EPCOS B5011 Saw if filter wimax Datasheet

SAW Components
SAW IF Filter
WiMAX
Series/Type:
Ordering code:
B5011
B39461-B5011-H810
Date:
Version:
Jun 09, 2008
2.0
 EPCOS AG 2008. Reproduction, publication and dissemination of this data sheet, enclosures
hereto and the information contained therein without EPCOS’ prior express consent is prohibited.
SAW Components
B5011
456.00 MHz
Low-Loss Filter for WiMAX
Data Sheet
Application
■ Low-loss IF filter for WiMAX
■ Usable bandwidth 3.7 MHz
■ Ceramic SMD package
Features
Package size 7.0 x 5.0 x 1.33 mm3
Package code QCC12E
RoHS compatible
Approx. weight 0.2 g
Package for Surface Mount Technology
(SMT)
■ Ni, gold-plated terminals
■
■
■
■
■
Pin configuration
■
■
■
■
■
■
10
12
4
6
2, 3, 8, 9
1, 5, 7, 11
Input
Input ground or balanced input
Output
Output ground or balanced output
Ground
Case ground
Please read cautions and warnings and
important notes at the end of this document.
2
Jun 09, 2008
SAW Components
B5011
456.00 MHz
Low-Loss Filter for WiMAX
Data Sheet
Characteristics
Operating temperature range:
Terminating source impedance:
Terminating load impedance:
T = –40 ˚C to +85 ˚C
ZS = 200 Ω balanced and matching network
ZL = 200 Ω balanced and matching network
min.
—
Nominal frequency
fN
Minimum insertion attenuation1)
(including matching network)
αmin
Amplitude ripple (p-p)
fN ± 1.7 MHz
fN ± 1.85 MHz
Group delay ripple (p-p)
fN ± 1.7 MHz
Return loss
fN ± 1.7 MHz
max.
—
MHz
—
8.5
10.0
dB
—
—
0.6
1.5
1.0
3.0
dB
dB
—
0.55
3.0
µs
—
120
250
ns
8
10
12
14
—
—
dB
dB
20
35
45
30
38
49
—
—
—
dB
dB
dB
30
40
50
40
40
30
70
70
64
46
44
44
—
—
—
—
—
—
dB
dB
dB
dB
dB
dB
∆α
τ
Absolute group delay (at fN)
typ.
456.00
∆τ
Input
Output
Impulse response attenuation (Time/Height
values are relative to the main time response
lobe)
1-2 µs
2-3 µs
> 3 µs
Relative attenuation (relative to αmin)
1 MHz ...
256 MHz
256 MHz ... 360
MHz
360 MHz ... 416.0 MHz
416 MHz ... 452.65 MHz
459.35 MHz ... 656 MHz
656 MHz ... 946
MHz
αrel
Temperature coefficient of frequency2)
Turnover temperature
TCf
—
–0.036
—
ppm/K2
T0
—
20
—
˚C
1)
2)
Could increase up to 10,8 dB with single ended matching network at 50 Ω
Temperature dependance of fc: fc(TA) = fc(T0)(1 + TCf(TA – T0)2)
Please read cautions and warnings and
important notes at the end of this document.
3
Jun 09, 2008
SAW Components
B5011
456.00 MHz
Low-Loss Filter for WiMAX
Data Sheet
Matching network to 200 Ω balanced
4:1 transformers are only required for measurement in a 50 Ω environment
(element values depend on PCB layout)
L
L
L
L
Lp1 = 100 nH
Lp4 = 22 nH
Ls6 = Ls7= 18 nH
Ls2 = Ls3= 33 nH
Lp5= 27 nH
Lp8 = 62 nH
Matching network to 50 Ω single ended(element values depend on PCB layout)
Ls2
Lp1
Ls5
Lp4
Lp3
Lp1 not used; Ls2 = 47nH; Lp3 = 18 nH
Lp6
Lp4 = 22nH; Ls5=47nH; Lp6=47nH
Maximum ratings
Operable temperature range
Storage temperature range
DC voltage
DC voltage
ESD voltage
Input power
1)
T
Tstg
VDC
VDC
VESD
PIN
–40/+80
–40/+85
5
0
2001)
10
˚C
˚C
V
V
V
dBm
between input, output and ground
between 10, 12 and between 4,6
machine model, 1 pulse
acc. to J-STD22A-0115A (machine model, 1 pulse +/-).
