GWSEMI GBJ2501 Single phase 25.0 amp bridge rectifier Datasheet

GBJ2501
THRU
GBJ2507
SINGLE PHASE 25.0 AMP BRIDGE RECTIFIERS
VOLTAGE RANGE
50 to 1000 Volts
CURRENT
25.0 Amperes
GBJ
FEATURES
* Ideal for printed circuit board
.134(3.4)
.122(3.1)
1.193(30.3)
1.169(29.7)
.189(4.8)
.173(4.4)
.150(3.8)
.134(3.4)
~
~
.165(4.2)
.142(3.6)
.094(2.4)
.078(2.0)
.043(1.1)
.035(0.9)
.441(11.2)
.425(10.8)
+
* Mounting position: Any
.800(20.3)
.776(19.7)
* Low leakage current
.708(18.0)
.669(17.0)
.189
(4.8)
* Low forward voltage
.114(2.9)
.098(2.5)
.031(0.8)
.023(0.6)
.402(10.2) .303(7.7) .303(7.7)
SPACING
.386(9.8) .287(7.3) .287(7.3)
Dimensions in inches and (millimeters)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating 25 C ambient temperature uniess otherwies specified.
Single phase half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
TYPE NUMBER
GBJ2501 GBJ2502 GBJ2503 GBJ2504 GBJ2505 GBJ2506 GBJ2507 UNITS
50
35
50
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
Maximum DC Blocking Voltage
Maximum Average Forward (with heatsink Note 2)
100
70
100
200
140
200
400
280
400
600
420
600
800
560
800
1000
700
1000
V
V
V
25.0
A
Rectified Current at Tc=100 C (Without heatsink)
Peak Forward Surge Current, 8.3 ms single half sine-wave
4.2
A
superimposed on rated load (JEDEC method)
Maximum Forward Voltage Drop per Bridge Element at 12.5A D.C.
Maximum DC Reverse Current
Ta=25 C
350
1.1
10
A
V
A
at Rated DC Blocking Voltage
Typical Junction Capacitance (Note 1)
Typical Thermal Resistance R JC (Note 2)
Operating Temperature Range, TJ
Storage Temperature Range, TSTG
500
85
0.6
A
PF
C/W
Ta=125 C
-55
-55
+150
+150
NOTES:
1. Measured at 1.0MHz and applied reverse voltage of 4.0V DC.
2. Thermal Resistance from Junction to Case with device mounted on 300mm x 300mm x 1.6mm Cu Plate Heatsink.
322
C
C
RATING AND CHARACTERISTIC CURVES (GBJ2501 THRU GBJ2507)
FIG.2-MAXIMUM NON-REPETITIVE FORWARD
SURGE CURRENT
25
AVERAGE FORWARD CURRENT,(A)
WITH HEATSINK
20
Single Phase
Half Wave 60Hz
15
Resistive Or Inductive Load
10
WITHOUT HEATSINK
5
0
20
40
60
80
100
120 140
160
PEAK FORWARD SURGE CURRENT,(A)
FIG.1-TYPICAL FORWARD CURRENT
DERATING CURVE
500
400
300
8.3ms Single Half
Tj=25 C
Sine Wave
200
JEDEC method
100
0
1
CASE TEMPERATURE,( C)
50
10
5
100
FIG.3-TYPICAL FORWARD
FIG.4-TYPICAL REVERSE
CHARACTERISTICS
CHARACTERISTICS
50
50
10
10
REVERSE LEAKAGE CURRENT, ( A)
INSTANTANEOUS FORWARD CURRENT,(A)
NUMBER OF CYCLES AT 60Hz
3.0
1.0
Tj=25 C
Pulse Width 300us
1% Duty Cycle
0.1
3.0
Tj=100 C
1.0
0.1
Tj=25 C
.01
0
.2
.4
.6
.8
1.0
1.2
.01
1.4
FORWARD VOLTAGE,(V)
0
20
40
60
80
100 120 140
PERCENT OF RATED PEAK REVERSE VOLTAGE, (%)
323
Similar pages