LED-75W Series– Fixed Output and Dimmable Switch Mode LED Drivers Constant Current & Constant Voltage with Isolation Black Magic Thermal Advantage™ Aluminum Housing Electrical Specifications Input Voltage Range: 100-277 Vac Nom. (90-305 V Min/Max) Input Over-Voltage: Can endure 320Vac for 48 Hrs, 350Vac for 2 Hrs Frequency: 50/60 Hz Nom. (47-63 Hz Min/Max) Power Factor: >0.90 @ full load, 100V through 277V Inrush Current: <30.0 Amps max @ 230 Vac, cold start 25ºC Input Current: 1.00 Amps max Maximum Power: 75W Current Accuracy: ± 1% Over input line variation Load Regulation: ± 3% THD: < _ 20% @ full load Leakage Current: 400 µA Typical Hold Up Time: Half Cycle Protection: utput Over-Voltage, Output Over-Current, and O Output Short Circuit Protection reset by power cycling Environmental Specifications • Total Power: 75 Watts • Input Voltage: 100-277 Vac Nom. • UL Dry & Damp Location Rated • IP66 • High Power Factor • UL8750, CSA 22.2, EN61347, EN61000-3-2, EN61000-3-3 Class C Minimum Starting Temp: -30ºC Maximum Case Temp. 90°C Storage Temperature: -40ºC to +85ºC Humidity: 5% to 95% LED75W-257-C0300-XX 300 Cooling: Convection LED75W-200-C0350-XX 350 Vibration Frequency: 5 to 55 Hz/2g, 30 minutes LED75W-128-C0600-XX 600 42-128 75 91% Sound Rating: Class A LED75W-085-C0900-XX 900 28-85 75 90% MTBF: 78,000 Hours at full load and 40ºC ambient conditions 4 per MIL-217F Notice 2 LED75W-064-C1200-XX 1200 21-64 75 90% LED75W-056-C1400-XX 1400 18-56 75 90% FCC 47CFR Part 15 Class B compliant LED75W-048-C1600-XX 1600 16-48 75 90% LED75W-036-C2100-XX 2100 12-36 75 89% LED75W-030-C2500-XX 2500 10-30 75 89% LED75W-027-C2800-XX 2800 9-27 75 88% LED75W-025-C3000-XX 3000 8-25 75 88% LED75W-022-C3400-XX 3400 7-22 74.8 88% LED75W-020-C3750-XX 3750 7-20 75 87% LED75W-018-C4200-XX 4200 6-18 75 86% LED75W-015-C5000-XX 5000 5-15 75 86% EMC: Constant Current - Product Specifications Model Number Output Current Output Voltage (mA ±3%) Range (Vdc) Max. Output Power (W) Typical Efficiency 85-257 75 91% 66-200 70 91% -XX indicates dimming options are available. See options at left. Blank = fixed current output Ordering Options: -D: 0-10V & Resistance dimmable version comes with an extra two wires +Purple/-Gray on the output side. -D 0-10V Dimming is compatible with most quality 0-10V wall dimmers. See page 3 for additional specifications. -PD: PWM Dimmable version comes with an extra two wires +Purple/-Gray on the output side. PD PWM version is PWM Dimmable via a positive 10% to 100% Duty Cycle, 200Hz to 1KHz, 0-10V Pulse. See page 4 for additional specifications. Sign Components Manual E332160 Note: LED drivers are designed and intended to operate LED loads only. Non-LED loading may be outside the specified design limits of our LED drivers, and therefore cannot be covered by any warranty. If you desire to use our LED drivers to operate non-LED loads please contact us to discuss compatibility. Specifications subject to change without notice. Constant Voltage - Product Specifications Model Number Output Voltage Output Current (Vdc ±5%) Range (mA) Max. Output Power (W) Typical Efficiency LED75W-015 15 1250-5000 75 86% LED75W-018 18 1050-4200 75 86% LED75W-020 20 938-3750 75 87% LED75W-022 22 850-3400 74.8 88% LED75W-025 25 750-3000 75 88% LED75W-027 27 700-2800 75 88% LED75W-030 30 625-2500 75 89% LED75W-036 36 525-2100 75 89% LED75W-048 48 400-1600 75 90% LED75W-056 56 350-1400 75 90% LED75W-064 64 300-1200 75 90% LED75W-085 85 225-900 75 90% LED75W-128 128 150-600 75 91% LED75W-200 200 88-350 70 91% LED75W-257 257 75-300 75 