A P V- 1 2 E 12W Single Output Switching Power Supply F ■ Features Constant voltage design Protections: Short circuit / Over load / Over voltage Fully isolated plastic case Cooling by free air convection Small and compact size Class Ⅱ power unit, no FG No load power consumption <0.5W Pass LPS IP42 design Suitable for LED lighting and moving sign applications 100% full load burn-in test Low cost, high reliability 2 years warranty 110 SELV series LPS IP42 ■ Applications Indoor LED lighting LED decorative lighting LED office lighting LED signage ■ Description APV-12E series is one 12W AC/DC constant voltage mode single output LED power supply. It accepts input 180~264VAC and provides four models with different output voltage, 5V, 12V, 15V,24V, respectively, that the small wattage LED applications employ the most frequently. Exploiting Class II design (without FG pin) and adopting the 94V-0 flame retardant plastic enclosure, APV-12E ideally fits the entry-level LED applications. ■ Model Encoding APV - 12E - 15 Output voltage Output wattage Series name File Name:APV-12E-SPEC 2015-12-22 A P V- 1 2 E 12W Single Output Switching Power Supply series SPECIFICATION MODEL OUTPUT APV-12E-5 APV-12E-12 APV-12E-15 APV-12E-24 DC VOLTAGE RATED CURRENT 5V 2A 12V 1A 15V 0.8A 24V 0.5A CURRENT RANGE RATED POWER 0 ~ 2A 10W 0 ~ 1A 12W 0 ~ 0.8A 12W 0 ~ 0.5A 12W 100mVp-p 120mVp-p 120mVp-p 150mVp-p 81% 83% RIPPLE & NOISE (max.) Note.2 VOLTAGE TOLERANCE Note.3 ±5.0% LINE REGULATION ±1.0% LOAD REGULATION ±2.0% SETUP, RISE TIME Note.6 500ms, 30ms / 230VAC at full load HOLD UP TIME (Typ.) VOLTAGE RANGE 20ms/230VAC at full load Note.4 FREQUENCY RANGE POWER FACTOR (Typ.) INPUT 180 ~ 264VAC 47 ~ 63Hz 254 ~ 370VDC EFFICIENCY (Typ.) PF>0.5/230VAC at full load 75% 81% AC CURRENT 0.2A/230VAC INRUSH CURRENT(Typ.) COLD START 70A(twidth=120μs measured at 50% Ipeak) at 230VAC MAX. No. of PSUs on 16A 17 units (circuit breaker of type B) / 29 units (circuit breaker of type C) at 230VAC CIRCUIT BREAKER LEAKAGE CURRENT 0.25mA / 240VAC OVER LOAD Above 105% rated output power PROTECTION OVER VOLTAGE Protection type : Hiccup mode, recovers automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16V 17.5 ~ 21V WORKING TEMP. Protection type : Shut off o/p voltage, clamping by zener diode -30 ~ +70℃(Refer to "Derating Curve") WORKING HUMIDITY 20 ~ 90% RH non-condensing 27.6 ~ 32.4V ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +80℃, 10 ~ 95% RH TEMP. COEFFICIENT ±0.03%/℃ (0 ~ 50℃) VIBRATION SAFETY STANDARDS 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes IP42 approved; design refer to EN61347-1,EN61347-2-13 WITHSTAND VOLTAGE I/P-O/P:3.75KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH EMC Compliance to EN55015,EN61000-3-2 Class A,EN61000-3-3 EMC EMISSION Compliance to EN61547,EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), criteria A EMC IMMUNITY MTBF OTHERS DIMENSION PACKING NOTE 1145.7K hrs min. MIL-HDBK-217F (25℃) 77*40*29(L*W*H) 0.08Kg; 120pcs/11.8Kg/1.06CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. File Name:APV-12E-SPEC 2015-12-22 A P V- 1 2 E 12W Single Output Switching Power Supply Mechanical Specification series Unit:mm 90 82.5 77 150±10 15.5 2 IEC52 H03VVH2-F 0.75mm AC/N(Blue) AC/L(Brown) 40 19 +V(Red) -V(Black) 31 UL1569 20AWG T case 150±10 29 ※ T case: Max. Case Temperature Block Diagram I/P fosc : 67KHz EMI FILTER POWER SWITCHING RECTIFIERS RECTIFIERS & FILTER +V -V DETECTION CIRCUIT PWM CONTROL Derating Curve Static Characteristics other 100 100 90 80 80 5V 70 50 LOAD (%) LOAD (%) 60 40 20 -30 0 10 20 30 40 45 50 AMBIENT TEMPERATURE (℃) 60 70 (HORIZONTAL) 60 50 40 180 190 200 210 220 230 240 250 264 INPUT VOLTAGE (VAC) 60Hz File Name:APV-12E-SPEC 2015-12-22