2016-V1.0-1119 Specifications Constant Current LED Power Supplies LXB-50C Series, 50W PAIRUI ELECTRONICS No. 545 Museum Road Yangzhou, Jiangsu China 225009 Tel: 86 (514) 8279 1592 Fax: 86 (514) 8769 3159 2016 led power supplies PRODUCT SPECIFICATION LED Power Supplies for Indoor Use LXB-50C SERIES, 50WATT, IP20 RATING Features 3 Year Warranty High Input Voltage Range: 200~240Vac Constant Current Output Mode Waterproof Rating IP20 Built-in Active Power Factor Correction Class II Power, no FG Short Circuit, and Over Temperature Protections Applications √ Panel Light √ Down Light √ Cabinet Light √ Other Indoor used Lights √ Recessed Light Electrical LX B 50 - C 700 ST Strain ReliefSet Output Current(mA) Output Mode C = Constant Current Mode Output Power(W) Input Voltage Range B = 200-240Vac Series Name PAIRUI ELECTRONICS www.pairuigroup.com Updated 2016-V1.0-1119 Page:1/6 led power supplies PRODUCT SPECIFICATION Electrical PartNumber Nominal Input Voltage LXB50-C350 200-240VAC LXB50-C500 Output Current Output Voltage No Load Output Voltage Ripple Efficiency Certificate 350mA(100-142V) 156V 50% 90% CE 200-240VAC 500mA(70-100V) 110V 50% 90% CE LXB50-C700 200-240VAC 700mA(50-71V) 78V 50% 89% CE LXB50-C1050 200-240VAC 1050mA(33-48V) 52V 50% 88% CE NOTE: Other output models are may available on request. PAIRUI ELECTRONICS www.pairuigroup.com Updated 2016-V1.0-1119 Page:2/6 led power supplies PRODUCT SPECIFICATION INPUT PARAMETER CONDITIONS Input frequency Input current Full load, Vin=220Vac Inrush current Cold start, Vin=230Vac Power factor(PF) Full load, Vin=220Vac Surge voltage L-N MIN TYP MAX 47 50 63 0.29 UNITS Hz A 35 A 0.96 2 KV PAIRUI ELECTRONICS www.pairuigroup.com Updated 2016-V1.0-1119 Page:3/6 led power supplies PRODUCT SPECIFICATION OUTPUT PARAMETER CONDITIONS Output current accuracy MIN TYP MAX UNITS ±5 % Line regulation Vin from 200Vac to 240Vac 3 % Load regulation Vout from min. to max. 3 % Output current overshoot Turning on Turn-on delay time Cold start, power on 1000 ms Ripple Please refer to below measuring method 50%Io mAp-p THD Output load≥60% % 10 % 20 NOTE: The values are measured at 20MHz of bandwidth by using a 12'' twisted pair-wire terminated with 0.1uF & 47uF parallel capacitor under ambient temperature 25℃ at rated input voltage and rated load. Protection Short circuit In hiccup mode, it will recover automatically after fault condition is removed Over temperature 120℃-160℃ It will recover automatically after the temperature goes down PAIRUI ELECTRONICS www.pairuigroup.com Updated 2016-V1.0-1119 Page:4/6 led power supplies PRODUCT SPECIFICATION Environment PARAMETER CONDITIONS MIN Ambient operating temperature Startup at rated voltage Operating relative humidity TYP MAX UNITS -25 +70 ℃ Non condensing 20 90 % Storagetemperature Humidity 10 ~ 95% RH - 40 + 80 ℃ Maximum case temperature Hot-spotoncase + 75 ℃ MTBF Fullload, 220Vac input, 25℃ambient temperature Waterproof rating IP20 Dimension(LxWxH) 122.0 x 43.0 x 30.0mm Weight 300g 230 Khrs Safety/EMC Safety Design refer to EN61347-1, EN61347-2-13 EMC Compliance to EN55015, FCC Part 15 Class B, EN61000-3-2, EN61000-3-3, EN61000-4-2, 3, 4, 5, 6, 8, 11, EN61547 NOTE: Unless otherwise specified, all the above parameters are measured at ambient temperature of 25℃andVin=200Vac to 240Vac. PAIRUI ELECTRONICS www.pairuigroup.com Updated 2016-V1.0-1119 Page:5/6 PRODUCT SPECIFICATION led power supplies Mechanical 30 43 122 Unit: mm Electrical Curve DERATING CURVE 100 90 Load(%) 80 70 60 50 40 30 -25 -15 0 10 20 30 40 50 60 70 Temperature(℃) PAIRUI ELECTRONICS www.pairuigroup.com Updated 2016-V1.0-1119 Page:6/6