FUJITSU SEMICONDUCTOR INTRODUCTION SHEET NP07-12631-1E 8-bit Microcontrollers MB95350L Series The MB95350L is a series of general-purpose, single-chip microcontrollers. In addition to a compact instruction set, the microcontrollers of this series contain a variety of peripheral resources for example 2 channels I2C. This can be used for the Security sensors, Toys, Heater detector applications which need more communication ports application etc. ■ FEATURES F2MC-8FX CPU ■PRODUCT LINEUP Part number Parameter Instruction set optimized for controllers MB95F 352E MB95F 353E Type Clock Maximum clock frequency：16.25MHz Timer 8/16-bit composite timer：2 channels Time-base timer：1 channels UART/SIO 1 channel(alternative selection between I2C and UART/SIO) MB95F 282L MB95F 283L MB95F 284L Flash memory product ROM (Byte) 8K RAM (Byte) 240 Low-voltage detection reset MB95F 354E 12K 20K 496 8K 12K 240 Yes 20K 496 No I2C 1 channel [+ 1 channel(alternative selection between I2C and UART/SIO)] LIN/UART:1 channel External interrupt：6 channels - Interrupt by edge detection - Can be used to wake up the device from different low power consumption (standby) modes 8/10-bit A/D converter：6 channels Low power consumption (standby) modes Stop mode Sleep mode Watch mode Time-base timer mode I/O port MB95F352E/F353E/F354E：22 MB95F352L/F353L/F354L：21 On-chip debug - 1-wire serial control - Serial writing supported (asynchronous mode) ■ORDERING INFORMATION Product name Package Remarks MB95F352EPF MB95F352LPF MB95F353EPF MB95F353LPF MB95F354EPF MB95F354LPF Plastic・SOP,24-pins (LCC-24P-M34) 7.50mm×15.34mm,1.27mm pitch - MB95F352EPFT MB95F352LPFT MB95F353EPFT MB95F353LPFT MB95F354EPFT MB95F354LPFT Plastic・TSSOP,24-pins (FPT-24P-M10) 4.40mm×7.80mm,0.65mm pitch - MB95F352EWQN MB95F352LWQN MB95F353EWQN MB95F353LWQN MB95F354EWQN MB95F354LWQN Plastic・QFN,32-pins (LCC-32P-M19) 5.00mm□,0.50mm pitch - ■PACKAGE EXAMPLE OF REFERENCE Hardware/software watchdog timer Low-voltage detection reset circuit MB95F352E/F353E/F354E Clock supervisor counter Dual operation Flash memory Flash memory security function Power supply：1.8～3.6V *The range of the power supply voltage is different according to the operating frequency and the operating temperature. May, 2010 1/2 Copyright©2010 FUJITSU SEMICONDUCTOR LIMITED All rights reserved Plastic ・ TSSOP, 24-pins (FPT-24P-M10) MB95350L Series PRELIMINARY ■ BLOCK DIAGRAM F2MC-8FX CPU PF2/RST*2 Reset with LVD Flash with security function PF1/X1*2 PF0/X0*2 Oscillator circuit PG2/X1A*2 CR oscillator RAM (496/240 bytes) PG1/X0A*2 Interrupt controller (P04/HCLK1) Clock control (P05*3/HCLK2) (P05*3/TO00) (P12/DBG*1) On-chip debug (P06*3/TO01) 8/16-bit composite timer (0) External interrupt P02/INT02 to P07/INT07 Internal bus P12*1/EC0, (P04/EC0) Wild register P62*3/TO10 P63*3/TO11 8/16-bit composite timer (1) P64/EC1 8/10-bit A/D converter (P00/AN00 to P05/AN05) P14*1/SDA0 I2C (0) P15*1/SCL0 (P16/SDA1) I2C (1) (P17/SCL1) (P02/SCK) PG0/UCK LIN-UART (P03/SOT) UART/SIO P16/UO (P04/SIN) P17/UI Por t Por t Vcc *1: P12, P14 and P15 are N-ch open drain pins. Vss *2: Software option *3: P05, P06, P62 and P63 are high-current ports. Note: Pins in parentheses indicate that functions of those pins are shared among different resources. ■ SUPPORT TOOL HARDWARE Name BGM adapter PC cable Evaluation board Part Number MB2146-08-E USB cable MB2146-460-E Remarks F2MC-8FX MB95200 series in common Attached to MB2146-08-E, 1.0m - SOFTWARE Software SOFTUNE V3 Professional Pack Part Number SP36503Z008-P01 Operating System Windows2000/XP/Vista FLASH MICROCONTROLLER PROGRAMMER Name Parallel programmer Serial on board programmer Remarks Made by Flash Support Group, etc. (Under contemplation) FUJITSU FLASH MCU Programmer NP07-12631-1E May, 2010 2/2 Copyright©2010 FUJITSU SEMICONDUCTOR LIMITED All rights reserved