September 23, 2009 SHIELDED SMD INDUCTOR DR358-6 SERIES Features Low Profile Surface Mount Design Flat Top for Pick and Place Inductance Range from 3.3µH to 100.0µH Operating Temp. -20°C to +80°C Tinned Leads with Leaded Solder is Available (note 7) ELECTRICAL SPECIFICATIONS AT 25ºC Part No. DR358-6-332 DR358-6-502 DR358-6-622 DR358-6-742 DR358-6-872 DR358-6-103 DR358-6-123 DR358-6-153 DR358-6-183 DR358-6-223 DR358-6-273 DR358-6-333 DR358-6-393 DR358-6-473 DR358-6-563 DR358-6-683 DR358-6-823 DR358-6-104 Inductance (H) 30% 3.3 5.0 6.2 7.4 8.7 10.0 12.0 15.0 18.0 22.0 27.0 33.0 39.0 47.0 56.0 68.0 82.0 100.0 DCR () Max. 0.020 0.024 0.030 0.033 0.034 0.038 0.053 0.057 0.092 0.096 0.109 0.124 0.138 0.155 0.202 0.234 0.324 0.358 I rated (A) Max. 3.50 2.90 2.40 2.30 2.20 2.00 1.70 1.60 1.50 1.30 1.20 1.10 1.00 0.95 0.85 0.75 0.70 0.65 MECHANICAL OUTLINES Notes: 1. All dimensions are shown in millimeter “mm” 2. General tolerance 0.2mm, unless other specified 3. Inductance Test: 100kHz, 0.1Vrms 4. Irated for an approximate 40C temperature rise 5. Irated for an approximate 35% drop maximum of the initial value 6. Tape and reel quantity, 1000 pcs/reel 7. For non-RoHS part replace DR prefix with 42- (e.g. DR358-6 becomes 42-358-6) 8. Terminal finish is compliant to RoHS requirements. Solder in accordance with J-STD-020D DATATRONIC: 28151 Highway 74, Romoland, CA 92585 Tel: 951-928-7700 Fax: 951-928-7701 Email: [email protected] 499 King’s Road, Hong Kong Tel: (852) 2562 3858, (852) 2564 8477 Fax: (852) 2565 7214, (852) 2563 1290 All specifications are subject to change without notice.