Green Power Solutions Srl Web: www.gpsemi.it e-mail: [email protected] Phone: +39-011-988 2251 Fax: +39-011-988 1358 http://gpsemi.it/pdf/GPTR5230.pdf GPTR5230 PHASE CONTROLLED SCR High reliability operation DC power supply Controlled rectifiers DC drives - Motor starters BLOCKING VOLTAGE UP TO 4400 V AVERAGE CURRENT 2300 A SURGE CURRENT BLOCKING CHARACTERISTICS Characteristic Conditions 37 kA Value VRRM Repetitive peak reverse voltage 4400 V VRSM Non-repetitive peak reverse voltage 4500 V VDRM Repetitive peak off-state voltage IDRM IRRM Repetitive peak off-state current, max. Repetitive peak reverse current, max. 4400 V VDRM, single phase, half wave, Tj = Tjmax VRRM, single phase, half wave, Tj = Tjmax 300 mA 300 mA ON-STATE CHARACTERISTICS IT(AV) Average on-state current Sine wave,180° conduction, Th = 55 °C 2300 A IT(RMS) R.M.S. on-state current Sine wave,180° conduction, Th = 55 °C 3613 A ITSM Surge on-state current Non rep. half sine wave, 50 Hz, VR = 0 V, Tj = Tjmax I²t I² t for fusing coordination VT(TO) Threshold voltage Tj = Tjmax 1.20 V rT On-state slope resistance Tj = Tjmax 0.300 mW VTM Peak on-state voltage, max On-state current IT = 3000 A , Tj = Tjmax 2.10 V IH IL Holding current, max Latching current, typ Tj = 25 °C Tj = 25 °C 300 mA 1500 mA 37 kA 6845 kA²s TRIGGERING CHARACTERISTICS VGT Gate trigger voltage Tj = 25 °C, VD = 12 V 3 V IGT Gate trigger current Tj = 25 °C, VD = 12 V 300 mA VGD Non-trigger voltage VD = 67% VRRM, Tj = Tjmax 0.35 V PGM Peak gate power dissipation Pulse width 0.5 ms 150 W PG(AV) Average gate power dissipation IFGM Peak gate current 10 A VFGM VRGM Peak gate voltage (forward) Peak gate voltage (reverse) 30 V 5 V 5 W SWITCHING CHARACTERISTICS di/dt Critical rate of rise of on-state current Tj = Tjmax 200 A/µs dV/dt Critical rate of rise of off-state voltage Tj = Tjmax 1000 V/µs tq Turn-off time, typ Tj = Tjmax, IT = 2300 A, di/dt = -10 A/µs 630 µs VR = 100 V, VD = 67% VDRM, dV/dt = 50 V/µs THERMAL AND MECHANICAL CHARACTERISTICS Rth(j-c) Thermal resistance (junction to case) Double side cooled 0.009 °C/W Rth(c-h) Thermal resistance (case to heatsink) Double side cooled 0.002 °C/W Tjmax Max operating junction temperature Tstg Storage temperature F Clamping force ± 10% Mass Document GPTR5230T002 125 °C -40 / 125 °C 45 kN 1500 g GPTR5230 PHASE CONTROLLED SCR Current rating - sine wave Power loss - sine wave 7000 180° 120 6000 110 90° 90 80 120° 60° 5000 100 PF [W] Heatsink temperature [°C] 130 30° 4000 3000 2000 70 60 1000 30° 60° 90° 50 0 400 800 1200 1600 120° 180° 2000 0 0 2400 400 800 1200 1600 2000 2400 IT[A] IT [A] Maximum surge current d.s. cooled On-state voltage drop 4000 40 35 25 [A] ITIT[A] ITSM [A] 30 20 15 10 5 0 1 10 100 5000 3000 4500 4000 3500 2000 3000 2500 2000 1500 1000 1000 500 0 0 0 1 Tjmax Tj=T j=Tjmax 1.2 1.4 Number of cycle current pulses [n] 1 1.6 2 1.8 2 VTT [V] 2.2 2.4 ZTH(j-c) [°C / W] Thermal impedance (j-c) 0.009 0.008 0.007 0.006 0.005 0.004 0.003 0.002 0.001 0 0.001 0.01 0.1 1 10 100 Time [s] Ordering information GPTR5230-VVGL VV: blocking voltage / 100 (e.g. 44 for 4400 V) G: trigger lead type (S = straight T = twisted blank = no leads) L: trigger lead lenght x 100mm (3 - 4 - 5 - 7 blank = no leads) dimensions mm In the interest of product improvement Green Power Solutions reserves the right to change any specification given in this data sheet without notice. Document GPTR5230T002 3 2.6