NTE NEVH3.3M160 Aluminum electrolytic 160v to 450v Datasheet

ALUMINUM ELECTROLYTIC 160V to 450V
NEVH, NEHH SERIES
SUBMINIATURE HIGH VOLTAGE
(NEVH: Radial Lead, NEHH: Axial Leads)
The NEVH and NEHH series subminiature aluminum electrolytic
capacitors are ideal for polarized capacitor applications requiring
small size, high capacitance, high voltage, low cost, and dependability over broad temperature ranges.
RATINGS
Capacitance Range: 1.0µf to 470µf
Tolerance: - 10%, +75%
Voltage Range: 160V to 450V
PERFORMANCE SPECIFICATIONS
Operating Temperature Range:
• For 160V and 250V:
- 40°C to +85°C ( - 40°F to +185°F)
• For 350V and 450V:
- 25°C to +85°C ( - 13°F to +185°F)
Leakage Current: I ≤ 0.02CV + 100µA (measured after
3 minutes of applied voltage)
I = Leakage Current (µA)
C = Nominal Capacitance (µf)
V = Rated Voltage (V)
Capacitance Tolerance (M): at +20°C (+68°F), 120HZ
Capacitance Values through 4.7µf - 10% to +75%
Capacitance Values above 4.7µf
- 10% to +50%
Dissipation Factor: at +20°C (+68°F),120HZ
Rated Voltage
160, 250, and 350
450
0.20
0.25
1.0µf to 470µf
MECHANICAL SPECIFICATIONS
Lead Solderability:
Meets the requirements of MIL - STD 202, Method 208
Marking:
Consists of series type, nominal capacitance, rated
voltage, temperature range, anode and/or cathode
identification, vendor identification.
Recommended Cleaning Solvents:
Methanol, isopropanol ethanol, isobutanol, petroleum
ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon
(MF, TF, or TC), trichloroethylene, trichloroethane, or
methylchloride are not recommended as they may
damage the capacitor.
CASE SIZE AND DIMENSIONS:
NEVH SERIES
Insulating
Sleeve
18.0 Min
A ±0.5
dØ
DØ
L
L’
D’ Ø = D Ø + 0.5 Max
5.0 Min
D’ Ø
L’ = L + 1.0 Max at D Ø ≤ 8.0
L’ = L + 2.0 Max at D Ø ≥ 10.0
Impedance Ratio at Low Temperature: 120HZ
Comparison Z
160 - 250
350
450
Z @ - 25°C ( - 13°F)/
Z @ +20°C (+68°F)
WV
2
2
2
Z @ - 40°C ( - 40°F)/
Z @ +20°C (+68°F)
4
-
-
NEHH SERIES (Insulating Bar = Negative)
L
Insulating
Sleeve
dØ
Surge Voltage:
DC Rated Voltage
160
250
350
450
Surge Voltage
200
300
400
500
2.3 Max
Load Life: 1000 ±12Hrs @ +85°C (+185°F),
at rated voltage
Leakage Current: Within values specified above
Dissipation Factor: Within ±200% of specified value
Capacitance Change Max: See Table
Rated Voltage
160V to 450V
DØ
35.0 Min
D’ Ø = D Ø + 0.5 Max
L’
35.0 Min
L’ = L + 1.0 Max at D Ø ≤ 8.0
D’ Ø
L’ = L + 2.0 Max at D Ø ≥ 10.0
Capacitance Change Max
Within 20% of the initial value
Shelf Life: 1000 Hrs @ +85°C (+185°F),
no voltage applied
Leakage Current: Within ±200% of specified value
Dissipation Factor: Within ±150% of specified value
Capacitance Change Max: Within ±20% of initial value
ORDERING INFORMATION
NEVH
47
M
160
Series
Capacitance
Tolerance
Voltage
NTE Electronics, Inc. D Voice (800) 631 - 1250 (973) 748 - 5089 D FAX (973) 748 - 6224 D http://www.nteinc.com
5
ALUMINUM ELECTROLYTIC 160V to 450V
NEVH, NEHH SERIES
NEVH Series (Radial Type) Dimensions: Diameter (D Ø) x Length (L): mm
WV
160
250
1.0
6.3 x 11
6.3 x 11
2.2
6.3 x 11
Cap (µf)
350
450
8 x 11.5
8 x 11.5
10 x 12.5
10 x 12.5
10 x 16
3.3
8 x 11.5
10 x 12.5
10 x 16
10 x 20
4.7
8 x 11.5
10 x 12.5
10 x 16
13 x 20
10
10 x 12.5
10 x 20
13 x 21
13 x 25
22
10 x 20
13 x 25
13 x 25
16 x 31.5
33
13 x 21
13 x 25
16 x 31.5
18 x 35.5
47
13 x 25
16 x 25
18 x 36
22 x 35
100
16 x 25
18 x 36
22 x 35
25 x 40
220
18 x 35
330
22 x 35
470
22 x 40
* These dimensions are for reference only, please consult the factory for actual size.
NEVH Series (Radial Type) Mechanical Specifications: mm
Outside Diameter (D Ø)
6.3
8
10
13
16
18
22
25
Lead Spacing (A)
2.5
3.5
5
5
7.5
7.5
10
12.5
Lead Diameter (d Ø)
0.5
0.6
0.6
0.6
0.8
0.8
0.8
1.0
* These dimensions are for reference only, please consult the factory for actual size.
NEHH Series (Axial Type) Dimensions: Diameter (D Ø) x Length (L): mm
WV
160
Cap (µf)
250
350
450
1.0
6.3 x 16
8 x 16
8 x 16
10 x 20
2.2
8 x 16
8 x 20
10 x 20
10 x 20
3.3
8 x 16
10 x 20
10 x 20
10 x 20
4.7
8 x 20
10 x 20
10 x 20
13 x 25
10
10 x 25
10 x 20
13 x 25
13 x 30
22
10 x 20
13 x 25
13 x 30
16 x 30
33
13 x 25
13 x 30
16 x 30
16 x 40
47
13 x 30
16 x 30
16 x 40
16 x 40
100
16 x 30
16 x 40
18 x 40
22 x 40
220
22 x 40
330
25 x 52
470
22 x 52
* These dimensions are for reference only, please consult the factory for actual size.
NEHH Series (Axial Type) Mechanical Specifications: mm
Outside Diameter (D Ø)
6.3
8
10
13
16
18
22
25
Lead Diameter (d Ø)
0.6
0.6
0.6
0.8
0.8
0.8
0.8
0.8
* These dimensions are for reference only, please consult the factory for actual size.
6
NTE Electronics, Inc. D Voice (800) 631 - 1250 (973) 748 - 5089 D FAX (973) 748 - 6224 D http://www.nteinc.com
Similar pages