Vectron OX-4011-EAP-108 Oven controlled crystal oscillator Datasheet

OX-400 / OX 401
Oven Controlled Crystal Oscillator
OX-400 / 401
Features
4-Pin Dip
Fast warm-up
TCXO replacement for better short term stability
Frequency Range, 10 MHz to 160 MHz
Standard frequencies, 20 MHz (SC); 13 MHz (AT)
•
•
•
•
Base stations
Test equipment
Synthesizers
Military communication equipment
Performance Specifications
Frequency Stabilities1 (AT-Cut Crystal-Standard - 10 to 160 MHz)
Parameter
Min
vs. operating temperature range
(referenced to +25°C)
Initial tolerance
vs. supply voltage change
vs. load change
vs. aging / day
vs. aging / year
Max
Units
-100
-250
-250
+100
+250
+250
ppb
ppb
ppb
-0.5
-20
-20
-10
-300
-500
+0.5
+20
+20
+10
+300
+500
ppm
ppb
ppb
ppb
ppb
ppb
at time of shipment, nominal EFC
VS ±5% static
Load ±5% static
after 30 days of operation
≤ 60MHz after 30 days of operation
≥ 60 MHz after 30 days of operation
3
minutes
to ±200ppb of final frequency (1 hour
reading) @ +25°C
Warm-up time
Typical
Condition
-20 to +70°C
-20 to +70°C
-40 to +85°C
Frequency Stabilities1 (SC-Cut Crystal-Option - 10 to 160 MHz)
vs. operating temperature range
(referenced to +25°C)
-10
-25
-50
+10
+25
+50
ppb
ppb
ppb
-20 to +70°C
-20 to +70°C
-40 to +85°C
Initial tolerance
vs. supply voltage change
vs. load change
vs. aging / day
vs. aging / year
vs. aging / year
-0.2
-10
-10
-5.0
-100
-500
+0.2
+10
+10
+5.0
+100
+500
ppm
ppb
ppb
ppb
ppb
ppb
at time of shipment, nominal EFC
VS ±5% static
Load ±5% static
after 30 days of operation
≤ 60 MHz; after 30 days of operation
≥60 MHz; after 30 days of operation
Page 1 of 5
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Options5
•
•
•
•
•
Applications
Performance Specifications
Supply Voltage (Vs)
Parameter
Supply voltage (standard)
Min
Typical
Max
3.135
3.3
3.465
VDC
4.75
5.0
5.25
VDC
2.5
Watts
during warm-up
1.0
Watts
steady state @ +25°C
Power consumption
Units
Condition
RF Output
Signal [standard]
HCMOS
Load
15
pF
Signal Level (Vol)
0.4
Signal Level (Vol)
0.5
Signal Level (Voh)
2.4
Signal Level (Voh)
3.5
Duty Cycle
45
VDC
with Vs=3.3V and 15pF Load
with Vs=5.0V and 15pF Load
VDC
with Vs=3.3V and 15pF Load
with Vs=5.0V and 15pF Load
55
Signal
%
@ (Voh-Vol)/2
Sine Wave
Load
50
Output Power @3,3V
2
5
Putput Power @ 5.0V
5
8
Ω
8
Harmonics
dBm
50 Ω load
11
dBm
50 Ω load
-30
dBm
50 Ω load
Tuning Range
Fixed OCXO; No adjust
Tuning Range
±5.0
±12
ppm
with AT cut crystal
±1.0
±3
ppm
with SC cut crystal
Linearity
Option5
Frequency Tuning (EFC) 10 to 160 MHz
10%
Tuning Slope
Positive
Control Voltage Range
0.0
1.4
2.8
VDC
with Vs=3.3V
0.0
2
4.0
VDC
with Vs=5.0V
Additional Parameters
Phase Noise3
Weight
Processing & Packing
-65
-95
-120
-140
-145
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
8.0
g
1 Hz
10 Hz
100 Hz
1 kHz
10 kHz
Handling & Processing Note
Absolute Maximum Ratings
supply voltage (Vs)
6.5
V
Output Load
50
pF
Operable Temperature Range
-55
+85
°C
Storage Temperature Range
-55
+125
°C
with Vs=3.3 & 5.0 VDC
Page 2 of 5
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
@ 10MHz
Outline Drawing / Enclosure
OX-400
Height “H”
Pin Length “L”
8.5
5.85min.
Pin Connections
1
Electronic Frequency Control Input (EFC)
7
Ground (Case)
8
RF Output
14
Supply Voltage Input
OX-401
Height “H”
Pin Length “L”
10.8
N/A
Pin Connections
1
Electronic Frequency Control Input (EFC)
7
Ground (Case)
8
RF Output
14
Supply Voltage Input
Dimensions in inches mm
Page 3 of 5
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Standard Shipping Method (OX-401)
Lage im Gurt
Position in tape
Pin 1
A
Abwickelrichtung
Unwinding direction
X
B
Gurtunterseite
Tape buttom side
K
P
Gurtoberseite
Tape upper side
*bei W ≤ 24 mm nur untere Lochreihe
∗by W ≤ 24 mm only lower hole line
Enclosure Type
Tape Width W (mm)
Quantity per meter
Quantity per reel
Dimension P
Typ OX-401
44
50
300
20
Recommended Reflow Profile
Profile Feature
Pb-Free Assembly/
Sn-Pb Assembly
Profile Feature
Pb-Free Assembly/
Sn-Pb Assembly
Average ramp-up rate (TL to TP)
3°C/second max.
Time 25°C to Peak Temperature
8 minutes max.
150°C
200°C
60-180 seconds
Time maintained above
-Temperature (TL)
-Time (tL)
217°C
60-150 seconds
Preheat
-Temperature Min TSmin
-Temperature Min TSmax
-Time (min to max) tS
TSmax to TL -Ramp-up Rate
3°C/second max
Time maintained above
-Temperature (TL)
-Time (tL)
217°C
60-150 seconds
Time within 5°C of actual Peak
Temperature (tP)
20-40 seconds
Peak Temperature (TP)
max 260°C
Ramp-down Rate
6°C/ second max
Note: All temperatures refer to topside of the package, measured on the package body surface.
Page 4 of 5
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Ordering Information
OX - 400 0 - D A E - 258 0 - 10M0000000
Product Family
OX: OCXO
Frequency
Package
THT version: 400
SMD version: 401
Frequency Control
0: No Tuning
1: ±5.0 to ±12ppm
2: ±1.0 to ±3.0ppm
Height
0: 8.5 mm
1: 10.8 mm
Stability Code
108: ±10ppb
258: ±25ppb
508: ±50ppb
107: ±100ppb
257: ±250ppb
Temperature Range
E: -40°C to +85°C
J: -20°C to +70°C
P: 0°C to +50°C
Supply Voltage
D: 5V
E: 3.3V
RF Output Code
A: HCMOS
E: Sinewave
Notes:
1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modification.
5. Contact factory for availability.
For Additional Information, Please Contact
USA:
Europe:
Asia:
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Vectron International
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 86.21.5048.1881
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
Rev: 8/2008
Page 5 of 5
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Similar pages