Double Balanced Mixer Model MM4xxG-10 Multi-Octave Band RF 2.0 to 8.0 GHz Electrical Specifications: (1) Specifications Conditions Parameter SSB Conversion loss: (2) (3) RF (GHz) 2.0-8.0 2.0-8.0 2.0-8.0 Isolation LO to RF: LO to IF: RF to IF: Input 1 dB Compression Point: 2.0-8.0 2.0-8.0 Input Third Order Intercept Point: LO Power: (4) LO (GHz) 2.0-8.0 2.0-8.0 2.0-8.0 IF (MHz) DC-500 DC-1200 DC-1500 2.0-8.0 2.0-3.0 3.0-8.0 2.0-8.0 DC-1500 2.0-8.0 2.0-8.0 DC-1500 2.0-8.0 2.0-8.0 DC-1500 Min Typical 5.4 dB 6.4 dB 6.7 dB 25 dB 18 dB 25 dB 33 dB 24 dB 34 dB 22 dB +1 dBm +4 dBm +8 dBm +12 dBm +11 dBm +14 dBm +18 dBm +22 dBm +7 dBm +10 dBm +14 dBm +19 dBm Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system from -55˚C to +100˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss for IF frequencies greater than 10 MHz. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. MM4xxG-10 Outline: G Max 7.5 dB 8.5 dB 9.0 dB MM43 MM44 MM46 MM47 MM43 MM44 MM46 MM47 MM43 MM44 MM46 MM47 Model MM4xxG-10 LO Power 3 = +7 dBm 4 = +10 dBm 6 = +14 dBm 7 = +19 dBm Drop-In Module or With SMA(F) Connectors M = Module P = With Connectors Typical Performance at 25˚C “MG” WITHOUT CONNECTORS “PG” WITH REMOVABLE CONNECTORS All dimensions are in inches and [mm]. Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 Rev. 2/8/07 www.SpectrumMicrowave.com Spectrum Microwave (Europe) · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001