EMG8 / UMG8N / FMG8A Transistors Emitter common (dual digital transistors) EMG8 / UMG8N / FMG8A zFeatures 1) Two DTC143Z chips in a EMT or UMT or SMT package. 2) Mounting cost and area can be cut in half. zExternal dimensions (Unit : mm) (3) 0.22 (4) (2) 1.2 1.6 (1) 0.5 0.13 (5) zStructure Epitaxial planar type NPN silicon transistor (Built-in resistor type) 0.5 0.5 1.0 1.6 EMG8 Each lead has same dimensions ROHM : EMT5 Abbreviated symbol : G8 2.0 (2) (1) (5) 1.3 (3) (4) 0.2 The following characteristics apply to both the DTr1 and DTr2. 0.65 0.65 UMG8N 1.25 0.1Min. (2) Abbreviated symbol : G8 FMG8A (1) (5) (1) (4) 0.3 (5) R2 2.9 R2 ROHM : UMT5 EIAJ : SC-88A (5) R1=4.7kΩ R1 R2=47kΩ DTr1 1.1 (4) R1 DTr2 (4) 0.8 R2 (3) 0.95 0.95 1.9 (1) R1=4.7kΩ R1 R2=47kΩ DTr1 (3) R2 FMG8A (2) R1 DTr2 (2) 0.9 Each lead has same dimensions EMG8 / UMG8N (3) 0to0.1 zEquivalent circuit 0.7 0.15 2.1 1.6 zAbsolute maximum ratings (Ta = 25°C) 0.3to0.6 Symbol Limits Unit Supply voltage VCC 50 V Input voltage VIN Parameter Output current 30 −5 IO 100 IC (Max.) 100 150 (TOTAL) 0to0.1 0.15 2.8 Each lead has same dimensions ROHM : SMT5 EIAJ : SC-74A Abbreviated symbol : G8 V mA EMG8, UMG8N Power dissipation FMG8A Pd Junction temperature Tj 150 ˚C Storage temperature Tstg −55 to +150 ˚C mW 300 (TOTAL) ∗1 ∗2 ∗1 120mW per element must not be exceeded. ∗2 200mW per element must not be exceeded. Rev.A 1/2 EMG8 / UMG8N / FMG8A Transistors zElectrical characteristics (Ta = 25°C) Parameter Symbol Min. Typ. Max. VI (off) − − 0.5 VI (on) 1.3 − − VO (on) − 0.1 0.3 V Input voltage Output voltage V Conditions VCC=5V, IO=100µA VO=0.3V, IO=5mA IO=5mA, II=0.25mA II − − 1.8 mA IO (off) − − 0.5 µA VCC=50V, VI=0V GI 80 − − − VO=5V, IO=10mA Input current Output current Unit DC current gain VI=5V Transition frequency fT − 250 − MHz Input resistance R1 3.29 4.7 6.11 kΩ VCE=10V, IE=−5mA, f=100MHz − Resistance ratio R2/R1 8 10 12 − − ∗ ∗ Transition frequency of the device zPackaging specifications Package Type Taping Code T2R TR T148 Basic ordering unit (pieces) 8000 3000 3000 EMG8 UMG8N FMG8A zElectrical characteristic curves 100 10m VO=0.3V 10 5 2 Ta=−40˚C 25˚C 100˚C 1 500m 1m 500µ 200µ 50µ 20µ 10µ 1µ 0 2m 5m 10m 20m 50m100m 1 200 100 Ta=100˚C 25˚C −40˚C 50 20 10 5 5µ 2µ 500µ 1m Ta=100˚C 25˚C −40˚C 100µ 100m 100µ 200µ 2 0.5 1.0 1.5 2.0 2.5 INPUT VOLTAGE : VI (off) (V) Fig.1 Input voltage vs. output current (ON characteristics) OUTPTUT VOLTAGE : VO (on) (V) 2m 200m OUTPUT CURRENT : IO (A) VO=5V 500 DC CURRENT GAIN : GI OUTPUT CURRENT : Io (A) INPUT VOLTAGE : VI (on) (V) 20 1k VCC=5V 5m 50 Fig.2 Output current vs. input voltage (OFF characteristics) 3.0 1 100µ 200µ 500µ 1m 2m 5m 10m 20m 50m100m OUTPUT CURRENT : IO (A) Fig.3 DC current gain vs. output current lO/lI=20 500m 200m 100m Ta=100˚C 25˚C −40˚C 50m 20m 10m 5m 2m 1m 100µ 200µ 500µ 1m 2m 5m 10m 20m 50m100m OUTPUT CURRENT : IO (A) Fig.4 Output voltage vs. output current Rev.A 2/2 Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.1