91% Class 2: US/Canada US Only Rev 8-31-15 Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LED75W Series SSL Solutions Faster Than The Speed Of Light® Pg 2 of 4 Dimensions - mm 6.81 [173.0] 0.31 [7.8] 1.06 [27] 2.81 [71.3] 0.16 [4] 0.24 [6] 6.42 [163.0] 7.25 [184.0] 0.39±0.04 [10±1] 5.91 Min [150 Min] 0.90 [22.8] Dimming Purple (+) Gray (-) INPUT Black (L) White (N) Green (GND) 0.39±0.04 [10±1] 2.24±0.12 [57.0±3] 2.24±0.12 [57.0±3] OUTPUT Red (+) Blue (-) 3.21 [81.5] Tc = 90°C max Power Factor / Load 1.00 THD / Load 50% 0.90 45% 0.80 40% 0.70 35% 0.60 30% THD PF 1.83 [46.5] 5.91 Min [150 Min] WIRE SPECS: Input Leads: 18 AWG, rated 600 V, 105C, min. Output Leads: 18 AWG, rated 300 V, 105C, min. Dimming Leads: 22 AWG, rated 300 V, 105C. All wires are stranded with solder dipped ends. 0.50 0.40 25% 120Vac 277Vac 0.30 0.20 15% 0.10 10% 0.00 50% 60% 70% 80% 90% Load 120Vac 277Vac 20% 100% 0% 50% 60% 70% 80% Load 90% 100% Lifetime (kHrs) Lifetime / Case Temperature 400 375 350 325 300 275 250 225 200 175 150 125 100 75 50 25 0 45 (Full Load @ 120Vac) 50 55 60 65 70 75 80 85 Case Hotspot Temperature (°C) 90 Note: Life calculations are based on reliability with confidence using a 90% confidence level and <5% failure rate. At a confidence level of 90% it is expected that <5% of the parts will fail at the rated life provided. (Failure is defined as a driver drifting outside specification, rather than fail to operate) UL Conditions of Acceptability See website for additional information Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LED75W Series SSL Solutions Faster Than The Speed Of Light® Pg 3 of 4 “-D” Option: 0-10VDC and Resistance Dimming Parameters Minimum Typical Maximum 0 mA -2.0 V — — 2 mA +15 V Source Current out of 0-10V Purple Wire Absolute Voltage Range on 0-10V (+) Purple Wire Typical Dimming Circuit Dim (+) Purple LED75W-XX-CXXXX-D IP710 Wall Dimmer Dim (-) Gray (Dimmer must be current-sink type control) Output Current / 0-10VDC Dimming Input Output Current % 100 90 80 70 60 50 40 30 20 10 0 0V 1V 2V 3V 4V 5V 6V Dimming Input (Vdc) 7V 8V 9V 10V Notes: 1. 2. 3. 4. 0-10V dimmable version comes with an extra two wires +Purple/-Gray on the output side. Compatible with most 0-10V Wall Slide dimmers and direct 0-10V analog signal. Recommended dimmer is Leviton IP710 or equivalent 0-10V dimmable version is not intended to dim below about 5% @ 0V or 10% @ 1.0V 0-10V dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted. Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LED75W Series SSL Solutions Faster Than The Speed Of Light® Pg 4 of 4 “-PD” Option: PWM Dimming Parameters Absolute Maximum Voltage Range on PWM Input (Purple Wire) Input LOW Level Voltage Range (Purple Wire) Input HIGH Level Voltage Range (Purple Wire) Sink Current into PWM Input (Purple Wire) PWM Input Signal Frequency PWM Input Signal Positive Duty Cycle Minimum Typical Maximum -2.0V -2.0 +9.0 0mA 200Hz 0% 10V 0V 10V — — 10-90% +28V +7.5V 28V 1.2mA 1000Hz 100% PWM Positive Dimming Typical Circuit PWM (+) Purple LED75W-XX-CXXXX-PD PWM In PWM (-) Gray Output Current / Positive Duty Cycle Output Current % 100 90 80 70 60 50 40 30 20 10 0 0% 10% 20% 30% 40% 50% 60% Positive Duty Cycle 70% 80% 90% 100% Notes: 1. PWM Dimmable version comes with an extra 2 wires +Purple/-Gray on the output side. 2. Below 10% Duty cycle proper dimming operation is not assured. Unit is not intended to turn off at <10% Duty Cycle. 3. PWM dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted. Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com