Philips Semiconductors Linear Products Product specification Dual general-purpose operational amplifier DESCRIPTION NE/SA/SE4558 PIN CONFIGURATIONS The 4558 is a dual operational amplifier that is internally compensated. Excellent channel separation allows the use of a dual device in a single amp application, providing the highest packaging density. The NE/SA/SE4558 is a pin-for-pin replacement for the RC/RM/RV4558. D and N Packages AOUT 1 AIN– 2 AIN+ 3 FEATURES V– 4 • 2MHz unity gain bandwidth guaranteed • Supply voltage ±22V for SE4558 and ±18V for NE4558 • Short-circuit protection • No frequency compensation required • No latch-up • Large common-mode and differential voltage ranges • Low power consumption A –+ B +– 8 V+ 7 BOUT 6 BIN– 5 BIN+ ORDERING INFORMATION TEMPERATURE RANGE ORDER CODE DWG # 8-Pin Plastic Small Outline (SO) Package DESCRIPTION 0 to +70°C NE4558D 0174C 8-Pin Plastic Dual In-Line Package (DIP) 0 to +70°C NE4558N 0404B 8-Pin Plastic Dual In-Line Package (DIP) -40 to +85°C SA4558N 0404B 8-Pin Plastic Dual In-Line Package (DIP) -40 to +85°C SA4558D 0404B 8-Pin Plastic Dual In-Line Package (DIP) -55 to +125°C SE4558N 0404B EQUIVALENT SCHEMATIC 8 v+ – OUYPUT 1(7) 2(6) INPUTS 3(5) + 4 V– August 31, 1994 65 853-0840 13721 Philips Semiconductors Linear Products Product specification Dual general-purpose operational amplifier NE/SA/SE4558 ABSOLUTE MAXIMUM RATINGS SYMBOL RATING UNIT SE4558 ±22 V NE4558, SA4558 ±18 V N package 1160 mW D package 780 mW Differential input voltage ±30 V VIN Input voltage2 ±15 V TSTG Storage temperature range -65 to +150 °C TA Operating ambient temperature range SE4558 -55 to +125 °C SA4558 -40 to +85 °C NE4558 0 to +70 °C 300 °C VCC PARAMETER Supply voltage PD MAX Maximum power dissipation, TA=25°C (Still air)1 TSOLD Lead soldering temperature (10sec max) Output short-circuit duration3 Indefinite NOTES: 1. Derate above 25°C at the following rates: N package at 9.3mW/°C D package at 6.2mW/°C 2. For supply voltages less than ±15V, the absolute maximum input voltage is equal to the supply voltage. 3. Short-circuit may be to ground on one amp only. Rating applies to +125°C case temperature or +75°C ambient temperature for NE4558 and to +85°C ambient temperature for SA4558. DC ELECTRICAL CHARACTERISTICS VCC=+15V, TA= 25°C unless otherwise specified. SYMBOL VOS PARAMETER Input offset voltage ∆VOS/∆T IOS AV RS≤10kΩ Over temp. Output voltage swing Over temp. 40 Typ Max 5.0 2.0 6.0 200 30 200 20 500 200 mV µV/°C 4 40 UNIT nA pA/°C 500 nA 40 pA/°C 0.3 1.0 0.3 1.0 MΩ RL≥2kΩ VOUT=±10V 50,00 0 300,0 00 20,00 0 300,0 00 V/V RL≥10kΩ RL≥2kΩ ±12 ±10 ±14 ±13 ±12 ±10 ±14 ±13 V V ±12 ±13 ±12 ±13 V 70 100 70 100 dB Input voltage range CMRR Common-mode rejection ratio RS≤10kΩ PSRR Power supply rejection ratio RS≤10kΩ ISC Short-circuit current August 31, 1994 1.0 Min 20 Over temp. VIN Power consumption (all amplifiers) Max 4 Input resistance Large-signal voltage gain SA/NE4558 Typ 50 Input bias current ∆IB/∆T RIN SE4558 Min Input offset current ∆IOS/∆T IBIAS TEST CONDITIONS 5 RL=∞ 66 10 150 25 60 120 170 5 µV/V 10 150 25 60 mA 120 170 mW Philips Semiconductors Linear Products Product specification Dual general-purpose operational amplifier NE/SA/SE4558 DC ELECTRICAL CHARACTERISTICS (Continued) SYMBOL PARAMETER Transient response (unity gain) tR SR TEST CONDITIONS SE4558 Min Typ SA/NE4558 Max Min Typ Max UNIT VIN=20mV RL=2kΩ CL≤100pF Rise time 100 100 Overshoot 15.0 15.0 ns % Slew rate (unity gain) RL≥2kΩ 1.0 1.0 V/µs Channel separation (gain=100) f=10kHz RS=1kΩ 90 90 dB 3.0 MHz 45 45 