PC PSU FSP250-50GSV-5K,(85) DESCRIPTION This is the specification of Model FSP250-50GSV-5K(85); AC -line powered switching power supply with active PFC (Power Factor C orrection) circuit, meet EN61000-3-2 and with Full Range Input features. Also, +5Vsb power is less than 0.5Winput at power off mode (PS_ON input at high state) which is comply with ErP Lot 6 year 2013 requirement. SAFETY STANDARD APPAOVAL APPLICATION Desktop, DVR W ATTAGE Wattage: 250W GENERAL SPECIFICATION 100mm(L) x 125mm(W) x 63.5mm(H) Efficiency: 80PLUS Bronze PWOK Delay Time: 500ms > PWOK > 100ms EMC Performance: EN55022 class B EN55024 EN 61000-3-2 EN 61000-3-3 DIMENSION Dimension: PRODUCT HIGHLIGHT Efficiency Level: Erp Lot: Input Voltage: 80PLUS Bronze <0.5W 100~240Vac ENVIRONMENTAL SPECIFICATION TEMP.Range: INPUT SPECIFICATION Input Range: Input Frequency: Input Current: 100-240 Vac 47-63 Hz 115V@ 3.0 Amps-rms maximum 230V@ 1.5 Ampsrms maximum MTBF: OUTPUT SPECIFICATION Output Rise Time: Operating Temperature:10°C to +50°C Storage Temperature: -20°C to + 70℃ The power supply have a minimum predicted MTBF(MIL-HDBK-217) of 100,000 hours of continuous operation at 25℃, maximum-output load, and nominal AC inout voltage. +3.3V 20mS (maximum) +5V 20mS (maximum) +12V 20mS (maximum) -12V 20mS (maximum) *Output Voltage and C urrent Rating +3.3V Ripple-Noise(R-P) mV 50mV Regulation Load % ±5% Output Max.(A) 16A Output Min.(A) 0.3A +5V 50mV ±5% 16A 1A +12V1 120mV ±5% 17A 1A NOTES (1)+3.3V & +5V total output must not exceed 97W. ( 2 )Total output continuous shall not exceed 250W watts. This content is subject to change, please refer to specification for m ore detail. FSP reserve the right to change the content without prior notice -12V 120mV ±10% 0.3A 0A +5Vsb 50mV ±5% 2A 0A