Fanout Low-Level Output VCC = min. VIL = max. I OH = max VCC = min. VIH = min. IOL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V VCC = max. VIN = 0.5V VCC = max. VOUT = 0. (One output at a time) VCC = max. VIN = OPEN VCC = max. VIN = 0 Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS VCC = max. VOH = 2.7V VCC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA Min Max Unit Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature VCC EP9810M 10/92 0.5 -1.2 50 1.0 -2 -100 V V V µA mA mA mA 14 VCC 12 4 10 6 8 OUTPUT INPUT 1 7 GROUND 75 mA 75 mA 4 nS 5 nS 20 TTL LOAD 10 TTL LOAD Package Dimensions Max Unit 4.5 2.0 5.5 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 -55 40 +125 White Dot Pin#1 PCA EP9810M-25 Date Code Unit 3.2 110 2.0 1.0 100 5.0 Volts % nS MHz KHz Volts .410 Max. .820 Max. .020 Min. .325 Max. .018 x .010 Input Pulse Test Conditions @ 25° C Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage -40 Min *These two values are inter-dependent. EIN PW TRI PRR 2.7 Schematic .150 Typ. .100 ELECTRONICS .300 INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791