MPE-FT40-02 40W Triple Outputs AC-DC Open Frame Power Supply 4.45 5.08 9.53 Industrial Power Supply 10.16 3.048 AC-DC Features Safety Standards *Safety: UL 1950 / TUV EN60950 / CE mark *Input Voltage: The range of input voltage is from *EMI: EN55022 class B / CISPR FCC class B 90~264VAC or 120~370VDC *Input Frequency: 47~440Hz *Input Current: The maximum input current is 1A(RMS) at 115VAC Output PIN *Inrush Current: The cold inrush current will limit less than +12V 1 50A at 264VAC input voltage +5V 2 *Load Range: Voltage accuracy is set at full load. Maximum +5V 3 output power is 42.6W COM 4 *Ripple And Noise: The peak to peak ripple and noise for +5V COM 5 output is less than 50mV, 120mV for +/-12V outputs. 6 -12V Measuring is done by 20MHz bandwidth limited oscilloscope and terminated each output with a 0.1uF ceramic capacitor and Output Min. Rated Max. Voltage a 10uF electrolysis capacitor at rated load, nominal line Voltage Load Load Load Accuracy *Line Regulation: The line regulation for +5V and -12V is less +5V 0.4A 3.0A 5.0A 4.85~5.15V than +/-1%, +/-2% for +12V +12V 0.2A 2.0A 2.5A 11.52~12.48V *Load Regulation: The load regulation for +5V output is less -12V 0A 0.3A 0.5A 11.64~12.36V than +/-3%, +/-5% for +12V, and +/-1% for -12V. Measuring is measured from 60% to 100% and 60% to 20% with full load (60% +/-40% full load) *Hold Up Time: Hold up time is 20mS typical at 115VAC input *Efficiency: The efficiency is 75% typical while measuring is at nominal line and rated load *Over Voltage Protection: The trip point of crowbar circuit is around 5.7~6.7V for +5V output and 14.4~16.8V for +12V. The power supply will go into hiccup mode against short circuit or over load conditions, and will do auto-recovery while faulty conditions are removed *Temperature: 0~+50oC (operating); -20~+85oC (storage) *Humidity: 5~95% non-condensing *Connectors: I/P Connector: Molex 5277 or equivalent O/P Connector: Molex 5273 or equivalent *Dimensions: 10.16 x 5.08 x 3.048 cm www.boser.com.tw