Please read cautions and warnings and
important notes at the end of this document.
4
Jun 09, 2008
SAW Components
B5011
456.00 MHz
Low-Loss Filter for WiMAX
Data Sheet
Transfer function
Transfer function (wideband
Please read cautions and warnings and
important notes at the end of this document.
5
Jun 09, 2008
SAW Components
B5011
456.00 MHz
Low-Loss Filter for WiMAX
Data Sheet
Normalized transfer function
Transfer function (Impulse response)
Please read cautions and warnings and
important notes at the end of this document.
6
Jun 09, 2008
SAW Components
B5011
456.00 MHz
Low-Loss Filter for WiMAX
Data Sheet
Type
B5011
Ordering code
B39461-B5011-H810
Marking and Package
C61157-A7-A103
Packaging
F61074-V8170-Z000
Date Codes
S-Parameters
Soldering profile
S_6001
For further information please contact your local EPCOS sales office or visit our webpage at
www.epcos.com .
Published by EPCOS AG
Surface Acoustic Wave Components Division
P.O. Box 80 17 09, 81617 Munich, GERMANY
 EPCOS AG 2008. Reproduction, publication and dissemination of this brochure and the information contained therein without EPCOS’ prior express consent is prohibited.
Purchase orders are subject to the General Conditions for the Supply of Products and Services of
the Electrical and Electronics Industry recommended by the ZVEI (German Electrical and Electronic
Manufacturers’ Association), unless otherwise agreed.
This brochure replaces the previous edition.
For questions on technology, prices and delivery please contact the Sales Offices of EPCOS AG or
the international Representatives.
Due to technical requirements components may contain dangerous substances. For information on
the type in question please also contact one of our Sales Offices.
Please read cautions and warnings and
important notes at the end of this document.
7
Jun 09, 2008
Important notes
The following applies to all products named in this publication:
1.
2.
3.
4.
5.
6.
7.
Some parts of this publication contain statements about the suitability of our products for
certain areas of application. These statements are based on our knowledge of typical
requirements that are often placed on our products in the areas of application concerned. We
nevertheless expressly point out that such statements cannot be regarded as binding
statements about the suitability of our products for a particular customer application.
As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar
with them than the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS product with the properties
described in the product specification is suitable for use in a particular customer application.
We also point out that in individual cases, a malfunction of electronic components or
failure before the end of their usual service life cannot be completely ruled out in the
current state of the art, even if they are operated as specified. In customer applications
requiring a very high level of operational safety and especially in customer applications in
which the malfunction or failure of an electronic component could endanger human life or
health (e.g. in accident prevention or life-saving systems), it must therefore be ensured by
means of suitable design of the customer application or other action taken by the customer
(e.g. installation of protective circuitry or redundancy) that no injury or damage is sustained
by third parties in the event of malfunction or failure of an electronic component.
The warnings, cautions and product-specific notes must be observed.
In order to satisfy certain technical requirements, some of the products described in this
publication may contain substances subject to restrictions in certain jurisdictions (e.g.
because they are classed as hazardous). Useful information on this will be found in our
Material Data Sheets on the Internet (www.epcos.com/material). Should you have any more
detailed questions, please contact our sales offices.
We constantly strive to improve our products. Consequently, the products described in this
publication may change from time to time. The same is true of the corresponding product
specifications. Please check therefore to what extent product descriptions and specifications
contained in this publication are still applicable before or when you place an order.
We also reserve the right to discontinue production and delivery of products. Consequently, we cannot guarantee that all products named in this publication will always be available. The aforementioned does not apply in the case of individual agreements deviating from
the foregoing for customer-specific products.
Unless otherwise agreed in individual contracts, all orders are subject to the current version of the “General Terms of Delivery for Products and Services in the Electrical
Industry” published by the German Electrical and Electronics Industry Association
(ZVEI).
The trade names EPCOS, BAOKE, Alu-X, CeraDiode, CSSP, CTVS, DSSP, MiniBlue, MKK,
MLSC, MotorCap, PCC, PhaseCap, PhaseMod, SIFERRIT, SIFI, SIKOREL, SilverCap, SIMDAD, SIMID, SineFormer, SIOV, SIP5D, SIP5K, ThermoFuse, WindCap are trademarks registered or pending in Europe and in other countries. Further information will be found on the
Internet at www.epcos.com/trademarks.
8
Jun 09, 2008
Similar pages