UTC DTD114EG-AL3-R Npn digital transistor (built- in bias resistors) Datasheet

UNISONIC TECHNOLOGIES CO., LTD
DTD114E
NPN SILICON TRANSISTOR
NPN DIGITAL TRANSISTOR
(BUILT- IN BIAS RESISTORS)
„
FEATURES
* Built-in bias resistors that implies easy ON/OFF applications.
* The bias resistors are thin-film resistors with complete isolation to
allow negative input.
„
EQUIVALENT CIRCUIT
„
ORDERING INFORMATION
Ordering Number
Lead Free
Halogen Free
DTD114EL-AE3-R
DTD114EG-AE3-R
DTD114EL-AL3-R
DTD114EG-AL3-R
„
Package
SOT-23
SOT-323
Pin Assignment
1
2
3
G
I
O
G
I
O
Packing
Tape Reel
Tape Reel
MARKING
www.unisonic.com.tw
Copyright © 2011 Unisonic Technologies Co., Ltd
1 of 3
QW-R206-043,C
DTD114E
„
NPN SILICON TRANSISTOR
ABSOLUTE MAXIMUM RATINGS (Ta=25°C)
PARAMETER
SYMBOL
RATING
UNIT
Supply Voltage
VCC
50
V
Input Voltage
VIN
-10~+40
V
Output Current
IOUT
500
mA
Power Dissipation
PD
200
mW
Junction Temperature
TJ
150
°C
Storage Temperature
TSTG
-40 ~ +150
°C
Note Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
„
ELECTRICAL SPECIFICATIONS (Ta=25°C, unless others specified)
PARAMETER
SYMBOL
VIN(OFF)
Input Voltage
VIN(ON)
Output Voltage
VOUT(ON)
Input Current
IIN
Output Current
IOUT(OFF)
DC Current Gain
hFE
Input Resistance
R1
Resistance Ratio
R2/R1
Transition Frequency
fT
*Transition frequency of the device
TEST CONDITIONS
VCC =5V, IOUT =100μA
VOUT =0.3V, IOUT =10mA
IOUT/IIN =50mA/2.5mA
VIN=5V
VCC =50V, VIN =0V
VOUT =5V, IOUT =50mA
VCE =10V, IE =−50mA, f=100MHz
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
MIN
TYP
MAX
0.5
UNIT
0.1
0.3
0.88
0.5
V
mA
μA
10
1
200
13
1.2
kΩ
3
56
7
0.8
V
MHz
2 of 3
QW-R206-043,C
DTD114E
NPN SILICON TRANSISTOR
DC Current Gain, hFE
Output Voltage, VOUT(ON) (mV)
TYPICAL CHARACTERISTICS
„
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
3 of 3
QW-R206-043,C
Similar pages