H HiTRON 04/22/2002 UNIVERSAL OR U.S. INPUT RANGE AC TO DC EXTERNAL WALLMOUNT ADAPTERS SINGLE OUTPUT 12 WATTS SWITCHING POWER SUPPLIES HES12 OR HES12B SERIES FEATURES: LOW COST WALLMOUNT ADAPTER DIVERSE AC PLUGS AVAILABLE MEET DIVERSE SAFETY STANDARDS EMI MEET EN 55022 OR FCC CLASS B CE MARKING COMPLIANCE SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Voltage: HES12 typ. 90-264Vac, rating 100-240Vac. HES12B typ. 90-132Vac, rating 120Vac. Input Connector: HES12: WM1 (U.S.2-blade)/WM3 (Euro-stecker)/ DT8(IEC320-2P). HES12B: WM1 (U.S.2-blade). Input Frequency: 47-63Hz. Inrush Current: HES12: Typ. 28A @ 230Vac by adding thermister. HES12B: Typ. 22.5A @ 115Vac. Input Current: HES12 Typ. 0.15A @ 230Vac. HES12B Typ. 0.24A @ 115Vac. Dielectric Withstand: Meet IEC950. EMI: Meet EN 55022 or FCC Class B. Hold-up Time: Typ. 13.2mS@115Vac/42.0mS@230Vac. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 12 Watts. Output Connector: Optional. Line Regulation: Typ. 0.1%. Load Regulation: Typ. ±2-3%. Noise & Ripple: Typ. 1.0% peak to peak. OVP: Built-in. By Zener diode clamping. Adjustability: Factory set. Overload Protection (OLP): Fully protected against output overload or short circuit. Typ. 120-150% max. load. Consult the factory for special OLP setting GENERAL SPECIFICATION Efficiency: Typ. 80.5%. Switching Frequency: Typ. 56-76K Hz.@ full load. Circuit Topology: Free-running flyback circuit. Transient Response: Output voltage returns typ. 1mS following a 25% load change. Safety Standard: UL1950/EN60950.Class II. Power Density: 2.3 Watts. / Cubic Inch. Operating Temperature: 0 to +40°C. Storage Temperature: -20 to +85°C. Temperature Coefficient: Typ. 0.04% /°C. Cooling: Free air convection. Construction: Impact resistant thermo-plastic enclosure case. Wallmount or Desktop format. Notes: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified. (2) Load regulation is measured at 230Vac or 120Vac in percentage to indicate the change in output voltage as the load is varied from half load to full load (±%). (3) The exact obtainable load regulation depends upon the output cord selected and load current. Upper data are for 6 ft. (2 m) cord AWG#18 wires. MODEL NO. DESCRIPTION: HES12 or B - XXX YYY – S 04/22/2002 INPUT AC PLUG: HES12: [1]WM1, [3]WM3, [8]DT8 HES12B: WM1 OUTPUT CURRENT OUTPUT VOLTAGE SERIES NAME (Hitron External Switcher): About 12W. OUTPUT VOLTAGE/CURRENT RATINGS CHART SINGLE OUTPUT MODEL NO. HES12-033240-1,3,8 HES12B-033240 HES12-050240-1,3,8 HES12B-050240 HES12-060200-1,3,8 HES12B-060200 HES12-065180-1,3,8 HES12B-065180 HES12-075160-1,3,8 HES12B-075160 HES12-090130-1,3,8 HES12B-090130 HES12-120100-1,3,8 HES12B-120100 HES12-150080-1,3,8 HES12B-150080 HES12-240050-1,3,8 HES12B-240050 HES12-480025-1,3,8 HES12B-480025 AC INPUT AC PLUG O/P VOLTAGE O/P CURRENT FORMAT 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac 90-264Vac 120Vac WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 WM1/WM3/DT8 WM1 3.3V 3.3V 5.0V 5.0V 6.0V 6.0V 6.5V 6.5V 7.5V 7.5V 9.0V 9.0V 12.0V 12.0V 15.0V 15.0V 24.0V 24.0V 48.0V 48.0V 2.40A 2.40A 2.40A 2.40A 2.00A 2.00A 1.80A 1.80A 1.60A 1.60A 1.30A 1.30A 1.00A 1.00A 0.80A 0.80A 0.50A 0.50A 0.25A 0.25A Wallmount/Desktop Wallmount Wallmount/Desktop Wallmount Wallmount/Desktop Wallmount Wallmount/Desktop Wallmount Wallmount/Desktop Wallmount Wallmount/Desktop Wallmount Wallmount/Desktop t Wallmount Wallmount/Desktop Wallmount Wallmount/Desktop Wallmount Wallmount/Desktop Wallmount MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 113g (4.0 Oz.)