Document 232 DW3316 Coupled Inductors for xDSL • Coupled inductor optimized for xDSL filtering applications • Can be used as a common mode choke, 1:1 transformer or in SEPIC applications Core material Ferrite Terminations RoHS compliant gold over nickel over phos bronze. Other terminations available at additional cost. Weight 1.13 – 1.34 g Ambient temperature –40°C to +85°C Storage temperature Component: –40°C to +85°C. Tape and reel packaging: –40°C to +80°C Resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) 38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332 Packaging 750 per 13″ reel Plastic tape: 24 mm wide, 0.36 mm thick, 16 mm pocket spacing, 5.5 mm pocket depth PCB washing Tested to MIL-STD-202 Method 215 plus an additional aqueous wash. See Doc787_PCB_Washing.pdf. Inductance2 DCR ±20% max Part number1 (mH) (Ohms) DW3316-155ML_ 1.5 10.8 DW3316-275ML_ 2.7 18.0 DW3316-335ML_ 3.3 20.0 DW3316-395ML_ 3.9 23.0 DW3316-475ML_ 4.7 26.0 DW3316-685ML_ 6.8 42.0 Color dot 2 -123 1 SRF3 typ (MHz) 1.70 1.25 1.10 0.968 0.850 0.690 1. When ordering, please specify termination and packaging codes: Isat4 (mA) 300 230 180 160 160 150 1 4 2 3 4 0.100 0.290 0.400 max 2,54 7,37 10,16 3 Schematic DW3316-685MLD Termination: L = Gold over nickel over phos bronze terminations Special order: T = RoHS tin-silver-copper (95.5/4/0.5) or S = non-RoHS tin-lead (63/37). Packaging: D = 13″ machine-ready reel. EIA-481 embossed plastic tape (750 parts per full reel). B = Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter C instead. 2. Inductance is per winding, tested at 10 kHz, 0.1 Vrms, 0 Adc using an Agilent/HP 4263B LCR meter or equivalent. 3. SRF is measured using an Agilent/HP 8753D network analyzer. 4. DC current at which the inductance drops 10% (typ) from its value without current. 5. Electrical specifications at 25°C. Refer to Doc 362 “Soldering Surface Mount Components” before soldering. 0.515 max 13,08 0.395 10,03 0.330 dia 8,38 0.185 4,70 0.200 max 5,08 0.100 2,54 0.490 12,45 Dimensions are in 0.115 2,92 0.110 2,79 Recommended Land Pattern inches mm Document 232 Revised 02/25/15