HV05-15 High Voltage Rectifier NOTE: TO ORDER WITH QUICK DISCONNECT TERMINALS, REFER HV05-15-qd DURING ORDERING PROCESS. FEATURES Avalanche Breakdown Protection Low Forward Voltage Drop Typical IR less than 0.1 μA High Overload Surge Capacity ABSOLUTE MAXIMUM RATINGS VRRM REPEATING PEAK REVERSE VOLTAGE (KV): TJMAX MAX. JUNCTION TEMP.(°C):……………….. TSTG STORAGE TEMP.(°C):………………………….. IO AVG. FORWARD CURRENT (MA):……………. IFSM FORWARD SURGE CURRENT (A): ………….. 15 120 -40 TO +120 550 44 ELECTRICAL CHARACTERISTICS IR1 Normal temp. Reverse Current (ΜA):.. 5.0 MAX IR2 High temp. Reverse Current (ΜA):…….. 50 MAX VF FORWARD VOLTAGE (V):………………………….. 12 MAX TEST CONDITIONS HIGH TEMP. REVERSE VOLTAGE @ 1000 HRS.: ….. VRM=VRRM, F=50HZ, TAMB=100°C HALF SINE VOLTAGE WITH F=50HZ APPLIED, TAMB=100°C HIGH TEMP. STORAGE @ 1000 HRS.:……………….. TAMB=130±2°C SOLDERING RESISTANCE HEAT TEST:…………………. SOLDER TROUGH TEMP.: 350±10°C, DIP TIME: 3.5S ± 0.5S HIGH PRESSURE SMOKE TEST @ 10 HRS.:…………… 120°C, 2 X 105PA INSULATION RESISTANCE TEST (1000MΩ):……….. BETWEEN THE CENTER OF THE BODY AND TERMINAL (SEE FIG. 1) INSULATION STRENGTH TEST @ 10KV:…………….. 1 MIN. BETWEEN CENTER OF THE BODY AND TERMINAL. (FIG.1 ) LEAD BEND TEST:………………………………………….. FORCE 10 N TO THE LEAD, BENT IT TO POS. AND neg. 90° LEAD PULL TEST:…………………………………………… FORCE 70 N OF AXIAL TO THE LEAD FOR 1 MIN. Insulation resistance test condition: Measure between A and B by using a DC 500V Insulation resistance tester Insulation strength test condition: Apply half sine wave voltage with 10kV wave height between A and B in insulation liquid Document Page 1 of 1 Revised 06/2013 Tel. 1-973-377-9566, Fax. 1-973-377-3078 133 Kings Road, Madison, New Jersey 07940 United States of America © 2013 American Microsemiconductor, Inc. Specifications are subject to change without notice. www.americanmicrosemi.com Aerospace Mgmt. Sys. Cert. AS/EN/JISQ9100:2009 Rev. C ISO9001:2008 Cert No. 45325