RoHS BR4005-4010 SINGLE-PHASE BRIDGE RECTIFIER D T ,. L FEATURES Low cost High forward surge current capability. Intergrally molded heatsink provide very low thermal resistan High temperature soldering guaranteed: 260/10 second, at 5 lbs. (2.3kg) tension. MECHANICAL DATA Case: Molded plastic body, suffix "N" for thinner type. Terminal: Plated 0.25" (6.35mm) lug. Polarity: Polarity symbols marked on case. Mounting: Thru hole for #10 screw, 20 in - lbs. Torque max Weight: 0.66ounce, 18.7gram(BR40) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load derate current by 20% Maximum Repetitive Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Output Current, at TC = 50 (Note1) Peak Forward Surge Current 8.3ms single half sine - wave superimposed on rated load (JEDEC method ) Rating for Fusing (t<8.3ms) Maximum Instantaneous Forward Voltage Drop per bridge element at 20A Maximum DC Reverse Current at rated TA = 25 DC blocking voltage per element TA Isolation Voltage from case to lugs Typical Thermal Resistance (Note 1, 2) Operating Temperature Range Storage Temperature Range J E R T W N SYMBOLS BR4005 BR401 BR402 BR404 BR406 BR408 BR4010 UNIT VRRM Volts VRMS Volts VDC Volts C E L E O IC C O I(AV) Amps IFSM Amps It 2 As VF Volts (-65 to +150) (-65 to +150) Amp mAmp VAC /W IR VISO RJC TJ TSTG 1. Unit Mounted on 9" X 3.5" X 4.6" (23 X 9 X 11.8cm) Al. finned plate. 2. Bolt down on heatsink with silicon thermal compound between bridge and mounting surface for maximum heat transfer efficiency with #10 screw. WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected] 2 RoHS BR4005-4010 FIG.1-DERATING CURVE FOR FORWARD SURGE CURRENT PER ELEMENT 700 (23 X 9 X 11.8cm) AL.Finned Plate Single Phase Half Wave 60Hz Inductive or Resistive 8.3ms Single Half Sine-Wave Tj (JEDEC Method) =T 500 CURRENT, (A) 9"X 3.5"X 4.6" Thick 15 600 PEAK FORWARD SURGE Heat Sink Mounting CURRENT,(A) AVERAGE FORWARD OUTPUT 35 25 1 Cycle 400 300 200 100 Load 0 1 0 25 0 50 75 100 D T ,. L O FIG.2-MAXIMUM NON-REPETITIVE PEAK OUTPUT RECTIFIED CURRENT 40 125 150 2 4 6 175 C 8 10 20 j max 40 60 100 NUMBER OF CYCLES AT 60 Hz CASE TEMPERATURE, ( ° C) FIG.4-TYPICAL REVERSE FIG.3-TYPICAL FORWARD CHARACTERISTICS IC 100 1.0 R T Tj =25 ° C Pulse Width=300uS 1%Duty Cycle 0.1 C E L 0.8 0.6 0.4 1.0 1.6 1.4 1.2 INSTANTANEOUS FORWARD VOLTAGE,(V) N O 10 (uA) INSTANTANEOUS REVERSE CURRENT, 10 (A) INSTANTANEOUS FORWARD CURRENT, 100 0.01 CHARACTERISTICS PER BRIDGE ELEMENT PER BRIDGE LEMENT 1.8 Tj =100 ° C 1.0 Tj =25 ° C 0.1 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE,(%) FIG.5-MAXIMUM POWER DISSIPATION AVERAGE POWER DISSIPATION OF BRIDGE, 100 W (W) J E 80 E Tj =T j max 60 Capacitive Load 40 Resistive or Inductive 20 Load 0 0 5 10 15 20 25 30 35 40 AVERAGE OUTPUT CURRENT, (A) WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected]