1.6X0.8mm SMD CHIP LED LAMP AP1608SURC HYPER RED Features Description •1.6mmX0.8mm SMT LED, 1.1mm THICKNESS. The Hyper Red source color devices are made •LOW POWER CONSUMPTION. with DH InGaAlP on GaAs substrate Light Emitting •W IDE VIEW ING ANGLE. Diode. •IDEAL FOR BACKLIGHT AND INDICATOR. •VARIOUS COLORS AND LENS TYPES AVAILABLE. •PACKAGE: 2000PCS / REEL . •RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAD0917 REV NO: V.3 DATE: MAR/10/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000073 Selection Guide Part No. Dice HYPER RED (InGaAlP) AP1608SURC Iv (mcd) @ 20mA Lens Type Viewing Angle Min. Typ. 2θ θ1/2 70 200 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 628 nm IF=20mA Spectral Line Half-width Hyper Red 27 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD0917 REV NO: V.3 DATE: MAR/10/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000073 Hyper Red AP1608SURC SPEC NO: DSAD0917 REV NO: V.3 DATE: MAR/10/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000073 AP1608SURC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength) , the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD0917 REV NO: V.3 DATE: MAR/10/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203000073