DUP75 I sol at e d a n d U n r egulat ed 0. 75 WATT M o d u la r DC/DC Co n ve rte rs series Low Cost 0.75 Watt in SIP pkg Unregulated Outputs 750VDC Isolation Non-Conductive Case Unit measures 0.24”W x 0.77”L x 0.4”H Model Number Output Voltage Internal Filters Output mAmps Input Range SINGLE OUTPUT DUP75-05S05 5 VDC DUP75-12S05 DUP75-15S05 DUP75-24S05 DUP75-05S12 12 VDC DUP75-12S12 DUP75-15S12 DUP75-24S12 DUP75-05S15 15 VDC DUP75-12S15 DUP75-15S15 DUP75-24S15 150 150 150 150 62 62 62 62 50 50 50 50 4.5-5.5 VDC 10.8-13.2 VDC 13.5-16.5 VDC 21.6-26.4 VDC 4.5-5.5 VDC 10.8-13.2 VDC 13.5-16.5 VDC 21.6-26.4 VDC 4.5-5.5 VDC 10.8-13.2 VDC 13.5-16.5 VDC 21.6-26.4 VDC DUAL OUTPUT DUP75-05D05 +/-5 VDC DUP75-12D05 DUP75-15D05 DUP75-24D05 DUP75-05D12 +/-12 VDC DUP75-12D12 DUP75-15D12 DUP75-24D12 DUP75-05D15 +/-15 VDC DUP75-12D15 DUP75-15D15 DUP75-24D15 +/-75 +/-75 +/-75 +/-75 +/-30 +/-30 +/-30 +/-30 +/-25 +/-25 +/-25 +/-25 4.5-5.5 VDC 10.8-13.2 VDC 13.5-16.5 VDC 21.6-26.4 VDC 4.5-5.5 VDC 10.8-13.2 VDC 13.5-16.5 VDC 21.6-26.4 VDC 4.5-5.5 VDC 10.8-13.2 VDC 13.5-16.5 VDC 21.6-26.4 VDC WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DUP75 I sol at e d a n d U n r egulat ed 0. 75 WATT M o d u la r DC/DC Co n ve rte rs INPUT SPECIFICATIONS Input Voltage Ranges: ENVIRONMENTAL SPECIFICATIONS 5 VDC Nominal 12 VDC Nominal 15 VDC Nominal 24 VDC Nominal 4.5-5.5 VDC 10.8-13.2 VDC 13.5-16.5 VDC 21.6-26.4 VDC OUTPUT SPECIFICATIONS Voltage and Current Load Regulation 10% - FL Line Regulation Temperature Coefficient Ripple/Noise(Single/Dual) Voltage Stability Short Circuit Protection series See Selection Chart +/- 10% on 5V output +/- 6% on all others +/- 1.2%/1% of Vin +/-0.1%/DegC 50mV Pk-Pk, typ +/-5%, max 1 Second max Oper. Temperature Storage Temperature Maximum Case Temp MTBF -25 to +71 DegC(FL) -55 to +125 DegC * 110 DegC * 5.5 MHrs MIL-HDBK 217F TA=25C FL PHYSICAL SPECIFICATIONS Case Material Construction Non-Conductive Black Plastic Fully Encapsulated GENERAL SPECIFICATIONS Input-Out Isolation Efficiency Switching Frequency Isolation Resistance 750VDC 78%, typ 100Khz 10000 M Ohms All specifications are typical at nominal input, full load, and 25DegC unless otherwise noted * These are stress ratings. Exposure of the devices to any of these conditions may adversely affect long term reliability. Proper operation under conditions other than the standard operating conditions is neither warranteed nor implied. WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DUP75 I sol at e d a n d U n r egulat ed 0. 75 WATT M o d u la r DC/DC Co n ve rte rs series MECHANICAL DIMENSIONS 0.77(19.6) 0.016(0.4) FRONT VIEW 0.40(10.2) 0.01x 0.02 ( 0.25 x 0.5) Rectangular Pin 0.10(2.54) 0.14(3.6) 0.085(2.16) 0.24(6.1) 0.20(5.08) 1 BOTTOM VIEW 2 4 5 6 Pin # Single Outputs Dual Outputs 1 2 3 4 5 6 + Input - Input No Pin - Output NC + Output + Input - Input No Pin - Output Common + Output 0.053(1.35) 1. All dimensions in Inches (mm) Tolerance: x.xx±0.02(x.x±0.5) x.xxx±0.01(x.xx±0.25) 2. Pin pitch tolerance ±0.014(0.35) OUTPUT DERATING CURVE OUTPUT POWER (%) Natural convection 100 75 50 25 0 -40 -25 -10 0 50 60 70 80 90 100 AMBIENT TEMPERATURE (ºC) WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458