CCLD-024 5×7mm SMD LVDS Clock Oscillator CCLD-024 Model 5×7 mm SMD, 2.5V, LVDS Model CCLD-024 is a 162.000 MHz to 250.000 MHz LVDS Clock Oscillator operating at 2.5 Volts. The oscillator utilizes a High Q crystal design providing very low Jitter and Phase Noise. No Sub-Harmonics are present in the Output Signal. Applications: 5×7mm SMD Digital Video SONET/SDH/DWDM Storage Area Networks Broadband Access Ethernet, Gigabit Ethernet Rev: K Date: 16-Oct-2015 Page 1 of 3 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com CCLD-024 5×7mm SMD LVDS Clock Oscillator CCLD-024 Model 5×7 mm SMD, 2.5V, LVDS Frequency Range: Frequency Stability Options(ppm): Temperature Range: (Option M) (Option X) Storage: Input Voltage: Input Current: Output: Symmetry: Rise/Fall Time: Load: Logic: Output Voltage Levels Differential Output Voltage: Disable Time: Enable Time: Phase Jitter: 12kHz~80MHz Phase Noise: (See Plot Below) Sub-harmonics: Aging: 162.000 MHz to 250.000 MHz ±20, ±25, ±50, ±100 (standard) 0°C to +70°C -20°C to +70°C -40°C to +85°C -45°C to 90°C 2.5V ±0.125V 43mA Typical, 63mA Max Differential LVDS 45/55% Max @ zero crossing point 1nSec Max (20% to 80%) 100 Ohms Connected between OUT and COUT “0”=0.90 Min, 1.10 Typical “1”=1.43 Typical, 1.60 Max 247mV Min, 454mV Max 200nSec Max 2mSec Max 0.5pSec Typical, 1pSec RMS Max None <3ppm 1st year, <1ppm every year thereafter Typical Phase Noise Plot CCLD-024-50-250.000 Rev: K Date: 16-Oct-2015 Page 2 of 3 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com CCLD-024 5×7mm SMD LVDS Clock Oscillator CCLD-024 Model 5×7 mm SMD, 2.5V, LVDS Crystek Part Number Guide CCLD - 024 X - 50 - 250.000 #1 #2 #3 #4 #5 Stability Indicator #1 Crystek LVDS Osc. #2 Model 024 #3 Temp Range: Blank = 0/70°C, M = -20/70°C, X = -40/85°C #4 Stability: (see Table 1) #5 Frequency in MHz: 3 or 6 decimal places Blank 50 25 20* Example: CCLD-024X-50-250.000 2.5V, -40/85°C, ±50ppm, 250.000 MHz ± 100ppm ± 50ppm ± 25ppm ± 20ppm *not available in -40/85 Table 1 RECOMMENDED REFLOW SOLDERING PROFILE Ramp-Up 3°C/Sec Max. Shock: Solderability: Vibration: Solvent Resistance: Resistance to Soldering Heat: Environmental: Thermal Shock: Moisture Resistance: TEMPERATURE Mechanical: MIL-STD-883, Method 2002, Condition B MIL-STD-883, Method 2003 MIL-STD-883, Method 2007, Condition A MIL-STD-202, Method 215 MIL-STD-202, Method 210, Condition I or J Critical Temperature Zone Ramp-Down 6°C/Sec. 260°C 217°C 200°C 150°C Preheat 180 Secs. Max. 8 Minutes Max. MIL-STD-883, Method 1011, Condition A MIL-STD-883, Method 1004 90 Secs. Max. 260°C for 10 Secs. Max. NOTE: Reflow Profile with 240°C peak also acceptable. 0.274 ±0.007 (6.96 ±0.18) Dimensions inches (mm) All dimensions are Max unless otherwise specified. Part Number Frequency DC Lot Code 0.193 ±0.007 (4.90 ±0.18) Tristate Function Function pin 1 Output pin Open or N/C "1" level 0.7×Vdd Min "0" level 0.3×Vdd Max Active Active High Z 0.071 (1.80) Denotes pad 1 SUGGESTED PAD LAYOUT via to ground 0.01µF 0.055 Typ (1.40 Typ) 0.071 SQ (1.80) 0.045 ±0.008 (1.14 ±0.20) #1 #2 #3 #6 #5 #4 0.100 (2.54) 0.200 (5.08) CRYSTEK CORPORATION 0.148 (3.75) 0.200 (5.08) 0.01uF Bypass Capacitor Recommended PIN Connection 1 2 3 4 5 6 Enable/Disable N/C GND Output Comp Output Vcc Rev: K Date: 16-Oct-2015 Page 3 of 3 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com