IPC PSU FSP150-50LG DESCRIPTION FSP150-50LG is an industrial level of switching power supply. The power supply comes to offer the total power capacity up to 150 Watts, and uses unique active PFC (Power Factor C orrection) circuit design with its high-load electrical components, makes it to be perfectly used in an industrial environment. In addition, with its full range of input and output electrical features, the power supply is ideally the best choice for server, workstation, communication or any other automation applications to use. The product also complies with the latest safety and EMC standards, which is perfectly to meet various regulations worldwide. SAFETY STANDARD APPAOVAL APPLICATION For standard, advanced server, NAS and industrial power system. OUTPUT SPECIFICATION Hold up Time: FEATURES Low Ripple & Noise Output over voltage protection Short circuit protection on all outputs Resettable power shut down INTERNAL 4 cm fan 100% burn-in under high ambient temperature (50℃) Vacuum-impregnated transformer MTBF:100K hours at 25℃ 100% Hi-pot tested Line input fuse protection Ouput Voltage Regulation: Output Rise Time: W ATTAGE Wattage: 150W Ripple & Noise: DIMENSION Dimension: 150mm(L) x 81.5mm(W) x 40.5mm(H) PRODUCT HIGHLIGHT Efficiency Level: Altitude: PMBus: Short Circuit Protection: Non-80+ 2000M For standard, advanced server, NAS and industrial power system. ENVIRONMENTAL SPECIFICATION TEMP.Range: MTBF: INPUT SPECIFICATION Input Range: Input Frequency: Input Current: 115V/60Hz 17mSec. Minimum@100% Load, 230V/50Hz 17mSec. Minimum,@100% Load +3.3Vdc output : +3.7 Vdc minimum, + 4.5Vdc maximum +5Vdc output : +5.7 Vdc minimum, + 6.5Vdc maximum +12Vdc output : +13.3 Vdc minimum, + 15.6Vdc maximum 115V-rms/230V-rms 5V 20ms Maximum 115V-rms/230V-rms 12V 20ms Maximum 3.3V:50mV p-p 5V:50mV p-p 12V1:120mV p-p -12V:120mV p-p 5Vsb:50mV p-p load < 0.1 Ohm 90-264 Vac 47-63 Hz 115V@ 3.0 Amps-rms maximum 230V@ 1.5 Amps-rms maximum Storage Temperature: 20°C to + 80℃ The power supply have a minimum predicted MTBF(MIL-HDBK-217) of 100,000 hours of continuous operation at 25℃, maximum-output load, and nominal AC inout voltage GENERAL SPECIFICATION Effciency: Voltage Regulation: 72% +3.3V, +12V, +5V, +5SB: ±5% -12V: ±10% *Output Voltage and C urrent Rating +3.3V Ripple-Noise(R-P) mV 50mV Regulation Load % ±5% Output Max.(A) 10A Output Min.(A) 0.3A +5V 50mV ±5% 13A 0.3A +12V1 120mV ±5% 10A 1A NOTES 5V, 3.3V, 12V, -12V Will have the regulation to 10% when all load take off. The +3.3V and +5V total output shall not exceed 85 watts. The total output shall not exceed 150 watts MECHANICAL SPECIFICATION This content is subject to change, please refer to specification for m ore detail. FSP reserve the right to change the content without prior notice -12V 120mV ±10% 0.3A 0A +5Vsb 50mV ±5% 2A 0A