SUBMINIATURE SOLID STATE LAMP ATTENTION AM2520MBCK03 BLUE OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Description Features SUBMINIA TURE PACKAGE. The Blue source color devices are made with GaN WIDE VIEWING ANGLE. on SiC Light Emitting Diode. GULL WING LEAD. Static electricity and surge damage the LEDS. LONG LIFE - SOLID STATE RELIABILITY. It is recommended to use a wrist band or LOW PACKAGE PROFILE. anti-electrostatic glove when handling the LEDs. PACKAGE : 1000PCS / REEL. All devices, equipment and machinery must be electrically grounded. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1262 REV NO: V.3 DATE: MAR/07/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1202000525 Selection Guide Part No. Dice AM2520MBCK03 Iv (mcd) @ 20mA Lens Type BLUE (GaN) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 10 30 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Blue λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 430 nm IF=20mA Blue 466 nm IF=20mA Spectral Line Half-width Blue 60 nm IF=20mA C Capacitance Blue 100 pF VF=0V;f=1MHz VF Forward Voltage Blue 4.0 5.2 V IF=20mA IR Reverse Current Blue 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Blue Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1262 REV NO: V.3 DATE: MAR/07/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1202000525 Blue AM2520MBCK03 SPEC NO: DSAD1262 REV NO: V.3 DATE: MAR/07/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1202000525 AM2520MBCK03 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength) , the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1262 REV NO: V.3 DATE: MAR/07/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1202000525