AC-DC 175 Watts xppower.com CLC175 Series • High Efficiency Resonant Topology • High Power Density 9.3 W/in3 • 12 V Fan Output as Standard • Remote Sense as Standard • 5V Standby Option • Remote On/Off Option • Power Good Signal Option Specification Input General Input Voltage • 85-264 VAC (120-370 VDC), derate output power <90 VAC (See derating curve) Input Frequency • 47-63 Hz Input Current • 3.0 A typical at 115 VAC, full load 1.5 A typical at 230 VAC, full load Inrush Current • 40 A max at 230 VAC, cold start 25 ºC Power Factor • EN61000-3-2, class A Earth Leakage Current • 200/400 µA 115/230 VAC at 50 Hz 475 µA 264 VAC at 60 Hz Input Protection • Internal 5 A fuse Output Output Voltage Output Voltage Trim Initial Set Accuracy Minimum Load Start Up Delay • • • • • Start Up Rise Time Hold Up Time Drift Line Regulation Load Regulation Over/Undershoot Transient Response • • • • • • • Ripple & Noise • Overvoltage Protection Overload Protection Short Circuit Protection Temperature Coefficient Remote Sense Remote On/Off (Inhibit/Enable) (Option -A) • • • • 12-48 V (see tables) ±5% ±1% V1, ±5% V2, ±3% V3 0.1A required for V2 regulation when used 1 s typical, see longform datasheet for more details 50 ms 16 ms min at 115 VAC ±0.2% after 20 min warm up ±0.5% max ±1% V1, ±5% V2 & V3 max 5% typical 4% max. deviation, recovery to within 1% in 500 µs for a 50-75-50% load change 1% pk-pk V1, others 2%, 20 MHz bandwidth 115-140% Vnom, recycle input to reset 110-150% V1 only Continuous trip and restart (Hiccup mode) 0.05%/˚C • Compensates for 0.5 V total voltage drop • Uncommitted isolated optocoupler diode, powered diode inhibits V1 & V2 Efficiency Isolation Switching Frequency Signals (Option -A) MTBF • 87% typical • 3000 VAC Input to Output 1500 VAC Input to Ground 500 VAC Output to Ground • 70 kHz typical • Power OK - open collector, Remote On/Off, 5 V Standby • 390 kHrs per MIL-HDBK-217F Environmental Operating Temperature • 0 ˚C to +70 ˚C derate linearly from +50 ˚C at 2.5%/˚C to 50% load at +70 ˚C. See derating curve and longform datasheet for thermal information. Cooling • Forced-cooled >10 CFM Operating Humidity • 95% RH, non-condensing Storage Temperature • -40 ˚C to +85 ˚C Operating Altitude • 3000 m Shock • 30 g pk, half sine, 6 axis Vibration • 2 g rms, 5 Hz to 500 kHz, 3 axis EMC & Safety Low Voltage PSU EMC • EN61204-3, high severity level as below Emissions • EN55022 level B conducted EN55022 level A radiated Harmonic Currents • EN61000-3-2, class A Voltage Flicker • EN61000-3-3 Radiated Immunity • EN61000-4-3, level 3 Perf Criteria A EFT/Burst • EN61000-4-4, level 3 Perf Criteria A Surge • EN61000-4-5, installation class 3 Perf Criteria A Conducted Immunity • EN61000-4-6, level 3 Perf Criteria A Dips & Interruptions • EN61000-4-11, 30% 10 ms, 60% 100 ms, 100% 5000 ms Perf Criteria A, B, B Safety Approvals • IEC60950-1 CB report, CSA 22.2 No. 60950-1, UL60950-1, TUV EN60950-1 Max Output Power(1) Output Voltage V1 Max Output Current V1 Fan Output V2 Standby Supply V3 (optional) 175 W 12.0 VDC 13.9 A 12.0 V/0.5 A 5.0 V/0.5 A CLC175US12 175 W 24.0 VDC 6.9 A 12.0 V/0.5 A 5.0 V/0.5 A CLC175US24 175 W 48.0 VDC 3.5 A 12.0 V/0.5 A 5.0 V/0.5 A CLC175US48 Model Number(2) Notes 1. 10 CFM airflow. 2. For V3 5 V standby, Power OK & Inhibit, add suffix ‘-A’ to model number. Mechanical Details 5.00 (127.0) 4.55 (115.6) 0.22 (5.7) 1.30 (33.0) 0.20 (5.1) 3.00 (76.2) 1.90 (48.3) 2.50 (63.6) 2.55 (64.8) 0.61 (15.6) 1.11 (28.3) 0.23 (5.7) 0.20 (5.1) 0.25 Faston Ground Tab V Adj. 0.18 (4.6) 4 x ø0.156 (3.96) Mounting Holes ø0.312 (7.92) Clearance Top & Bottom Input Connector J1 Pin 1 Line Pin 2 Neutral 0.25”Faston Earth J1 mates with Molex housing 09-50-1031 and Molex series 5194 crimp terminals. 0.19 (4.8) SMD component height 0.14 (3.5) Output Connector J2 Pin Single 1 +V1 2 +V1 3 +V1 4 +V1 5 RTN 6 RTN 7 RTN 8 RTN J2 mates with Molex housing 09-50-1081 and Molex series 5194 crimp terminals. Signal Connector J3 Pin Single 1 +5V Standby 2 Logic GND 3 Logic GND 4 Power OK 5 Inhibit HI 6 Inhibit LO 7 +Sense 8 -Sense 9 +Vout 10 -Vout Fan Connector J4 Pin 1 Fan +(12V) Pin 2 Fan J4 mates with Molex housing 22-01-1024 and Molex series 5103 crimp terminals. J3 mates with JST housing PHDR-10VS and JST series SPHD-001T-P0.5 crimp terminals. Notes 1. All dimensions in inches (mm). Tolerance .xx = ±0.02 (0.50); .xxx = ±0.01 (0.25) Derating Curves Output Power (W) Output Power (W) 175 175 158 85 90 264 Input Voltage (VAC) 88 0 +40 +50 +60 +70 Ambient Temperature (ºC) 30-Jul-08 AC-DC CLC175 Models and Ratings