ER1A THRU ER1J SURFACE MOUNT SUPERFAST RECTIFIER VOLTAGE - 50 to 600 Volts CURRENT - 1.0 Ampere FEATURES SMB/DO-214AA l For surface mounted applications l Low profile package l Built-in strain relief l Easy pick and place l Superfast recovery times for high efficiency l Plastic package has Underwriters Laboratory Flammability Classification 94V-O l Glass passivated junction l High temperature soldering: 260 /10 seconds at terminals MECHANICAL DATA Case: JEDEC DO-214AA molded plastic Terminals: Solder plated, solderable per MIL-STD-750, Method 2026 Polarity: Indicated by cathode band Standard packaging: 12mm tape (EIA-481) Weight: 0.003 ounce, 0.093 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current, at TL=100 Peak Forward Surge Current 8.3ms single half sinewave superimposed on rated load(JEDEC method) Maximum Instantaneous Forward Voltage at 1.0A Maximum DC Reverse Current TA=25 At Rated DC Blocking Voltage TA=100 Maximum Reverse Recovery Time (Note 1) Typical Junction capacitance (Note 2) Typical Thermal Resistance (Note 3) Operating and Storage Temperature Range SYMBOLS ER1A ER1B ER1C ER1D ER1E ER1G ER1J UNITS 50 100 150 200 300 400 600 Volts VRRM 35 70 105 140 210 280 420 Volts VRMS 50 100 150 200 300 400 600 Volts VDC I(AV) 1.0 Amps IFSM 30.0 Amps VF IR TRR CJ R JL TJ,TSTG NOTES: 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, Irr=0.25A 0.95 1.25 5.0 100 35.0 10.0 34 -50 to +150 1.7 Volts A nS PF /W 2. Measured at 1 MHz and Applied reverse voltage of 4.0 volts 3. 8.0mm2 (.013mm thick) land areas RATING AND CHARACTERISTIC CURVES ER1A THRU ER1J Fig. 1-REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM ER1A THRU ER1J Fig. 3-TYPICAL REVERSE CHARACTERISTICS Fig. 2-MAXIMUM AVERAGE FORWARD CURRENT RATING Fig. 4-TYPICAL FORWARD CHARACTERISTICS Fig. 5-MAXIMUM NON-REPETITIVE SURGE CURRENT Fig. 6-TYPICAL JUNCTION CAPACITANCE