2-Phase, High Speed CCD Driver Features General Description # # # # # # # The EL7182C is extremely well suited for driving CCD’s, especially where high contrast imaging is desirable. The 16V supply rating is attractive for higher voltage CCD applications, as in color fax machines. The input is TTL and 3V compatible. The low quiescent current requirement is advantageous in portable/ battery powered systems. The EL7182 is available in 8-pin P-DIP and 8-lead SO packages. 3V and 5V Input compatible Clocking speeds up to 10 MHz Reduced clock skew 20 ns Switching/delay time 2A Peak drive Low quiescent current Wide operating voltageÐ 4.5V – 16V EL7182C EL7182C Connection Diagram EL7182C Applications # CCD Drivers requiring highcontrast imaging # Differential line drivers # Push-pull circuits Ordering Information Part No. Temp. Range Pkg. Outline Ý 7182 – 1 EL7182CN b 40§ C to a 85§ C 8-Pin P-DIP MDP0031 EL7182CS b 40§ C to a 85§ C 8-Pin SO MDP0027 Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a ‘‘controlled document’’. Current revisions, if any, to these specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation. © 1994 Elantec, Inc. January 1996 Rev. B Manufactured under U.S. Patent Nos. 5,334,883, Ý5,341,047 EL7182C 2-Phase, High Speed CCD Driver Absolute Maximum Ratings Supply (V a to Gnd) Input Pins Combined Peak Output Current Storage Temperature Range Ambient Operating Temperature 125§ C Operating Junction Temperature Power Dissipation SOIC PDIP 16.5V b 0.3V to a 0.3V above V a 4A b 65§ C to a 150§ C b 40§ C to a 85§ C 570 mW 1050 mW Important Note: All parameters having Min/Max specifications are guaranteed. The Test Level column indicates the specific device testing actually performed during production and Quality inspection. Elantec performs most electrical tests using modern high-speed automatic test equipment, specifically the LTX77 Series system. Unless otherwise noted, all tests are pulsed tests, therefore TJ e TC e TA. Test Level I II III IV V Test Procedure 100% production tested and QA sample tested per QA test plan QCX0002. 100% production tested at TA e 25§ C and QA sample tested at TA e 25§ C , TMAX and TMIN per QA test plan QCX0002. QA sample tested per QA test plan QCX0002. Parameter is guaranteed (but not tested) by Design and Characterization Data. Parameter is typical value at TA e 25§ C for information purposes only. DC Electrical Characteristics TA e 25§ C, V e 15V unless otherwise specified Parameter Description Test Conditions Min Typ Test Level Units I V 10 I mA 0.8 I V Max Input VIH Logic ‘‘1’’ Input Voltage IIH Logic ‘‘1’’ Input Current VIL Logic ‘‘0’’ Input Voltage IIL Logic ‘‘0’’ Input Current VHVS Input Hysteresis 2.4 @Va 0.1 @ 0V 0.1 10 0.3 I mA V V ROH Pull-Up Resistance IOUT e b100 mA 3 6 I X ROL Pull-Down Resistance IOUT e a 100 mA 4 6 I X IPK Peak Output Current Source Sink 2 2 IV A IDC Continuous Output Current Source/Sink I mA IS Power Supply Current Input High 5 I mA VS Operating Voltage 16 I V 100 Power Supply 2.5 4.5 2 TD is 3.1in Output EL7182C 2-Phase, High Speed CCD Driver AC Electrical Characteristics TA e 25§ C, V e 15V unless otherwise specified Parameter Description Test Conditions Min Typ Max CL e 500 pF CL e 1000 pF 7.5 10 20 CL e 500 pF CL e 1000 pF 10 13 20 Test Level Units IV ns IV ns tR tF Rise Time Fall Time tD-ON Turn-On Delay Time 18 25 IV ns tD-OFF Turn-Off Delay Time 20 25 IV ns Timing Table Standard Test Configuration 7182 – 3 7182 – 2 Simplified Schematic 7182 – 17 3 TD is 1.5in Switching Characteristics EL7182C 2-Phase, High Speed CCD Driver Typical Performance Curve Max Power/Derating Curves Switch Threshold vs Supply Voltage 7182 – 15 7182 – 4 Input Current vs Voltage Peak Drive vs Supply Voltage 7182 – 5 7182 – 6 Quiescent Supply Current ‘‘ON’’ Resistance vs Supply Voltage CASE: Input Level Curve GND B Va D 7182 – 16 7182 – 7 4 EL7182C 2-Phase, High Speed CCD Driver Typical Performance Curve Ð Contd. Average Supply Current vs Voltage and Frequency Average Supply Current vs Capacitive Load 7182 – 8 7182 – 9 Rise/Fall Time vs Load Rise/Fall Time vs Supply Voltage 7182 – 10 7182 – 14 5 EL7182C 2-Phase, High Speed CCD Driver Typical Performance Curve Ð Contd. Rise/Fall Time vs Temperature Propagation Delay vs Supply Voltage 7182 – 12 7182 – 11 Delay Time vs Temperature 7182 – 13 6 7 BLANK EL7182C EL7182C 2-Phase, High Speed CCD Driver General Disclaimer Specifications contained in this data sheet are in effect as of the publication date shown. Elantec, Inc. reserves the right to make changes in the circuitry or specifications contained herein at any time without notice. Elantec, Inc. assumes no responsibility for the use of any circuits described herein and makes no representations that they are free from patent infringement. January 1996 Rev. B WARNING Ð Life Support Policy Elantec, Inc. products are not authorized for and should not be used within Life Support Systems without the specific written consent of Elantec, Inc. Life Support systems are equipment intended to support or sustain life and whose failure to perform when properly used in accordance with instructions provided can be reasonably expected to result in significant personal injury or death. Users contemplating application of Elantec, Inc. products in Life Support Systems are requested to contact Elantec, Inc. factory headquarters to establish suitable terms & conditions for these applications. Elantec, Inc.’s warranty is limited to replacement of defective components and does not cover injury to persons or property or other consequential damages. Elantec, Inc. 1996 Tarob Court Milpitas, CA 95035 Telephone: (408) 945-1323 (800) 333-6314 Fax: (408) 945-9305 European Office: 44-71-482-4596 8 Printed in U.S.A.