Lineage Power CAR2512FPBY0-1A 2500 watt 12v front end power supply Datasheet

CAR2512FP Series
2500 Watt +12V Front End Power Supply
Features:
∎ Leading Edge Power Density, 27W/in3 in 1U Form Factor
∎ Works in Parallel with DC Input Models (CAR2412DC)
∎ I2C Serial Bus and PMBus Interface
∎ Up to 91.5% Efficiency (90% at 20% Load)
∎ Active Current Sharing (Single Wire)
∎ Remote On/Off, Remote Sense, Voltage Program Circuits
∎ Microprocessor Based Design Allows for Automatic Fan Speed Control
∎ Front Panel AC Access via IEC-320 Inlet
FEATURES
High Power Density 27W/in3
Load Sharing & Fault Tolerant
Automatic Fan Speed Control
High Efficiency under light Loads
BENEFITS
More system space for application circuits and hardware
Excellent reliability in N+1 operation with AC or DC Input Versions
Reduces audible noise and increases reliability
Supports Demands for Latest Server Farm Trends
SPECIFICATIONS
Input Voltage Range
Input Current Maximum
Inrush Current
Input Protection
Power Factor
Efficiency
2500 Watt 12V Front End Power Supply
180-264 VAC, 47-63 Hz, derate for 140-180 VAC Operation
16A @ 180VAC, Full Load (max)
40A max. cold start (per ETS 300 132-1 and Bellcore specifications)
One fuse (line) - 20A & 250Vac Type 3AB Axial
0.99 typical complies with IEC555, EN60555-2, EN61000-3-2
Up to 91.5% (90% eff. @ 20% load, 91.5% eff @ 30% load, 90.5% eff @ 50%, 88% @ 100% Load), Operating under 12V
output @ 230 VAC (including ORing MOSFETS)
2500W at High Line Operation (180-264 VAC)
10.8V to 13.2Vdc via analog and I2C / PMBus
208 Amps @ 12 VDC
3.3VSB @ 1A, reference to Vout Return (optional 5VSB)
±2% of Vnom for any combination of line, load and temperature
±1% (pk-pk) @ 20MHz with 0.1μF ceramic and 10μF electrolytic caps at the output
5% max deviation, recovery time 300μs @ 50% load step and di/dt < 1A/μs
400khz typical or optimized for efficiency gains
12ms at full load measured down to 10.8V (with 230Vac). An early warning signal is provided 2ms prior to loss of output
power. Ride thru is 8.3ms typically
TTL Compatible input, ON if >3V or open, OFF if <1V”
110-130% of Iout nominal
Self protected with auto recovery
Trip level: ≥14.8Vdc ± 1V, Reset condition by recycling the input or applying Remote On/Off
-10°C to +70°C
Non latching; protection active at 110°C internal temperature, restart at 95°C (typical)
FCC-B & EN55022-B with specified filter or at rack-level, GR-1089-CORE
Two LED’s, 1st Led (Green = AC OK), 2nd LED (Green = DC OK / Red = Fault)
Voltage Programming (V Prog), Load sharing (I Share), Remote ON/OFF, Current Monitor (I Monitor), Over temperature
(Temp Warning), Fault, PS Present, Module Enable, AC OK, DC OK
I2C and PMBus
Telcordia NEBS GR-63-CORE Level III
14.88” x 4.00” x 1.65” / 378mm x 102mm x 41.9mm
4.73lbs / 2.15kg
IEC/UL/CSA/EN60950-1, CE Mark (LVD), TUV
5VSB Output
Output Power
Output Voltage Range
Output Current
Standby Bias Voltage
Voltage Regulation
Ouput Ripple & Noise
Transient Response
Switching Frequency
Hold-Up Time
Remote On/Off
Current Limit Protection
Short Circuit Protection
Over Voltage Protection
Operating Temperature
Over Temperature Protection
EMI
LED Indicators
Analog Status & Control
Digital Status & Control
Shock & Vibration
Dimensions
Weight
Safety Approvals
Options
KEY MARKET SEGMENTS & APPLICATIONS
∎ Distributed Power
∎ Storage Equipment
∎ Mid-High End Servers
∎ High-End Routers & Switchgear
rev 100506
www.lineagepower.com/oem
Lineage Power
Lineage Power
Lineage Power (China)
3000 Skyline Dr.
Mesquite, TX 75149 Phone: (972) 284-2000
2841 Dow Avenue
Tustin, CA 92780 USA Phone: (714) 544-6665
1353 Chenqiao Road, Shanghai Sengpu Industrial Park
Shanghai, 201401 China
Phone: 021 6710 8910
CAR2512FP Series
2500 Watt +12V Front End Power Supply
OUTLINE DRAWING
All Dimensions in Inches (mm)
Tolerance: .XX = ± .02 in (.50 mm)
.XXX = ± .010 in (.254 mm)
EFFICIENCY CURVE:
CONNECTOR DRAWING:
95%
93%
Efficiency %
1
91.5%
91%
2
3
4
5
6
D
90.5%
90%
C
88%
89%
P1
P2
P3
P4
P5
P6
P7
P8
P9
P10
P11
P12
B
87%
A
85%
83%
81%
DC Output : Tyco P/N 6600122-7 (Rear side) / Mating Connector: Tyco P/N 6450171-5
79%
10%
20%
40%
50%
60%
80%
100%
% of Load @ 230Vac
PART NUMBER DEFINITION GUIDE:
CAR 25 12 F P x x xx -1A
Series
25=2500W
Output Current
12=12V
Output Voltage
Example:
F=Front End
Type
P=Positive
Polarity
Rev.
YO=5 of 6 Compliant
ZO=6 of 6 Compliant
RoHS
Blank = 3.3VSB
5 = 5VSB
Standby Voltage
B=Bezel Option
Blank=None
Options
CAR2512FPB5Z0-1A
2500W / 12Vout / Bezel / 5VSB / 6 of 6 RoHS
PIN OUT INFORMATION
A1
A2
A3
A4
A5
A6
B1
B2
B3
B4
B5
B6
VSB [3.3]
PS Present
Signal Return
Write Protect
Remote Sense (+)
Remote Sense (-)
Fault
I Monitor
Module Enable
VSB [3.3] Return
SDA
SCL
C1
C2
C3
C4
C5
C6
D1
D2
D3
D4
D5
D6
I Share
N/C
Temp OK
I2C Address (A0)
I2C Address (A1)
I2C Address (A2)
V Prog
OVP Test Point
Remote ON/OFF
DC OK
AC OK
Interrupt
rev 100506
P1
P2
P3
P4
P5
P6
P7
P8
P9
P10
P11
P12
Output Return
Output Returnt
Output Return
Output Returnt
Output Return
Output Return
+Vout
+Vout
+Vout
+Vout
+Vout
+Vout
www.lineagepower.com/oem
Lineage Power
Lineage Power
Lineage Power (China)
3000 Skyline Dr.
Mesquite, TX 75149 Phone: (972) 284-2000
2841 Dow Avenue
Tustin, CA 92780 USA Phone: (714) 544-6665
1353 Chenqiao Road, Shanghai Sengpu Industrial Park
Shanghai, 201401 China
Phone: 021 6710 8910
Similar pages