Model A10A50X1A RoHS Compliant Chip Termination 10 Watts, 50Ω General Specifications Resistive Element Substrate Terminal Finish Operating Temperature Thick film Alumina Ceramic Thick film Silver -55 to +125°C (see chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications Features: • 10 Watts • Surface Mountable • Alumina Ceramic Resistance Value: Power: Frequency Range: V.S.W.R.: 50 ohms, ± 2% 10 Watts DC – 5.0 GHz 1.25:1 Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change without notice • Non-Nichrome Resistive Element • Low VSWR • 100% Tested • RoHS Compliant Outline Drawing A10A50X1A (097) Rev D Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model A10A50X1A RoHS Compliant Power Derating: Tape & Reel: Mounting Footprint and Procedure: A10A50X1A (097) Rev D USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.