Green Power Solutions Srl Web: www.gpsemi.it e-mail: [email protected] Phone: +39-011-988 2251 Fax: +39-011-988 1358 http://gpsemi.it/pdf/GPTR6243.pdf GPTR6243 PHASE CONTROLLED SCR High reliability operation DC power supply Controlled rectifiers DC drives - Motor starters BLOCKING VOLTAGE UP TO 5200 V AVERAGE CURRENT 2435 A SURGE CURRENT BLOCKING CHARACTERISTICS Characteristic Conditions 37 kA Value VRRM Repetitive peak reverse voltage 5200 V VRSM Non-repetitive peak reverse voltage 5200 V VDRM Repetitive peak off-state voltage IDRM IRRM Repetitive peak off-state current, max. Repetitive peak reverse current, max. 5300 V VDRM, single phase, half wave, Tj = Tjmax VRRM, single phase, half wave, Tj = Tjmax 200 mA 200 mA ON-STATE CHARACTERISTICS IT(AV) Average on-state current Sine wave,180° conduction, Th = 55 °C 2435 A IT(RMS) R.M.S. on-state current Sine wave,180° conduction, Th = 55 °C 3823 A ITSM Surge on-state current Non rep. half sine wave, 50 Hz, VR = 0 V, Tj = Tjmax I²t I² t for fusing coordination VT(TO) Threshold voltage Tj = Tjmax 1.1 V rT On-state slope resistance Tj = Tjmax 0.241 mW VTM Peak on-state voltage, max On-state current IT = 3000 A , Tj = Tjmax 1.82 V IH IL Holding current, max Latching current, typ Tj = 25 °C Tj = 25 °C 300 mA 3000 mA 37 kA 6845 kA²s TRIGGERING CHARACTERISTICS VGT Gate trigger voltage Tj = 25 °C, VD = 5 V 1.5 V IGT Gate trigger current Tj = 25 °C, VD = 5 V 350 mA VGD Non-trigger voltage VD = 67% VRRM, Tj = Tjmax 0.4 V PGM Peak gate power dissipation Pulse width 0.5 ms 150 W PG(AV) Average gate power dissipation 20 W IFGM Peak gate current 10 A VFGM VRGM Peak gate voltage (forward) Peak gate voltage (reverse) 10 V 12 V SWITCHING CHARACTERISTICS di/dt Critical rate of rise of on-state current Repetitive, Tj = Tjmax dV/dt Critical rate of rise of off-state voltage Linear up to to 67% VDRM, Tj = Tjmax tq Turn-off time, typ Tj = Tjmax, IT = 2300 A, di/dt = -2 A/µs 150 A/µs 1500 V/µs µs VR = 200 V, VD = 67% VDRM, dV/dt = 20 V/µs THERMAL AND MECHANICAL CHARACTERISTICS Rth(j-c) Thermal resistance (junction to case) Double side cooled 0.009 °C/W Rth(c-h) Thermal resistance (case to heatsink) Double side cooled 0.002 °C/W Tjmax Max operating junction temperature Tstg Storage temperature F Clamping force Mass Document GPTR6243T002 125 °C -40 / 125 °C 48 / 54 kN 1500 g GPTR6243 PHASE CONTROLLED SCR Current rating - sine wave Power loss - sine wave 7000 120 180° 6000 110 90° 30° 90 80 4000 3000 2000 70 60 1000 30° 60° 90° 120° 180° 0 50 0 400 800 1200 1600 2000 0 2400 400 800 1200 1600 2000 2400 IT[A] IT [A] Maximum surge current d.s. cooled On-state voltage drop 2800 40 35 30 25 [A] ITIT[A] ITSM [A] 120° 60° 5000 100 PF [W] Heatsink temperature [°C] 130 20 15 10 5 0 1 10 100 2400 6000 2000 5000 1600 4000 Tj=Tjmax 1200 3000 2000 800 1000 400 0 0 0 0.8 Tj=Tjmax 0.5 1 1 1.2 Number of cycle current pulses [n] 1.5 1.4 1.6 VTT [V] 2 1.8 ZTH(j-c) [°C / W] Thermal impedance (j-c) 0.01 0.009 0.008 0.007 0.006 0.005 0.004 0.003 0.002 0.001 0 0.001 0.01 0.1 1 10 Time [s] Ordering information GPTR6243-VVGL VV: blocking voltage / 100 (e.g. 52 for 5200 V) G: trigger lead type (S = straight T = twisted blank = no leads) L: trigger lead lenght x 100mm (3 - 4 - 5 - 7 blank = no leads) dimensions mm In the interest of product improvement Green Power Solutions reserves the right to change any specification given in this data sheet without notice. Document GPTR6243T002 2.5 2