OP505, OP505W, OP506, OP506W OP535, OP705 OP505, OP535, OP705 OP506 Features: OP505W T-1 package style Variety of sensitivity ranges Choice of narrow or wide receiving angle Small package size ideal for space-limited applications 0.050” [1.27mm] or 0.100” [2.54mm] Lead spacing OP506W Description: Each OP505 and OP506 devices consist of an NPN silicon phototransistor, the OP535 device consist of an NPN silicon photodarlington transistor and the OP705 device consist of an NPN silicon phototransistor with a large value resistor integrated between the Base and Emitter for low light signal rejection. All of the devices are molded in a blue-tinted T-1 (3mm) epoxy package The OP505, OP535 and OP705 devices have a narrow receiving angle that provides excellent on-axis coupling while the OP506 device has a wider receiving angle for those applications where a narrow receiving angle of the OP505, OP535 and OP705 is not required. The OP505W and OP506W device have the widest receiving angle and provides relatively even reception over a large area. Devices are 100% production tested, using infrared light for close correlation with Optek’s GaAs and GaAIAs emitters. Please refer to Application Bulletins 208 and 210 for additional design information and reliability (degradation) data. Please see your OPTEK representative for custom versions of these devices. Applications: Space-limited applications Interruptive applications to detect media which is semitransparent to infrared light Ordering Information Part Number Sensor Viewing Angle Lead Spacing Lead Length 20° 0.050” [1.27 mm] OP505A OP505B OP505C OP505D OP505W Transistor 90° OP506A OP506B 20° OP506C OP506W OP535A OP535B OP705A 0.100” [2.54 mm] 0.50" [12.7 mm] 90° Darlington RBE Transistor 20° 0.050” [1.27 mm] RoHS General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 1 OP505, OP505W, OP506, OP506W OP535, OP705 OP505, OP535, OP705 Pin # Transistor 1 2 Emitter Collector OP505, OP506 OP505W, OP506W 2 OP505W 1 OP705 2 OP506 1 OP535 2 1 OP506W CONTAINS POLYSULFONE Methanol and isopropanol alcohols are recommended cleaning agents. Housings are soluble in chlorinated hydrocarbons and keytones. Highly activated or water soluble fluxes may damage body. Testing reagents before use is recommended prior to use. TOLERANCES ARE ± .010” [.25] UNLESS OTHERWISE STATED DIMENSIONS ARE IN INCHES [MILLIMETERS] General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 2 OP505, OP505W, OP506, OP506W OP535, OP705 Electrical Specifications Absolute Maximum Ratings ( TA = 25° C unless otherwise noted) Storage & Operating Temperature Range -40°C to +100° C Collector-Emitter Voltage (OP505, OP506, OP505W, OP506W, OP705) 30 V Collector-Emitter Voltage (OP535) 15 V Emitter-Collector Voltage (OP505 and OP506 series only) 5.0 V Lead Soldering Temperature (1/16 inch (1.6 mm) from case for 5 seconds with soldering iron) 260° C Power Dissipation 100 mW (2) Emitter Reverse Current (OP705 series only) 10 mA Collector DC Current (OP705 series only) 30 mA Electrical Characteristics ( TA = 25° C unless otherwise noted ) OP505, OP506, OP505W, OP506W, OP705 SYMBOL PARAMETER MIN TYP MAX OP505A, OP506A OP505B, OP506B OP505C, OP506C OP505D 4.30 2.15 1.10 0.55 - 5.95 3.00 - OP705A 3.95 - OP505W, OP506W 0.10 Collector-Emitter Saturation Voltage OP505, OP506, OP705 OP505W, OP506W UNITS TEST CONDITIONS On-State Collector Current IC(ON) VCE(SAT) ICEO Collector-Dark Current mA VCE = 5 V, Ee = 0.50 mW/cm2 , Note 3 12.00 mA VCE = 5 V, Ee = 0.50 mW/cm2, Note 3 - - mA VCE = 5 V, Ee = 0.75 mW/cm2, Note 3 - - 0.40 V IC = 250 μA, EE = 0.5 mW/cm2, Note 3 - - 0.40 V IC = 50 μA, EE = 0.75 mW/cm2, Note 3 - - 100 nA VCE = 10 V, EE = 0 V(BR)CEO Collector-Emitter Breakdown Voltage 30 - - V IC = 100 μA, EE = 0 V(BR)ECO Emitter-Collector Breakdown Voltage OP505, OP506 5 - - V IE = 100 μA, EE = 0 0.4 - - V IE = 100 μA, EE = 0 Relative IC Changes with Temperature - 1.00 - % / °C Knee Point Irradiance (OP705) - 0.02 - OP705 ∆IC/∆T EKP VCE = 5 V, EE = 1.0 mW/cm2 mW/cm2 VCE = 5 V, Note 4 Notes: (1) RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering. A maximum of 20 grams force may be applied to the leads when soldering. (2) Derate linearly 1.33 mW/° C above 25° C. (3) Light source is an unfiltered GaAs LED with a peak emission wavelength of 935 nm and a radiometric intensity level, which varies less than 10% over the entire lens surface of the phototransistor being tested. (4) The knee point irradiance is defined as the irradiance required to increase Ic(on) to 50 μA. General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 3 OP505, OP505W, OP506, OP506W OP535, OP705 Electrical Specifications Electrical Characteristics ( TA = 25° C unless otherwise noted ) OP535 SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS 10.5 3.5 - 32.0 mA Collector-Emitter Saturation Voltage - - 1.10 V IC = 400 μA, EE = 0.13 mW/cm2 , Note 3 Collector-Dark Current - - 100 nA VCE = 10 V, EE = 0 On-State Collector Current IC(ON) VCE(SAT) ICEO OP535A OP535B VCE = 5 V, EE = 0.13 mW/cm2, Note 3 V(BR)CEO Collector-Emitter Breakdown Voltage 15.0 - - V IC = 1.0 mA, EE = 0 V(BR)ECO Emitter-Collector Breakdown Voltage 5.0 - - V IE = 100 μA, EE = 0 General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 4 OP505, OP505W, OP506, OP506W OP535, OP705 Performance OP505A, OP505B, OP505C, OP505D General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 5 OP505, OP505W, OP506, OP506W OP535, OP705 Performance OP505W General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 6 OP505, OP505W, OP506, OP506W OP535, OP705 Performance OP506A, OP506B, OP506C General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 7 OP505, OP505W, OP506, OP506W OP535, OP705 Performance OP506W General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 8 OP505, OP505W, OP506, OP506W OP535, OP705 Performance OP535A, OP535B, OP535D General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 9 OP505, OP505W, OP506, OP506W OP535, OP705 Performance OP705A Collector Emitter General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue B 08/2016 Page 10