CDLL4765 thru • TEMPERATURE COMPENSATED ZENER REFERENCE DIODES • LEADLESS PACKAGE FOR SURFACE MOUNT CDLL4774A • 9.1 VOLT NOMINAL ZENER VOLTAGE + 5% • LOW CURRENT OPERATING RANGE: 0.5 and 1.0 mA • METALLURGICALLY BONDED • DOUBLE PLUG CONSTRUCTION MAXIMUM RATINGS Operating Temperature: -65°C to +175°C Storage Temperature: -65°C to +175°C DC Power Dissipation: 500mW @ +50°C Power Derating: 4 mW / °C above +50°C REVERSE LEAKAGE CURRENT lR = 10 µA @ 25°C & VR = 6Vdc ELECTRICAL CHARACTERISTICS @ 25°C, unless otherwise speci½ed. TYPE NUMBERS ZENER VOLTAGE vz @ I ZT ZENER TEST CURRENT I ZT (Note 3) MAXIMUM ZENER IMPEDANCE ZZT MAXIMUM VOLTAGE TEMPERATURE TEMPERATURE RANGE STABILITY ³V ZT MAXIMUM EFFECTIVE TEMPERATURE COEFFICIENT (Note 1) (Note 2) VOLTS mA OHMS mV CDLL4765 CDLL4765A CDLL4766 CDLL4766A 9.1 9.1 9.1 9.1 0.5 0.5 0.5 0.5 350 350 350 350 68 141 34 70 0 -55 0 -55 to to to to + + + + 75 100 75 100 0.01 0.01 0.005 0.005 CDLL4767 CDLL4767A CDLL4768 CDLL4768A 9.1 9.1 9.1 9.1 0.5 0.5 0.5 0.5 350 350 350 350 14 28 6.8 14 0 -55 0 -55 to to to to + + + + 75 100 75 100 0.002 0.002 0.001 0.001 CDLL4769 CDLL4769A CDLL4770 CDLL4770A 9.1 9.1 9.1 9.1 0.5 0.5 1.0 1.0 350 350 200 200 3.4 7 68 141 0 -55 0 -55 to to to to + + + + 75 100 75 100 0.0005 0.0005 0.01 0.01 CDLL4771 CDLL4771A CDLL4772 CDLL4772A 9.1 9.1 9.1 9.1 1.0 1.0 1.0 1.0 200 200 200 200 34 70 14 28 0 -55 0 -55 to to to to + + + + 75 100 75 100 0.005 0.005 0.002 0.002 CDLL4773 CDLL4773A CDLL4774 CDLL4774A 9.1 9.1 9.1 9.1 1.0 1.0 1.0 1.0 200 200 200 200 6.8 14 3.4 7 0 -55 0 -55 to to to to + + + + 75 100 75 100 0.001 0.001 0.0005 0.0005 °C % / °C NOTE 1 Zener impedance is derived by superimposing on lZT A 60Hz rms a.c. current equal to 10% of lZT. NOTE 2 The maximum allowable change observed over the entire temperature range i.e., the diode voltage will not exceed the speci½ed mV at any discrete temperature between the established limits, per JEDEC standard No.5. NOTE 3 Zener voltage range equals 9.1 volts +5% DIM D F G G1 S MILLIMETERS INCHES MIN MAX MIN MAX 1.60 1.70 0.063 0.067 0.41 0.55 0.016 0.022 3.30 3.70 .130 .146 2.54 REF. .100 REF. 0.03 MIN. .001 MIN. FIGURE 1 DESIGN DATA CASE: DO-213AA, Hermetically sealed glass case. (MELF, SOD-80, LL34) LEAD FINISH: Tin / Lead POLARITY: Diode to be operated with the banded (cathode) end positive. MOUNTING POSITION: Any. MOUNTING SURFACE SELECTION: The Axial Coefficient of Expansion (COE) Of this Device is Approximately +6PPM/°C. The COE of the Mounting Surface System Should Be Selected To Provide A Suitable Match With This Device. 6 LAKE STREET, LAWRENCE, MASSACHUSETTS 01841 PHONE (978) 620-2600 FAX (978) 689-0803 WEBSITE: http://www.microsemi.com 129 Pd, Rated Power Dissipation (mW) CDLL4765 thru CDLL4774A 600 500 400 300 200 100 0 0 25 50 75 100 125 150 TL, Ambient temperature (°C) FIGURE 2 POWER DERATING CURVE 1000 ZENER IMPEDANCE ZZT (OHMS) 500 100 50 10 1 2 OPERATING CURRENT lZT (mA) 3 FIGURE 3 ZENER IMPEDANCE VS. OPERATING CURRENT CHANGE IN TEMPERATURE COEFFICIENT ( %/°C) +.0015 +.0010 +.0005 0 -.0005 -.0010 -.0015 0.5 1.0 1.5 OPERATING CURRENT lZT (mA) 2.0 FIGURE 3 130 TYPICAL CHANGE OF TEMPERATURE COEFFICIENT WITH CHANGE IN OPERATING CURRENT 175