MUR405G THUR MUR460G R SUPER FAST RECTIFIER Reverse Voltage: 50 to 600 Volts Forward Current:4.0Amperes S E M I C O N D U C T O R DO-201AD FEATURES Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Low forward voltage drop High current capability, High reliability Low power loss, high efficiency High surge current capability High speed switching, Low leakage High temperature soldering guaranteed:260℃/10 seconds at terminals Component in accordance to RoHS 2011/65/EU 1.0(25.4) MIN 0.220(5.6) 0.190(4.8) DIA 0.375(9.50) 0.285(7.20) MECHANICAL DATA Case: JEDEC DO-201AD molded plastic body 1.0(25.4) MIN Epoxy: UL94V-0 rate flame retardant Lead: Plated axial leads, solderable per MIL-STD-750,method 2026 0.052(1.32) 0.045(1.14) DIA Polarity: Color band denotes cathode end Mounting Position: Any Weight: 0.042ounce, 1.19 grams Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (Rating at 25℃ ambient temperature unless otMURwise specified. Single phase ,half wave ,60HZ,resistive or inductive load. For capacitive load, derate current by 20%.) Symbols Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage VRRM VRMS VDC MUR 405G MUR 410G MUR 420G MUR 430G MUR 440G MUR 450G MUR 460G 50 100 200 300 400 500 600 35 70 140 210 280 350 420 50 100 200 300 400 500 600 Units Volts Volts Volts Maximum Average Forward Rectified Current 0.375"(9.5mm)lead length I(AV) 4.0 AmpS Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) IFSM 150 Amps Maximum Instantaneous Forward Voltage at 4.0 A Maximum DC Reverse Current at rated DC blocking voltage VF 1.0 1.28 TA=25°C 10.0 IR A TA=100°C Maximum reverse recovery time(Note1) Typical junction capacitance(Note2) Operating junction and storage temperature range Volts 50 Trr CJ 45 60 80 TJ TSTG -55 to+150 -55 to+150 ns PF °C Note: 1.Test conditions: IF=0.5A,IR=1.0A,IRR=0.25A. 2.Measured at 1MHZ and applied reverse voltage of 4.0 Volts. JINAN JINGHENG ELECTRONICS CO., LTD. 2-1 HTTP://WWW.JINGHENGGROUP.COM RATINGS AND CHARACTERISTIC CURVES MUR405G THRU MUR460G FIG.2-TYPICAL FORWARD CURRENT DERATING CURVE 50 NONINDUCTIVE (＋) 50Vdc (APPROX) 10 NONINDUCTIVE Trr +0.5A 1 NONINDUCTIVE 0 PULSE GENERATOR (NOTE2) D.U.T. (－) AVERAGE FORWARD CURRENT (A) FIG.1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC -0.25A OSCILLOSCOPE (NOTE1) -1.0A NOTES:1.Rise Time=7ns max. input impedance=1 megohm 22pF 2.Rise Time=10ns max. source impedance= 50 ohms 1cm 6.0 5.0 4.0 3.0 2.0 SINGLE PHASE HALF WAVE 60HZ RESISTIVE OR INDUCTIVE LOAD 0.375"(9.5mm)LEAD LENGTH 1.0 0 0 SET TIME BASE FOR 50/100 ns/cm 25 50 75 100 125 150 175 LEAD TEMPERATURE ( ℃) FIG.4-TYPICAL REVERSE CHARACTERISTICS 1000 100 INSTANTANEOUS REVERSE CURRENT ( A) INSTANTANEOUS FORWARD CURRENT( AMPERES) FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 50\100\200\300V 10 400\500V 1 600V TJ=25°C 0.1 100 TJ=150°C 10 TJ=100°C 1.0 TJ=25°C 0.1 Pulse Width=300μs 1% Duty Cycle 0.01 0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 0.01 INSTANTANEOUS FORWARD VOLTAGE (VOLTS) 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE(%) FIG.5-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT FIG.6-TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE(pF) PEAK FORWARD SURGE CURRENT(AMPERES) 300 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) 200 100 200 100 60 40 20 10 6 4 1 0 1 5 10 50 100 TJ=25℃ 2 0.1 0.2 0.4 1 2 4 10 20 40 REVERSE VOLTAGE. (V) NUMBER OF CYCLES AT 60Hz JINAN JINGHENG ELECTRONICS CO., LTD. 2-2 HTTP://WWW.JINGHENGGROUP.COM 100