Degree 25 25 nV/√H z GBW Unity gain bandwidth (gain=1) θM Phase margin VNOISE Input noise voltage 2.0 f=1kΩ 3.0 2.0 NOTE: The following specifications apply over operating temperature range. VOS Input offset voltage IOS Input offset current IBIAS Input bias current AV Large-signal voltage gain PC RS≤10kΩ 7.5 mV 300/5001 nA 800/1500 1500 RL≥2kΩ VOUT=±10V 25,000 Output voltage swing RL≥2kΩ ±10 Power consumption TA=HIGH TA=LOW 67 1 15,000 150 200 nA V/V ±10 105 125 NOTES: 1. SA4558 only. August 31, 1994 6.0 500 V 115 120 150 200 mW mW Philips Semiconductors Linear Products Product specification Dual general-purpose operational amplifier NE/SA/SE4558 TYPICAL PERFORMANCE CURVES Input Bias as a Function of Ambient Temperature Input Offset Current as as a Function of Ambient Temperature 80 60 40 20 –15 VS = + 15V 15 10 5 0 0 0 10 20 30 40 50 0 60 70 10 20 30 40 50 Open–Loop Voltage Gain as a Function of Frequency –5 0 5 10 15 60 70 4 TEMPERATURE (oC) TEMPERATURE (oC) POWER CONSUMPTION (mV) VOLTAGE GAIN 20 RL = 2KΩ 600K 400K 200K 0 –20 1 0 Typical Output Voltage as a Function of Supply Voltage –5 –10 RL = 2KΩ 6 8 10 12 14 16 SUPPLY VOLTAGE (V) August 31, 1994 20 30 40 50 60 120 110 100 90 70 0 18 40 26 36 24 22 32 28 TA = 25oC 18 16 VS = + 15V 14 12 10 8 0.1 0.2 0.5 1.0 2.0 5.0 LOAD RESISTANCE (KΩ)) 68 40 50 60 70 Output Voltage Swing as a Function of Frequency 28 20 10 20 30 TEMPERATURE (oC) PEAK TO PEAK 0 4 10 10 OUTPUT SWING (V) 5 PEAK TO PEAK 10 OUTPUT SWING (V) OUTPUT SWING (V) TA = 25oC –15 130 Output Voltage Swing as a Function of Load Resistance) 15 18 140 TEMPERATURE (oC) FREQUENCY (Hz) ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ 14 16 80 0K 10 100 1K 10K 100K1K 10M 10 12 Power Consumption as a Function of Ambient Temperature V = + 15V VS S = + 15V 40 8 SUPPLY VOLTAGE (V) 800K 100 60 6 Open–Loop Gain as a Function of Temperature 120 80 TA = 25oC –10 20 COMMON MODE VOLTAGE RANGE (V) INPUT offset current ( µ A) INPUT BIAS CURRENT (µ A) VS = + 15V VOLTAGE GAIN (dB) Common–Mode Range as a Function of Supply Voltage 25 100 ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇ 24 20 18 12 8 4 0 100 VS = + 15V TA = 25oC RL = 25KΩ 1K 10K 100K FREQUENCY (Hz) 1M Philips Semiconductors Linear Products Product specification Dual general-purpose operational amplifier NE/SA/SE4558 TYPICAL PERFORMANCE CURVES (Continued) Quiescent Current as a Function of Supply Voltage Transient Response 6 28 TA = 25oC 5 4 3 2 OUTPUT VOLTAGE 24 OUTPUT (mV) QUIESCENT CURRENT (mA) Voltage–Follower Large–Signal Pulse Response 20 90% 16 12 VS = + 15V TA = 25oC RS = 2KΩ CL = 100pF 8 4 10% RISE TIME 1 0 0 0 3 6 9 12 15 0 18 .25 SUPPLY VOLTAGE (V) .50 .75 1.0 TA = 25oC RS = 50Ω AV = 60dB 100 10 30 40 VS = + 15V T = 25oC 10 RS = 100K AV = 60dB 1 0.1 10 100 1K 10K 1 100K 10 100 TOTAL HARMONIC DISTROTION ON (2) 1kHz (%) 120 100 80 60 VS = + 15V TA = 25oC 100 1K FREQUENCY (Hz) 10K 100k 6 VS = + 15V RL = 2KΩ AV = 40dB = 1kHz RS = 1KΩ 5 4 3 2 1 0 1 2 3 4 5 6 7 8 VO OUTPUT VOLTAGE (VRMS) 69 9 10 TOTAL HARMONIC DISTORATION (%) Total Harmonic Distortion vs Output Voltage 140 1K 10K 100K FREQUENCY (Hz) Channel Separation CHANNEL SEPARATION (dB) 20 100 FREQUENCY (Hz) August 31, 1994 0 5 10 TIME (µS) NOISE CURRENT (PA√ Hz) NOISE CURRENT (nV√ Hz) VS = + 15V 1 10 –6 –8 Input Noise Current as a Function of Frequency 1 0 –4 TIME (µS) 1000 20 VS = + 15V TA = 25oC 2 0 –2 –10 1.25 Input Noise Voltage as a Function of Frequency 40 10 8 6 4 Distortion vs Frequency VO = 1VRMS 7 6 5 V10S = +30V RIAA COMPENSATION 4 3 2 1 0 0 100 1K FREQUENCY (Hz) 10K 100K