Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 1A FAST RECOVERY GLASS PASSIVATED RECTIFIER FR10-005G THRU FR10-10G FEATURES z FAST RECOVERY TIMES z UL 94V0 FLAME RETARDANT EPOXY MOLDING COMPOUND z GLASS PASSIVATED CHIP JUNCTION z LOW COST z HIGH SURGE CURRENT CAPABILITY 1.0(25.4) MIN .034(0.9) .028(0.7) .205(5.2) .166(4.2) .107(2.7) .080(2.0) MECHANICAL DATA z CASE: TRANSFER MOLDED, DO41, DIMENSIONS IN INCHES AND (MILLIMETERS) z LEADS: SOLDERABLE PER MIL-STD-202, METHOD 208 z POLARITY: CATHODE INDICATED BY COLOR BAND z WEIGHT: 0.34 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% FR10 FR10 FR10 FR10 FR10 FR10 FR10 UNITS RATINGS SYMBOL -005G -01G -02G -04G -06G -08G -10G MAXIMUM RECURRENT PEAK REVERSE VOLTAGE MAXIMUM RMS VOLTAGE MAXIMUM DC BLOCKING VOLTAGE MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) VRRM VRMS VDC 50 35 50 100 70 100 200 140 200 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V IO 1.0 A IFSM 30 A CJ 15 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθjc 50 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) FR10 FR10 CHARACTERISTICS SYMBOL -005G -01G MAXIMUM FORWARD VOLTAGE AT IO DC VF FR10 -02G FR10 -04G 1.3 MAXIMUM REVERSE CURRENT AT 25℃ IR 5 MAXIMUM REVERSE CURRENT AT 100℃ IR 50 FR10 -06G MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR 150 NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS FR10 -08G UNITS V μA μA 250 500 2. BOTH LEADS ATTACHED TO HEAT SINK 20×20×1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A FR10-005G THRU FR10-10G FR10 -10G Page: 1 nS RATINGS AND CHARACTERISTIC CURVE FR10-005G THRU FR10-10G FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50Ω NO INDUCTIVE 10Ω NO INDUCTIVE Trr +0.5A (-) D.U.T. PULSE GENERATOR ( NOTE 2 ) (+) 25 Vdc (approx) 1Ω NON INDUCTIVE (-) 0 -0.25A OSCILLOSCOPE ( NOTE 1 ) (+) -1.0A NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS 1cm SET TIME BASE FOR 10/20 ns/cm RESISTIVE OR INDUCTIVE LOAD 0.375”(9.5mm) LEAD LENGTH 1.0 0.8 I(pk) 0.6 I(AV) π Fig. 5-MAXIMUM FORWARD SURGE CURRENT = I(pk) 0.2 I(AV) 0 0 PEAK FORWARD SURGE CURRENT AMPERES CAPACITIVE LOAD 0.4 5 = 10 20 20 40 60 80 100 120 140 160 180 200 TA-AMBIENT TEMPERATURE (°C) FIG. 3-TYPICAL JUNCTION CAPACITANCE 20 CAPACITANCE, pF Tj=25oC 10 1 1 10 100 REVERSE VOLTAGE, VOLTS INSTANTANEOUS REVERSE CURRENT, MICRO AMPERES(uA) 30 TA=75oC 8.3ms SINGLE HALF SINE-WAVE JEDEC METHOD 20 10 1.0 CYCLE 0 1 10 NUMBER OF CYCLES AT 60 HZ 100 f = 1 MHz Vsig = 50 mVp-p FIG. 4-TYPICAL REVERSE CHARACTERISTICS 100 10 TJ=100oC 1 0.1 o TJ=25 C INSTANTANEOUS FORWARD CURRENT, IF(A) Io-AVERAGE RECTIFIED CURRENT (A) Fig. 2-MAXIMUM FORWARD CURRENT DERATING CURVE FIG. 6-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 20 10 3 1 Tj=25oC PULSE WIDTH =300us 1% DUTY CYCLE .3 .1 .03 .01 0.4 .01 0 20 40 60 80 100 120 140 0.6 0.8 1.0 1.2 1.4 PERCENT OF RATED PEAK REVERSE VOLTAGE FR10-005G THRU FR10-10G 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE, (V) Page: 2